87,399 research outputs found
Dr. Glendon Swarthout
No full textHosted by Roger M. Busfield, MSU Assistant Professor of Speech and Theater, Meet the Author is designed to introduce a general audience to a contemporary author and their work through in-depth interviews. This episode features a conversation between Dr. Glendon Swarthout, prolific author and English professor at MSU, and assistant professors Sam S. Baskett and Theodore B. Strandness
Simulation of thermal plant optimization and hydraulic aspects of thermal distribution loops for large campuses
Full text linkFollowing an introduction, the author describes Texas A&M University and its utilities system. After that, the author presents how to construct simulation models for chilled water and heating hot water distribution systems. The simulation model was used in a $2.3 million Ross Street chilled water pipe replacement project at Texas A&M University. A second project conducted at the University of Texas at San Antonio was used as an example to demonstrate how to identify and design an optimal distribution system by using a simulation model. The author found that the minor losses of these closed loop thermal distribution systems are significantly higher than potable water distribution systems. In the second part of the report, the author presents the latest development of software called the Plant Optimization Program, which can simulate cogeneration plant operation, estimate its operation cost and provide optimized operation suggestions. The author also developed detailed simulation models for a gas turbine and heat recovery steam generator and identified significant potential savings. Finally, the author also used a steam turbine as an example to present a multi-regression method on constructing simulation models by using basic statistics and optimization algorithms. This report presents a survey of the author??s working experience at the Energy Systems Laboratory (ESL) at Texas A&M University during the period of January 2002 through March 2004. The purpose of the above work was to allow the author to become familiar with the practice of engineering. The result is that the author knows how to complete a project from start to finish and understands how both technical and nontechnical aspects of a project need to be considered in order to ensure a quality deliverable and bring a project to successful completion. This report concludes that the objectives of the internship were successfully accomplished and that the requirements for the degree of Degree of Engineering have been satisfied
C3H7NO2S effect on concrete steel-rebar corrosion in 0.5 M H2SO4 simulating industrial/microbial environment
No full textThis paper investigates C3H7NO2S (Cysteine) effect on the inhibition of reinforcing steel corrosion in concrete immersed in 0.5 M H2SO4, for simulating industrial/microbial environment. Different C3H7NO2S concentrations were admixed, in duplicates, in steel-reinforced concrete samples that were partially immersed in the acidic sulphate environment. Electrochemical monitoring techniques of open circuit potential, as per ASTM C876-91 R99, and corrosion rate, by linear polarization resistance, were then employed for studying anticorrosion effect in steel-reinforced concrete samples by the organic hydrocarbon admixture. Analyses of electrochemical test-data followed ASTM G16-95 R04 prescriptions including probability distribution modeling with significant testing by Kolmogorov-Smirnov and student's t-tests statistics. Results established that all datasets of corrosion potential distributed like the Normal, the Gumbel and the Weibull distributions but that only the Weibull model described all the corrosion rate datasets in the study, as per the Kolmogorov-Smirnov test-statistics. Results of the student's t-test showed that differences of corrosion test-data between duplicated samples with the same C3H7NO2S concentrations were not statistically significant. These results indicated that 0.06878 M C3H7NO2S exhibited optimal inhibition efficiency η = 90.52±1.29% on reinforcing steel corrosion in the concrete samples immersed in 0.5 M H2SO4, simulating industrial/microbial service-environment
Author Correction: A global analysis of terrestrial plant litter dynamics in non-perennial waterways
No full text© 2018 The Author(s) In the version of this Article originally published, the affiliation for M. I. Arce was incorrect; it should have been:5Leibniz Institute of Freshwater Ecology and Inland Fisheries (IGB), Berlin, Germany. This has now been corrected in the online versions of the Article
Studies on Thermal Reactions and Sintering Behaviour of Red Clays by Irreversible Dilatometry
No full textThermal behavior of clays strongly influences that of ceramic bodies made thereof and hence, its study is must for assessing its utility in ceramic products as well as to set the body composition. Irreversible dilatometry is an effective thermal analysis tool for evaluating thermal reactions as well as sintering behavior of clays or clay based ceramic bodies. In this study, irreversible dilatometry of four red clay samples (S, M, R and G) of Gujarat region, which vary in their chemical and mineralogical compositions was carried out using a Dilatometer and compared. Chemical analysis and XRD of red clays were carried out. XRD showed that major clay minerals in S, M and R clays are kaolinite. However, clay marked R and G showed presence of both kaolinite and illite and / muscovite. Presence of non-clay minerals such as hematite, quartz, anatase were also observed in all clays. XRD results were in agreement with chemical analyses results. Rational analyses showed variation in amount of clay and non-clay minerals in red clay samples. Evaluation of dilatometric curves showed that clay marked as S, M and R exhibit patterns typical for kaolinitic clays. Variation in linear expansion (up to 550 degrees C) and shrinkage (above 550 degrees C) between these three clays was found to be related to difference in amount of quartz and kaolinite respectively. However, dilatometric curve of G exhibit a pattern similar to that for an illitic clay. This study confirmed that sintering of investigated kaolinitic and illitic and / muscovitic red clays initiates at above 1060 degrees C and 860 degrees C respectively and this behaviour strongly depends upon type and amount of minerals and their chemical compositions
Measurement of the CP-violating phase \phi s in Bs->J/\psi\pi+\pi- decays
Full text linkMeasurement of the mixing-induced CP-violating phase phi_s in Bs decays is of prime importance in probing new physics. Here 7421 +/- 105 signal events from the dominantly CP-odd final state J/\psi pi+ pi- are selected in 1/fb of pp collision data collected at sqrt{s} = 7 TeV with the LHCb detector. A time-dependent fit to the data yields a value of phi_s=-0.019^{+0.173+0.004}_{-0.174-0.003} rad, consistent with the Standard Model expectation. No evidence of direct CP violation is found
Author Correction: El Niño–Southern Oscillation complexity (Nature, (2018), 559, 7715, (535-545), 10.1038/s41586-018-0252-6)
No full textIn this Review, the middle initial of author Kim M. Cobb was omitted. The original Review Article has been corrected online. © 2019, The Author(s), under exclusive licence to Springer Nature Limited.11Nsciescopu
Acoustic radiation due to scattering of T-S wave by the mean-flow distortion induced by steady local suction
No full textSubstantial sound waves can be generated by boundary-layer instability modes when the latter are scattered by a rapid mean-flow distortion. This is a rather generic mechanism and operates when an oncoming T-S wave is scattered by a steady local suction slot. This paper focuses on this problem by extending a recently developed Local Scattering Theory (Wu & Dong, J. Fluid Mech. submitted), where a so-called transmission coefficient, defined as the ratio of the T-S wave amplitude downstream of the scatter to that upstream, is introduced to characterize the effect of a local scatter on boundary-layer instability and transition. As in the earlier work, the mathematical formulation is based on triple-deck formulism, but in order to accommodate the acoustic far field, which was not considered in the paper mentioned, the unsteady terms in the upper deck, which play a leading-order role in radiation, are retained, and the influence of the radiated sound on the near-wall perturbation is included. The upper deck equation for the pressure is the Helmholtz equation rather than the Laplace equation. This leads to a modified pressure-displacement relation, which is coupled with the linearized boundary-layer equations in the lower deck. Discretization of the whole system formulates a generalized eigenvalue problem, which is solved numerically. It is found that suction suppresses oncoming T-S waves, and this effect increases with the suction velocity and the slot width. The directivity is ndependent of the flow parameters only when the Mach number is low. The intensity of the radiated sound in general increases with the frequency, the suction velocity and the width of the suction slot. Interestingly, for O(1) suction velocities, the radiated sound is very weak, indicating that the gain of stabilizing effect does not cause aeroacoustic penalty
Evidence for the decay B0→J/ψω and measurement of the relative branching fractions of meson decays to J/ψη and J/ψη′
Full text linkFirst evidence of the B 0 → J / ψ ω decay is found and the B s 0 → J / ψ η and B s 0 → J / ψ η ′ decays are studied using a dataset corresponding to an integrated luminosity of 1.0 fb -1 collected by the LHCb experiment in proton-proton collisions at a centre-of-mass energy of sqrt(s) = 7 TeV. The branching fractions of these decays are measured relative to that of the B 0 → J / ψ ρ 0 decay:frac(B (B 0 → J / ψ ω), B (B 0 → J / ψ ρ 0)) = 0.89 ± 0.19 (stat) - 0.13 + 0.07 (syst),frac(B (B s 0 → J / ψ η), B (B 0 → J / ψ ρ 0)) = 14.0 ± 1.2 (stat) - 1.5 + 1.1 (syst) - 1.0 + 1.1 (frac(f d, f s)),frac(B (B s 0 → J / ψ η ′), B (B 0 → J / ψ ρ 0)) = 12.7 ± 1.1 (stat) - 1.3 + 0.5 (syst) - 0.9 + 1.0 (frac(f d, f s)), where the last uncertainty is due to the knowledge of f d / f s, the ratio of b-quark hadronization factors that accounts for the different production rate of B 0 and B s 0 mesons. The ratio of the branching fractions of B s 0 → J / ψ η ′ and B s 0 → J / ψ η decays is measured to befrac(B (B s 0 → J / ψ η ′), B (B s 0 → J / ψ η)) = 0.90 ± 0.09 (stat) - 0.02 + 0.06 (syst)
Anne-Marie Ericsson. The Interiors of M/S Kungsholm: Masterpieces in Swedish Art Deco
No full textArt Deco is a style that has hitherto gained too little attention in Swedish history of art and design. With her special focus on the 1920s and 1930s Anne-Marie Ericsson, a well known author and lecturer in the Swedish design world, is the just author for this period. Therefore I open her M/S Kungsholms inredning. Mästerverk i svensk art deco [The Interior of M/S Kungsholm. A masterpiece in Swedish art deco][i] with great expectations. As the title implies, the aim of the book is to treat the interiors of M/S Kungsholm, the show-piece of the Swedish American Line. This focus is reasonable, insofar as the exterior presented nothing new, according to the author, whereas the interior was enthusiastically received by the New York press as a “fairy tale castle” when she arrived on her maiden voyage in New York, December 1928. (p. 9). Trying to present a reconstruction of how the ship looked, although almost nothing remains of it today, Anne-Marie Ericsson has taken upon herself a task that is not an easy one. The fate of M/S Kungsholm was unfortunate. After a glorious decade, she transported troops during World War II, incredibly enough escaped bombs and torpedoes, became a cruise ship in the Mediterranean and was finally broken up in Bilbao in 1964. By that time, the interiors had been almost entirely extinguished and the furniture plundered or sold. [i] If not stated otherwise, all the translations from Swedish to English are my own, M.T
- …
