196,197 research outputs found
Study of the Powerful Nd:YLF Laser Amplifiers for the CTF3 Photoinjectors
No full textA high-power neodymium-doped yttrium lithium fluoride (Nd:YLF) mode-locked 1.5-GHz laser currently used to drive the two photoinjectors of the Compact Linear Collider Test Facility project at the European Organization for Nuclear Research is described. A phenomenological characterization of the two powerful Nd:YLF amplifiers is presented and compared with the measurements. The laser system operates in a saturated steady-state mode. This mode provides good shot-to-shot stability with pulse train mean power in the 10 kW range
Centrifuge modelling of long-term tunnelling ground movements
No full textThe increasing demand for public transport provision in cities has resulted in a requirement for enlarged
public transport infrastructure. Where underground railways represent an important component of these systems,
tunnel construction will inevitably lead to some degree of ground movement that can cause damage to surface
structures and buried structures and services. It is important, therefore, that in the design of tunnels in urban
environments these ground movements are predicted reliably. Predicting short-term ground movements resulting from
tunnelling is standard when assessing the potential for damage to adjacent infrastructure. However, long-term
tunnelling-induced ground movements and how these develop are understood less well and a research programme,
based on geotechnical centrifuge modelling, is being conducted to improve our fundamental scientific understanding
of this. The first stage of the programme has been to develop an apparatus that simulates the construction of a tunnel
with a lining of known stiffness and permeability and allows construction ground loss to be replicated correctly. This
paper describes the initial development of the apparatus along with results and analysis that demonstrates the suitability
of the technique for the proposed study. The results obtained were observed to represent the short-term settlements that
might be expected above a tunnel excavated in clay. The results also prove the modelling technique suitable for
application in a full parametric study in which the geometry and boundary conditions of the model will be varied
together with the permeability of the tunnel liner
Dr. Duane M. Jackson, Morehouse College, July 2011
No full textThis video is a conversation with Dr. Duane M. Jackson. Dr. Jackson talks about his paper, "Recall and the Serial Position Effect: The Role of Primacy and Recency on Accounting Students' Performance." Jackie Daniel, AUC Woodruff Library, is the interviewer
"Reflections on the subject of Emigration from Europe with a view to Settlement in the United States" By M. Carey.
No full text"Reflections on the subject of Emigration from Europe with a view to Settlement in the United States: containing bried sketches of the moral and political character of those states.
By M. Carey, member of the American philosophical, and of the American Antiquarian Society, and author of The Olive Branch, Cindiciae Hibernicae, essays on banking, on political economy, and on internal improvement.
To which are now added the English editor's comments on the subject; together with Important Advice to Emigrants, and Cautions Against Impositions Practiced in the Outports
Dispelling the Myths Behind First-author Citation Counts
No full textWe conducted a full-scale evaluative citation analysis study of scholars in the XML research field to explore just how different from each other author rankings resulting from different citation counting methods actually are, and to demonstrate the capability of emerging data and tools on the Web in supporting more realistic citation counting methods. Our results contest some common arguments for the continued
use of first-author citation counts in the evaluation of scholars, such as high correlations between author rankings by first-author citation counts and other citation
counting methods, and high costs of using more realistic citation counting methods that are not well-supported by the ISI databases. It is argued that increasingly available digital full text research papers make it possible for citation analysis studies to go beyond what the ISI databases have directly supported and to employ more
sophisticated methods
Dr. Glendon Swarthout
No full textHosted by Roger M. Busfield, MSU Assistant Professor of Speech and Theater, Meet the Author is designed to introduce a general audience to a contemporary author and their work through in-depth interviews. This episode features a conversation between Dr. Glendon Swarthout, prolific author and English professor at MSU, and assistant professors Sam S. Baskett and Theodore B. Strandness
Development of layered models for geotechnical centrifuge tests
No full textCentrifuge modelling is an established technique for investigating the ground response to complex and non-standard geotechnical events. These models are usually made from re-formed soil, allowing for comparisons with naturally occurring soil deposits. Clay models are formed by mixing clay powder and water into a slurry. This slurry is placed within a container and loaded to create a uniform stiff clay model. However, there is a fundamental disparity between this process and the deposition of natural soils, because natural soil is deposited in layers creating a unique structure. This structure is important for modelling true soil behaviour because some essential soil properties (such as permeability, stiffness and strength) are not identical in all directions. Currently, there are limited methods for creating layered soil samples. This paper describes the development of a new procedure for creating layered centrifuge models with structure – leading to potentially more representative models of naturally occurring ground
Simulation of thermal plant optimization and hydraulic aspects of thermal distribution loops for large campuses
No full textFollowing an introduction, the author describes Texas A&M University and its utilities system. After that, the author presents how to construct simulation models for chilled water and heating hot water distribution systems. The simulation model was used in a $2.3 million Ross Street chilled water pipe replacement project at Texas A&M University. A second project conducted at the University of Texas at San Antonio was used as an example to demonstrate how to identify and design an optimal distribution system by using a simulation model. The author found that the minor losses of these closed loop thermal distribution systems are significantly higher than potable water distribution systems. In the second part of the report, the author presents the latest development of software called the Plant Optimization Program, which can simulate cogeneration plant operation, estimate its operation cost and provide optimized operation suggestions. The author also developed detailed simulation models for a gas turbine and heat recovery steam generator and identified significant potential savings. Finally, the author also used a steam turbine as an example to present a multi-regression method on constructing simulation models by using basic statistics and optimization algorithms. This report presents a survey of the author??s working experience at the Energy Systems Laboratory (ESL) at Texas A&M University during the period of January 2002 through March 2004. The purpose of the above work was to allow the author to become familiar with the practice of engineering. The result is that the author knows how to complete a project from start to finish and understands how both technical and nontechnical aspects of a project need to be considered in order to ensure a quality deliverable and bring a project to successful completion. This report concludes that the objectives of the internship were successfully accomplished and that the requirements for the degree of Degree of Engineering have been satisfied
Intern experience at CH���M Hill, Inc.: an internship report
No full textIncludes author's vita"Submitted to the College of Engineering of Texas A&M University in partial
fulfillment of the requirement for the degree of Doctor of Engineering."Includes bibliographical referencesA review of the author's internship experience with CH���M HILL, Inc.
during the period September 1975 through May 1976 is presented. During this nine month
internship the author worked as an Engineer II in the Industrial Processes discipline of this
large consulting engineering firm... The author's prime responsibility was as one of three
lead design engineers on the design of a large wastewater treatment facility for a pulp mill
in Hoquiam, Washington owned by ITT Rayonier Inc. The work generally consisted of the design
of individual treatment units and associated piping and pumping. The purpose of the project
was to provide wastewater treatment capabilities that would satisfy the effluent limitations
(standards) imposed upon the mill by the State of Washington Department of Ecology and the
U.S. Environmental Protection Agency. The author's assignment also entailed necessary
interaction with the project manager and other CH���M HILL design engineers and support staff
members, the client's representatives, and representatives of two other consulting engineering
firms working on the project. Thus, the internship position at CH���M HILL provided considerable
experience coordinating the author's work with the work of other engineers, guiding the design
and administrative efforts of a support staff, and interacting regularly with the client and
other consulting firms. This broad exposure to a variety of engineering and organizational
problems provided a valuable educational experience
- …
