International Journal of Reconfigurable and Embedded Systems (IJRES)
Not a member yet
454 research outputs found
Sort by
Low-cost electrocardiogram monitoring system for elderly people using LabVIEW
Get PDFCardiovascular diseases increase due to factors such as obesity, an inadequate diet, and are a problem due to shortages of medical personnel and hospitals. In this case, the implementation of technological solutions is presented as a necessity to prevent heart diseases. Various approaches are used to design low-cost electrocardiogram (ECG) devices, from the use of Bluetooth technology to facilitate data transmission, to the development of wearable ECG devices that use artificial intelligence. The objective is to develop a monitoring system in LabVIEW to visualize the heart rhythms of older adults in the city of Lima (Peru), focusing on ease of use and adaptation to their needs, with the purpose of collaboration between health professionals. A development approach is used that encompasses design, implementation, and iterative testing, as well as practical evaluations and pilot testing. As a result, the correct functioning of the ECG device was validated. Electronic components and electrodes were integrated into the board to capture cardiac signals, energized with batteries and sending the information to an interface in LabVIEW. In conclusion, a portable ECG device has been developed that uses operational amplifiers (Op-amps) and analog filters to reduce noise in cardiac measurements and an intuitive interface in LabVIE
Air quality monitoring system based on low power wide area network technology at public transport stops
Get PDFMass migration from rural areas to urban areas has caused problems of traffic congestion, high industrial concentration and inequity in the distribution of housing in the world's capitals, generating a significant threat to sustainable development and public health due to air pollution air. In the Peruvian context, the importance of real-time monitoring of air quality is highlighted according to the standards established by the government. Several studies propose real-time environmental monitoring systems using internet of thing (IoT) technologies, electrochemical and optical sensors to measure pollutants, highlighting the need for data analysis. The objective of the paper is to show the implementation of IoT devices called sensor nodes, with long range wide area network (LoRaWAN) transmission technology for continuous monitoring of polluting gas concentrations. In addition, they are integrated into a central node called gateway to perform real-time monitoring through a web application. As an initial result, IoT devices demonstrated their effectiveness for real-time monitoring. Despite being a prototype-level result, the next stage involves its deployment at public transport stops in Lima. Overcoming the limitations of the solution, this paper establishes the foundation for future research on pollution and public health
Affective analysis in machine learning using AMIGOS with Gaussian expectation-maximization model
Get PDFInvestigating human subjects is the goal of predicting human emotions in the stock market. A significant number of psychological effects require (feelings) to be produced, directly releasing human emotions. The development of effect theory leads one to believe that one must be aware of one's sentiments and emotions to forecast one's behavior. The proposed line of inquiry focuses on developing a reliable model incorporating neurophysiological data into actual feelings. Any change in emotional affect will directly elicit a response in the body's physiological systems. This approach is named after the notion of Gaussian mixture models (GMM). The statistical reaction following data processing, quantitative findings on emotion labels, and coincidental responses with training samples all directly impact the outcomes that are accomplished. In terms of statistical parameters such as population mean and standard deviation, the suggested method is evaluated compared to a technique considered to be state-of-the-art. The proposed system determines an individual's emotional state after a minimum of 6 iterative learning using the Gaussian expectation-maximization (GEM) statistical model, in which the iterations tend to continue to zero error. Perhaps each of these improves predictions while simultaneously increasing the amount of value extracted
Adaptive tunicate swarm optimization with partial transmit sequence for phase optimization in MIMO-OFDM
Get PDFMultiple-input multiple-output (MIMO) and orthogonal frequency division multiplexing (OFDM) are widely utilized in wireless systems and maximum data rate communications. The MIMO-OFDM technology increases the efficiency of spectrum utilization. The peak-to-average-power ratio (PAPR) minimization in MIMO-OFDM is a complex task in wireless communications systems. In this research, an adaptive tunicate swarm optimization with partial transmit sequence (ATSO-PTS) algorithm is proposed for a reduction of PAPR in MIMO-OFDM. The nonsquare-matrix-based differential space time coding (N-DSTC) scheme is used for the encoding and decoding process of MIMO-OFDM. The N-DSTC encoding and decoding are linear error-correcting codes that are utilized for message transmission over noisy channels. The pre-specified quadrate phase shift keying (QPSK) symbol is deployed for the modulation and demodulation scheme. On the receiver side, the serial to parallel (S/P) conversion, and fast Fourier transform (FFT) are accomplished, alongside the received data bits being demodulated to obtain the output bits. The proposed ATSO-PTS method achieves better results according to performance metrices PAPR, bit error rate (BER) and signal-to-noise-ratio (SNR), with values of about 2.9, 0.01 and 0.025, respectively. This ensures superior results when compared to the existing methods of twin symbol hybrid optimization applied to partial transmit sequence (TSHO-PTS), selective level mapping and PTS (SLM-PTS), and particle swarm and grey wolf (PS-GW) with PTS, respectively
Design and performance analysis of asynchronous network on chip for streaming data transmission on FPGA
Get PDFThe majority of the system on chip (SoC) uses the network on chip (NoC) as routing ports for data transfer from node-to-node with minimal power consumption and low latency and high throughput. This paper concentrates on the ability to model the asynchronous NoCs on the asynchronous circuits on field programmable gate arrays (FPGAs). A 3×3 NoC and its universal asynchronous receiver transmitter (UART) protocol is designed and its simulation of the Verilog hardware description language (VHDL) code is done and tested on the Artix-7 FPGA kit, the testing processes in done using the Chipscope tool. In order to meet target requirements in terms of power consumption and latency, the label switching (LS) technique is used as routing. The proposed LS-NoC with level-encoded dual-rail (LEDR) encoding technique provides throughput by registering the packet between the different routers and it helps to improve throughput and speed. The effectiveness of the data transfer is measured and analyzed through a synthesis summary in terms of lookup table’s (LUT’s), slice registers, flip flops’s (FF’s), latency, and packet delivery ratio (PDR) for the traffic pattern generator. The proposed NoC is designed for 8×8 and each port size is 21 bits including ID’s of source and destination routers. The results can be justified by following results: improvement of LUTs is about 12%, flip-flops are 7%, improvement of throughput is 23% and delay is reduced by 26%
Earthquake detection in mountainous homes using the internet of things connected to photovoltaic energy supply
Get PDFThe North Sumatra region is an area with the potential for earthquakes originating from volcanic and oceanic eruptions which have resulted in many fatalities. Therefore, through the application of automatic monitoring and control system technology connected to the internet of things (IoTs), it is the right solution to provide efforts to increase security for residents of the house to always be vigilant. The security enhancement method referred to in this study is a home security system protection system by anticipating earthquakes. The advantage of this tool is that it applies a notification security system method with a sensitivity sensor which is automatically sent via email and sonor buzzer which also acts as sound vibrations due to an earthquake. The test results show that when a vibration occurs, the system will send a short email message to the user's smartphone so that the user will receive an email in the form of a warning message that the state of the house has an earthquake and the light-emitting diode (LED) interrupts and the buzzer is also on so that the alarm sounds which has been integrated into IoT. Then an integrated security monitoring system using the web can be monitored in real time
Comparative study of password storing using hash function with MD5, SHA1, SHA2, and SHA3 algorithm
Get PDFThe main purpose of passwords is to prevent unauthorized people from accessing the system. The rise in internet users has led to an increase in password hacking, which has resulted in a variety of problems. These issues include opponents stealing a company's or nation's private information and harming the economy or the organization's security. Password hacking is a common tool used by hackers for illegal purposes. Password security against hackers is essential. There are several ways to hack passwords, including traffic interception, social engineering, credential stuffing, and password spraying. In an attempt to prevent hacking, hashing algorithms are therefore mostly employed to hash passwords, making password cracking more difficult. In the suggested work, several hashing techniques, including message digest (MD5), secure hash algorithms (SHA1, SHA2, and SHA3) have been used. They have become vulnerable as a result of being used to store passwords. A rainbow table attack is conceivable. Passwords produced with different hash algorithms can have their hash values attacked with the help of the Hashcat program. It is proven that the SHA3 algorithm can help with more secure password storage when compared to other algorithms
Highly selective filtering power divider using substrate integrated waveguide technique for radar applications
Get PDFThis article exhibits a filtering power divider designed with substrate integrated waveguide (SIW) technique, having the power dividing as well as filtering functionalities. In the design band-pass performance is realized by merging SIW structure having high-pass response and complementary split ring resonator (CSRRs) with parallel tank LC resonant response and the dumbbells shape defected ground structure (DGS) with high out of band rejection characteristics. The anticipated structure serves as both a power divider and a filter, it reduces both the cost and the size of the system. Structure is constructed and tested to confirm the design functionality. The measurement result shows the return loss of -25.94 dB with 3-dB fractional bandwidth of 2.85% at 14 GHz
Noise coupling reduction using temperature enhanced device for future integrated circuit integration applications
Get PDFInformation technology-to-internet of things may have succeeded because of fast silicon chip capability expansion. Moore's law, which reduces device size, boosted integrated circuit (IC) performance. Delay rises with highdensity connection parasitic capacitance. Interconnect delays have surpassed transistor delays and slowed progress. An alternative is required now to reduce connection latency. The third dimension is used in popular 3D IC technology IC technology requires through silicon via (TSV) for signal integrity and heat mitigation. Noise coupling hinders electrical communication between signal-carrying TSVs (aggressive TSVs) and ground TSVs (victim TSVs), a 3D IC bottleneck. TSVs must be dielectrically insulated from Si substrates to avoid electrical signal interference. Additionally, first-order modelling will confirm the suggestions. This article proposes using the nanosheet field effect transistor (NSFET) to overcome 3D IC noise coupling and complementary metal oxide semiconductor (CMOS) technology nodes. After discussing the electronic industry and sub nm, several basic metrics and criteria for developing electronic components are presented. The first technique uses Perylene-N's exceptional noise-cancelling characteristics. Second technique uses electrical TSV (ETSV), thermal TSV (TTSV), and heat source models to measure noise coupling on numerous ICs. The third proposes many noise-reducing materials. The suggested structures outperform traditional approaches
Implementing hue-saturation-value filter and circle hough transform for object tracking on ball-wheeled robot
Get PDFThe ball-wheeled robot relies on a camera for receiving information on the object to be followed. Object tracing is one of the methods that can be used for detecting object movement. In recognizing objects around it, the robot requires an image analysis process that involves visual perception. Image processing is the process of processing and analyzing images that involves visual perception, and is characterized by input data and output information in the form of images. This is how the robot can see objects around it and then be assisted by computer vision to make a decision. The object tracking method with hue-saturation-value (HSV) colour filtering and shape recognition with circle hough transform (CHT) is applied to the ball-wheeled robot. The front vision of the robot uses HSV colour filtering with various test values to determine the thresholding value, and it was found that the ball could be identified up to a distance of 1,000 cm. To further improve the performance of recognizing the ball object, CHT was applied. It was found that the ball could be identified up to a distance of 700 cm. Furthermore, the ball can be identified in obstructed conditions up to 75%