Indo. J. Chem. Res.
Not a member yet
303 research outputs found
Sort by
Identifikasi Batuan PAF, NAF dan UNCERTAIN dengan Menggunakan Metode NTAPP Pada Area PT. Trubaindo Coal Mining, Melak-Kalimantan Timur
Get PDFThe research about identification of PAF, NAF and uncertain rock using NTAPP method in the PT. Trubaindo Coal Mining has been done. This research was conducted as an effort to control the potential for the formation of acid mine drainage, with identifying the types of mine rocks using certain testing methods. Some important parameters such as Total Sulfur Level, Slurry pH, Total Actual Acidity (TAA), Chromium Reducible Sulfur (CRS) and Acid Neutralizing Capacity (ANC) using the NTAPP method on mine rocks have been determined to identify mining rock category categories. Based on the results of tests on 101 samples, 63 samples were identified included in the category of rocks that are not NAF (Slurry pH value = 4.1 - 8.9; Total Sulfur = 0.01-0.60 %; CRS = 0.01-0.10 % and NTAPP = 0.030-0.959 %), 38 samples were classified as PAF (pH Slurry = 2.9-7.9; Total Sulfur = 0.01-5.10 %; CRS = 0.11-2.04 % and NTAPP = 0.053-4.571 %), and no sample was included in the uncertainty category. 
Pengaruh Tekanan Dan Tahap Kompresi Dalam Pemurnian Biogas Menjadi Biometana Dengan Absorpsi CO2 Menggunakan Air Bertekanan
Get PDFPalm oil mill effluent (POME) from condensate stew, hydrocyclone water, and sludge separator contains organic carbon with a COD more than 40 g/L and a nitrogen content of about 0.2 and 0.5 g/L as ammonia nitrogen and total nitrogen. At present, the POME is converted into biogas using anaerobic ponds. Biogas produced contains 60% methane (CH4) and 40% carbon dioxide (CO2) and can be purified into biomethane through CO2 absorption using water. This study evaluates the optimum pressure and feed compression stage in biogas upgrading into biomethane. The results show the rate of circulation of water needed to separate CO2 from biogas feed decreases with increasing absorber pressure due to increased solubility of CO2 in water. Water circulation pumps and biogas compressor works increase due to the increase in pressure difference needed. The optimum pressure of the biogas biogas purification unit is within the range of 7-10 bar. At the same absorber pressure, the 1 stage feed compression unit is cheaper than that of 2 stages. However, the overall process with 1 compression stage might not be more economical than the 2-stage if consider the higher methane loss
Patchouli Oil Isolation and Identification of Chemical Components Using GC-MS
Get PDFThis research aims to isolate oil from patchouli (Pogostemon cablin Benth) and identify the chemical components of patchouli oil using Gas Chromatography-Mass Spectrometry (GC-MS). Patchouli plant samples were obtained from Welulu Village, Kolaka Regency, Southeast Sulawesi Province. Fresh patchouli leaves are dried in the sun for four days to a constant weight. Patchouli leaves water content is 77.41% (w/w). Dry patchouli leaves are distilled using the water and steam method for two hours. Water and oil distillates are separated using a separating funnel. Patchouli oil obtained was dried using Na2SO4 anhydrous and yield 0.73% (w/w). The results of GC-MS analysis showed that patchouli oil contained 13 chemical components compounds, namely β-patchoulene (4.56%), cedr-8-ene (1.24%), trans-caryophyllene (7.96%), α-guaiene (18.61%), seychellene (5.70%), patchoulene (2.88%), eremophilene (1.33%), azulene (8.74%), delta-guaiene (18.90%), cyclohexanone (1.10%), globulol (1.88%), veridiflorol (4.39%), and alcohol patchouli (22.7%)
Serbuk Gergaji Kayu Jati Teraktivasi EDTA Sebagai Penjerap Ion Tembaga (II) dan Krom (III)
Get PDFTeak sawdust is a waste of the furniture industry. The main compound content is cellulose, which contains hydroxyl groups so that can be used as adsorbent. This work aims to determine adsorption capacity and isotherm adsorption pattern of teak sawdust activated by EDTA for copper (II) dan chromium (III) ions. Some parameters were optimized including the ratio of adsorbent and EDTA, and contact time. The results showed the optimum ratio of teak sawdust and EDTA was 2:3, and the optimum contact time was 105 minutes. Both of isoterm adsorption patterns of teak sawdust to Cu (II) and Cr (III) ions follow the Freundlich equation, with determination coefficient close to one. Optimum adsorption capacity was obtained 46.5 and 39.7 mg/g for Cu (II) and Cr (III), respectively
Mekanisme Teoritis Pembentukan Senyawa Siklik Hidrokarbon dari Reaksi C4H5 dan C4H2
Get PDFAcetylene and polyyne are intermediates in the formation of Polycyclic Aromatic Hydrocarbons (PAHs) and soot in combustion or pyrolysis. PAH formation from acetylene is known as the most adopted pathway because it has a low reaction energy. Another mechanism for the formation of PAH is a mechanism that involves polyyne or known as a radical pathway, proposed by Krestinin. This pathway involves the reaction of alkyne + alkenes which results in the addition of radical sites to the molecular structure. In this study, the two reaction mechanisms will be compared. Electronic features and energy requirements of the reaction process will be evaluated using molecular computational studies based on electron density (DFT). In combustion conditions (high temperature), the formation of radical sites requires relatively little energy, with a range of 2-5 kcal/mol. This is very different when compared to the energy profile for the same reaction at room temperature. From this study, it can be concluded that the mechanism of radical growth has the potential to occur in combustion reactions.Polycyclic aromatic hydrocarbons, radical growth, combustion, polyyne
Penyingkiran Merkuri Dari Minyak Mentah Berat: Konversi Merkuri Ion ke Merkuri Metalik
Get PDFThe presence of mercury in crude oil creates problems in oil processing in refineries, both in terms of operations and health. The previous removal process of mercury has not yet optimally removed mercury in the product, due to ionic and metallic mercury species. In this study, to obtain optimum results, the process of removal of mercury begins with the process of converting ionic (non-metallic) mercury into metallic mercury thermally in the liquid phase, followed by the transfer of metallic mercury to the gas phase by instant evaporation (flashing) and reinforced by gas stripping using internal gas cone from the evaporation of an instant. The results of the optimization of the process carried out can eliminate mercury with an efficiency of more than 95%
Biokonsentrasi dan Bioakumulasi Mercury (Hg) Pada Lamun Enhalus Acoroides Di Teluk Kayeli Kabupaten Buru Provinsi Maluku
Get PDFGold reserves on Gunung Botak (Bald Mountain), Buru Island, were discovered in 2011. Since then, thousands of illegal miners have used amalgamation methods to extract gold in the areas of Gunung Botak and Gogrea, Buru Island. The resulting waste is disposed of into the environment directly without any treatment process so it is very dangerous for humans and the environment. This research was conducted to determine the ability of the Enhalus acoroides type of seagrass to accumulate heavy metal mercury (Hg) in the aquatic environment. This research shows that the heavy metal mercury has been distributed in the water sediments along Kayeli Bay. Mercury bio-concentration (accumulation) Gunung Botak, Kayeli Bay, Mercury (Hg), bioconcenstration, Seagrass, Enhalus acoroides, Kayeli Baywas found in Enhalus acoroides seagrass, in leaves (0.0243-0.0373 mg/Kg), and in rhizomes (0.0453-0.0663 mg/Kg). This result shows that the Kayeli Bay ecosystem has been contaminated with mercury
Ekstraksi Kalsium dari Cangkang Kerang Hijau (Perna viridis L.) dan Kerang Batik (Paphia undulata B.) dengan Metode Kalsinasi sebagai Sediaan Effervescent
Get PDFOne of the solutions is the supplying of calcium effervescent powder as a source of calcium. The source of calcium that has not been processed maximally is the clam shell. Calcium from the clam shells will be extracted by calcination method at 900 °C for 4 hours. The extracted clam shells powder are tested using XRD and analyzed using the Rietveld method. The particle sizes of calcium are determined by the Scherer equation. The best calcium is formulated into 3 formulations with several variations in composition. Evaluation of calcium effervescent powder includes organoleptic test, water content and dispersion time. The extracted calcium crystal diffractogram shows the CaO compound with cubic structure and space group FM3M. The particle sizes of CaO nanoparticles from green shells and batik were 88.7597nm and 96.66566nm, respectively. The best CaO based on χ2 values ​​and particle sizes are CaO from green clamshells. The organoleptic test of the three formulations produced the same data as yellow, granular shape, and citrus aroma. Formulation three is the best formulation based on the low water content and short dispersion time
Produksi Ekstrak Bioaktif Untuk Aditif Pangan Dari Limbah Kulit Buah Naga: Pengaruh Metode Pre-Treatment Dan Ekstraksi
Get PDFDragon fruit is one of the tropical fruits can be grown in Indonesia. The skin of dragon fruit, which is accounted for 30-35% of the whole fruit usually thrown away as waste. This study aims to produce a bioactive extract from extraction of dragon fruit skin that is rich in phenolic and pigment compounds then it used as food additives. The variation that was used in this study includes the application of drying as pre-treatment of dragon fruit skin and the extraction methods (maceration and Soxhlet extraction). The obtained extracts were evaluated for the amount of total phenolic compounds and pigments (anthocyanin and betacyanin). Drying of dragon fruit skin was found to yield lower amounts of bioactive materials, which may occur due to the thermal degradation even though a low drying temperature was used. In addition, the maceration method was found to give a higher amount of bioactive materials compared with the Soxhlet method. The extraction with the highest yield of bioactive materials was obtained by the use of fresh dragon fruit skin and maceration for 240 minutes, which gave amounts of anthocyanin, betacyanin, and total phenolic compounds of 0.08, 0.04, dan 0.35 mg/g fresh dragon fruit skin, respectively
Isoterm Adsorpsi Ion Cr(III) Oleh Kitosan Hasil Isolasi Limbah Kepiting Rajungan dan Kitosan Komersil
Get PDFThe chitin isolation from crab Rajungan (Portunus sanginolentus) and commercial chitin was done. The chitosan was made by deasetilation of chitin using alkaline solution with addition NaBH4. The chitin and chitosan were identified by related instrument. The identification by adsorption Cr(III) ion on chitosan was done by the Atomic Absorption Spectrofotometry. The result of the chitosan isolation was fitted to the Freundlisch isotherm, with KF = 1.18673 mg/g and 1/n= 0.2712.