2,364 research outputs found
Reptricket. Förord till Lars Gustafsson: Mot noll
No full textIntroduction to a collection of philosophical essays by Swedish author Lars Gustafsson (b. 1936)
Author Functions in Lars Kepler\u27s The Hypnotist: An Analysis
No full textThis paper examines Foucault\u27s notion of the author function as it pertains to Lars Kepler\u27s bestselling 2011 crime thriller, The Hypnotist. Lars Kepler is the pseudonym of a Swedish husband-wife writing duo, making him the perfect subject for analysis centering on illusory notion of the author. This paper will answer these questions: Who is the true author of The Hypnotist? What factors influence the author function of this bestelling novel? And what can The Hypnotist phenomenon tell us about the relationships between authors and their readers? This paper will demonstrate that no literary works may be ascribed to an individual person, and that authors hold no privileged knowledge of the works they produce, because authors cease to be authors the moment pen is lifted from page
Oslofjorden 20-23 juni 2011, CTD och spridningshastigheter
No full textVertical profiles of stratification and dissipation rates of turbulent kinetic energy along transects. The data were collected during the period June 20 to June 23, 2011 on board the R/V Trygve Braarud. The wind conditions were relatively calm during the data collection. The maximum measured wind speed at station Gullholmen (59°26.11’N 10°34.68’) was 8.4 m/s. A MSS90L profiler (MSS) was dropped continuously from the stern of the ship as it cruised at low speeds (~1 knot). The MSS90L is a loosely tethered profiler with standard conductivity, temperature and pressure (CTD) sensors as well as two airfoil shear probes (PNS06) sampling at 1024 Hz with 16 bit resolution while the profiler is freely falling through the water with a sinking speed of about 0.6-0.7 m s-1. A more detailed discussion of an earlier version of the instrument can be found in Prandke and Stips (1998). A sensor protecion guard allowd full depth profiles down to 0.1 m above the bottom, with exception of the upper 2-3 meters which were influenced by vessel turbulence and removed. A total of 15 transects were performed; 13 along-fjord transects over the Drøbak Sill and 2 across-fjord transects just inside the sill. Altogether 368 profiles were collected.
Dissipation rates: Dissipation rates of turbulent kinetic energy were obtained from the microstructure shear data using standard methods, as describe in more detail by e.g. Arneborg and Liljebladh (2009). Basically, the shear probes measure how one transverse velocity component changes along the path of the profiler. From the shear variance one can calculate the dissipation rate under the assumption of isotropic turbulence. However, since the sensors do not cover the complete wave-number range of the shear variance, the dissipation rates are obtained by fitting the observed shear spectrum to the universal Nasmyth spectrum for that component. This is done in 50% overlapping 512 point segments, and the resulting estimates of dissipation rate are averaged into 0.5 m bins. In the present case, the main problem with this method is that the velocity of the sensor tip through the water is estimated from the rate of change of the pressure. The velocity through the water enters the calculation of dissipation rates to the power of 4, so small errors in the velocity give considerable errors in the dissipation rate. As discussed in Klymak and Gregg (2004) this may cause large problem in a hydraulic jump where the vertical velocities can be large relative to the sinking velocity of the profiler. As proposed by Klymak and Gregg (2004) we also considered a constant velocity rather than that calculated from the pressure, but found no significant differences in the results. The results presented here are therefore obtained by using the traditional method.
Temperatures: The NTC channel is based on an fp07 fast thermistor, which designed for fast response rather than stability. The TEMPcor channel is based on an Pt100 sensor with better accuracy (+/- 0.01 deg C) but slower response. The raw temperatures are corrected for response time before averaging.
The conductivity sensor is a 7-pole cell with specified accuracy of about +/- 0.05mS/cm.Vertikala profiler för stratifiering och spridningshastigheter av turbulent kinetisk energi längs transekt.
Data samlades in under perioden 20 juni till 23 juni 2011 ombord på fartyget R/V Trygve Braarud. Vindförhållandena var relativt lugna under datainsamlingen.
Mätningar/profileringarna genomfördes med ett turbulensinstrument, MSS90L. Totalt 15 transekter utfördes; 13 längs fjorden och 2 tvärs över fjorden. Totalt insamlades 368 profiler
För mer information se den engelska katalogsidan: https://snd.gu.se/en/catalogue/study/ecds0113
Se beskrivning på engelska
Oslofjorden 20-23 juni 2011, CTD och spridningshastigheter
No full textVertical profiles of stratification and dissipation rates of turbulent kinetic energy along transects. The data were collected during the period June 20 to June 23, 2011 on board the R/V Trygve Braarud. The wind conditions were relatively calm during the data collection. The maximum measured wind speed at station Gullholmen (59°26.11’N 10°34.68’) was 8.4 m/s. A MSS90L profiler (MSS) was dropped continuously from the stern of the ship as it cruised at low speeds (~1 knot). The MSS90L is a loosely tethered profiler with standard conductivity, temperature and pressure (CTD) sensors as well as two airfoil shear probes (PNS06) sampling at 1024 Hz with 16 bit resolution while the profiler is freely falling through the water with a sinking speed of about 0.6-0.7 m s-1. A more detailed discussion of an earlier version of the instrument can be found in Prandke and Stips (1998). A sensor protecion guard allowd full depth profiles down to 0.1 m above the bottom, with exception of the upper 2-3 meters which were influenced by vessel turbulence and removed. A total of 15 transects were performed; 13 along-fjord transects over the Drøbak Sill and 2 across-fjord transects just inside the sill. Altogether 368 profiles were collected. Dissipation rates: Dissipation rates of turbulent kinetic energy were obtained from the microstructure shear data using standard methods, as describe in more detail by e.g. Arneborg and Liljebladh (2009). Basically, the shear probes measure how one transverse velocity component changes along the path of the profiler. From the shear variance one can calculate the dissipation rate under the assumption of isotropic turbulence. However, since the sensors do not cover the complete wave-number range of the shear variance, the dissipation rates are obtained by fitting the observed shear spectrum to the universal Nasmyth spectrum for that component. This is done in 50% overlapping 512 point segments, and the resulting estimates of dissipation rate are averaged into 0.5 m bins. In the present case, the main problem with this method is that the velocity of the sensor tip through the water is estimated from the rate of change of the pressure. The velocity through the water enters the calculation of dissipation rates to the power of 4, so small errors in the velocity give considerable errors in the dissipation rate. As discussed in Klymak and Gregg (2004) this may cause large problem in a hydraulic jump where the vertical velocities can be large relative to the sinking velocity of the profiler. As proposed by Klymak and Gregg (2004) we also considered a constant velocity rather than that calculated from the pressure, but found no significant differences in the results. The results presented here are therefore obtained by using the traditional method. Temperatures: The NTC channel is based on an fp07 fast thermistor, which designed for fast response rather than stability. The TEMPcor channel is based on an Pt100 sensor with better accuracy (+/- 0.01 deg C) but slower response. The raw temperatures are corrected for response time before averaging. The conductivity sensor is a 7-pole cell with specified accuracy of about +/- 0.05mS/cm.Vertikala profiler för stratifiering och spridningshastigheter av turbulent kinetisk energi längs transekt. Data samlades in under perioden 20 juni till 23 juni 2011 ombord på fartyget R/V Trygve Braarud. Vindförhållandena var relativt lugna under datainsamlingen. Mätningar/profileringarna genomfördes med ett turbulensinstrument, MSS90L. Totalt 15 transekter utfördes; 13 längs fjorden och 2 tvärs över fjorden. Totalt insamlades 368 profiler För mer information se den engelska katalogsidan: https://snd.gu.se/en/catalogue/study/ecds0113 Se beskrivning på engelska
”Lärda nyheter” i Peter Hernquists korrespondens till Carl von Linné och Abraham Bäck - med kommentarer och utvikningar
No full textI detta Meddelande nr 55 från Veterinärhistoriska museet har författaren - professor emeritus Lars-Erik Appelgren - gjort ett urval av den korrespondens som Peter Hernquist hade med sina mentorer Carl von Linné och Abraham Bäck under sin vistelse i Frankrike, varvid ”Lärda nyheter” varit en ledstjärna för urvalet. Speciellt har breven till Bäck försetts med författarens personliga kommentarer men även kompletterats med faktaupplysningar från andra källor än breven om berörda nyheter. För att underlätta läsningen har dessa kommentarer omgetts med enkelkonturerad och utvikningarna med dubbelkonturerad ram. Lars-Erik Appelgren har inte bara genom sitt veterinärhistoriska författarskap utan också genom att ställa sina fackliga kunskaper och sin eminenta estetiska läggning till förfogande gjort Veterinärhistoriska museet ovärderliga tjänster. Det är med stor glädje jag noterar att region Uppsala nyligen visat sin uppskattning genom att tilldela Lars-Erik sitt Medicinhistoriska stipendium med motiveringen att de vill ”lyfta fram ett viktigt men ofta förbisett område inom medicinhistorien: veterinärmedicinen”. Med de varmaste gratulationer
Interpreting Wage Bargaining Norms
No full textFrom the mid-1990s onwards, Swedish wage bargaining has been characterised by informal co-ordination of the wage claims of big unions and bargaining cartels. In particular, it has been understood that the manufacturing sector should lead by first agreeing on a pay increase, whereafter the service sector and public sector unions choose a similar increase. We analyse his setup with two possible theoretical interpretations: (i) the manufacturing sector as a tackelberg leader and (ii) a normative role for the manufacturing sector’s pay increase, upported either by unmodelled social pressure or a modeled loss aversion (envy) of the heltered sector unions. The conclusion of the analysis is that the normative or leading role of one sector – in the Swedish case the manufacturing sector – can potentially bring big benefits for employment and output. Generalising an idea suggested by Lars Calmfors and Anna Larsson, our analysis also generates a rudimentary theory of why the wage increase norm sometimes binds and sometimes not. A comparison of the model predictions and the observed outcomes of the last five wage bargaining rounds in Sweden suggests that the model is generally consistent with the empirical observations: wage moderation and norm observance are stronger when the manufacturing industry’s initial relative wage is low.wage bargaining; bargaining co-ordination
Dan Andersson
No full textSpecial feature issue on the Swedish author Dan Andersson, with articles by Anders Hallengren, Nisse Munck, Lars Furuland, Lars Järnemo (2), Gösta Ågren, Inge Mattsson, Arne Säll, and Bure Holmbäck.</p
Representation of female characters in the films of Lars von Trier
No full textOslanjajući se na sličnosti u ženskim likovima Lars Von Triera, detektirani su patrijarhalni i religijski obrasci koji su okosnica radnje filmova Lomeći valove, Dogville i Antikrist. Kroz religijsku i patrijarhalnu optiku autor čita Lars Von Triera kao redatelja koji istu optiku kritizira i preispituje u svom stvaralaštvu.Relying on the similarities in Lars von Trier's female characters, patriarchal and religious patterns have been detected that are the backbone of the plot of the films Breaking the Waves, Dogville and the Antichrist. Through religious and patriarchal optics, the author reads Lars Von Trier as a director who criticizes and questions the same optics in his work
Representation of female characters in the films of Lars von Trier
No full textOslanjajući se na sličnosti u ženskim likovima Lars Von Triera, detektirani su patrijarhalni i religijski obrasci koji su okosnica radnje filmova Lomeći valove, Dogville i Antikrist. Kroz religijsku i patrijarhalnu optiku autor čita Lars Von Triera kao redatelja koji istu optiku kritizira i preispituje u svom stvaralaštvu.Relying on the similarities in Lars von Trier's female characters, patriarchal and religious patterns have been detected that are the backbone of the plot of the films Breaking the Waves, Dogville and the Antichrist. Through religious and patriarchal optics, the author reads Lars Von Trier as a director who criticizes and questions the same optics in his work
Representation of female characters in the films of Lars von Trier
No full textOslanjajući se na sličnosti u ženskim likovima Lars Von Triera, detektirani su patrijarhalni i religijski obrasci koji su okosnica radnje filmova Lomeći valove, Dogville i Antikrist. Kroz religijsku i patrijarhalnu optiku autor čita Lars Von Triera kao redatelja koji istu optiku kritizira i preispituje u svom stvaralaštvu.Relying on the similarities in Lars von Trier's female characters, patriarchal and religious patterns have been detected that are the backbone of the plot of the films Breaking the Waves, Dogville and the Antichrist. Through religious and patriarchal optics, the author reads Lars Von Trier as a director who criticizes and questions the same optics in his work
- …
