1,720,963 research outputs found
Control of composition and grain growth in Cu 2 ZnSnS 4 thin films from nanoparticle inks
No full textCu 2 ZnSnS 4 (CZTS) nanocrystals (NCs) were produced via hot-injection from metal chloride precursors. A systematic investigation of the influence of synthesis conditions on composition, size and microstructure of CZTS NCs is presented. The results show that the solvent amount (oleylamine) is a key parameter in the synthesis of this quaternary chalcogenide: a low solvent content leads to CZTS NCs with a prominent kesterite phase with the desired composition for use as absorber material in thin film photovoltaic cells. It is also observed that lowering the injection temperature (250 °C) favours formation of CZTS NCs in the wurtzite phase. The effect of different high temperature thermal treatments on the grain growth is also shown: large crystals are obtained with annealing in inert atmosphere, whereas nanocrystalline films are obtained introducing sulphur vapour during the heat treatment. A correlation between the grain dimension and the carbonaceous residues in the final films is investigated. It is shown that the grain growth is hindered by organic residues, amount and nature of which depend on the heat treatment atmosphere. In fact, oleylamine is removed by a complex pyrolytic process, which is affected by the presence of sulphur vapour. The latter favours the stability of oleylamine residuals against its non-oxidative release
Synthesis and post-annealing of Cu2ZnSnS4 absorber layers based on Oleylamine/1-dodecanethiol
No full textCu2ZnSnS4 (CZTS) nanocrystals in oleylamine (OLA) and 1-dodecanethiol (1-DDT) solvents were successfully prepared via hot-injection method, to produce inks for the deposition of absorber layers in photovoltaic cells. In this process, 1-DDT acts as a coordinating ligand to control the nucleation and growth of CZTS nanocrystals, whereas lower amounts of OLA promote a homogeneous growth of the grains in the absorber layer. X-Ray Diffraction (XRD) revealed both tetragonal and hexagonal phases of CTZS in films obtained after soft thermal treatments (labeled TT0). In particular, 1-DDT is responsible for the formation of a greater percentage of the hexagonal phase (ZnS-wurtzite type) than that formed when only OLA is used. The thermal treatments have been varied from 500 °C to 600 °C for improving crystallization and eliminating secondary phases. Both features are known to promote CZTS thin films with band gap values typical of CZTS (1.5-1.6 eV) and suitable resistivity. This study let to compare also the CZTS post-annealing without (TT1) and with sulfur vapor (TT2) in a tubular furnace. Only tetragonal CZTS phase is observed in the XRD pattern of CZTS thin films after TT2. A small presence of localized residues of secondary phases on the same samples was revealed by μRaman measurements. The best values of band gap (1.50 eV) and resistivity (1.05 ohm.cm) were obtained after thermal treatment at 500 °C, which is suitable for absorber layer in photovoltaic application
Anion Exchange Membranes Based on Chemical Modification of Recycled PET Bottles
Full text linkThis study presents an innovative and effective solution for recycling PET bottles as raw for producing anion exchange membranes (AEMs) for electrochemical applications. This approach reduces the demand for pristine materials, a key principle of the circular economy and sustainability. PET was subjected to chemical modification by introducing cationic functional groups followed by methylation and OH- exchange process. The amination synthesis was optimized based on reaction time. The results indicate that ion exchange capacity, water uptake, and swelling ratio properties mainly depend on the degree of cationic functionalization. The optimized AEM exhibits ionic conductivity of 5.3 x 10(-2) S center dot cm(-1) and alkaline stability of 432 h in 1 M KOH at 80 degrees C. The membrane properties before and after the alkaline treatment were investigated using Fourier-transform infrared spectroscopy, thermogravimetric analysis, and scanning electron microscopy analysis. Computational chemistry analysis was employed to gain further insights into the membrane degradation mechanisms and pathways under alkaline conditions. This research and its findings are a step toward using recycled materials in the field of AEM technology
Going Beyond Counting First Authors in Author Co-citation Analysis
Full text linkThe present study examines one of the fundamental aspects of author co-citation analysis (ACA) - the way co-citation
counts are defined. Co-citation counting provides the data on which all subsequent statistical analyses and mappings
are based, and we compare ACA results based on two different types of co-citation counting - the traditional type that
only counts the first one among a cited work's authors on the one hand and a non-traditional type that takes into
account the first 5 authors of a cited work on the other hand. Results indicate that the picture produced through this non-traditional author co-citation counting contains more coherent author groups and is therefore considerably clearer. However, this picture represents fewer specialties in the research field being studied than that produced through the traditional first-author co-citation counting when the same number of top-ranked authors is selected and analyzed. Reasons for these effects are discussed
Variations on the Author
Full text link“Variations on the Author” discusses two of Eduardo Coutinho’s recent films (Um Dia na Vida, from 2010, and Últimas Conversas, posthumously released in 2015) and their contribution to the general question of documentary authorship. The director’s filmography is characterized by a consistent yet self-effacing form of authorial self-inscription: Coutinho often features as an interviewer that rather than express opinions propels discourses; an interviewer that is good at listening. This mode of self-inscription characterizes him as an author who is not expressive but who is nonetheless markedly present on the screen. In Um Dia na Vida, however, Coutinho is completely absent form the image, while Últimas Conversas, on the contrary, includes a confessional prologue that moves the director from the margins to the center of his films. This article examines the ways in which these works stand out in the filmography of a director who offers new insights into the notion of cinematic authorship
Chemical physical characterization of ancient paper with functionalized polyamidoamines (PAAs)
No full textHybrid inorganic–organic treatments,
based on amide-amine polymers (PAAs), against
thermal oxidation have been prepared on paper dating
back to eighteenth century. The polymeric sols are
obtained by step-growth Michael addition polymerization
and functionalized with siloxane network by
sol–gel method. Five types of samples have been
prepared changing the molar ratios among the reagents
and their concentration. The treated paper samples
were subjected to morphological and structural characterization,
by using Scanning Electron Microscopy
and vibrational spectroscopies (FTIR and Raman),
respectively. Static mechanical tests have been carried
out on the samples for measuring elastic modulus,
ultimate strength, ultimate deformation and energy
loss, whereas dynamic-mechanical measurements
have been recorded at increasing temperatures to
evaluate E0, E00 and tan d. Finally, Thermo-Gravimetry and Differential Scanning Calorimetry have been
carried out in order to study the behaviour of treated
samples in temperature with respect the plain paper.
The main result is that the siloxane-modified PAA
treatment can improve significantly both mechanical
and dynamic-mechanical properties, as well as the
thermal resistance, without altering the aspect and
texture of the original material. In general, the thicker
the impregnation, the better the performances of
treated paper: the thickest treatment is able to prevent
the combustion of paper samples until 500 °C. The
treatment is very promising to preserve ancient
manuscripts during accidental fire and against the
embrittlement due to natural ageing
Appropriate Similarity Measures for Author Cocitation Analysis
Full text linkWe provide a number of new insights into the methodological discussion about author cocitation analysis. We first argue that the use of the Pearson correlation for measuring the similarity between authors’ cocitation profiles is not very satisfactory. We then discuss what kind of similarity measures may be used as an alternative to the Pearson correlation. We consider three similarity measures in particular. One is the well-known cosine. The other two similarity measures have not been used before in the bibliometric literature. Finally, we show by means of an example that our findings have a high practical relevance.information science;Pearson correlation;cosine;similarity measure;author cocitation analysis
Dispelling the Myths Behind First-author Citation Counts
Full text linkWe conducted a full-scale evaluative citation analysis study of scholars in the XML research field to explore just how different from each other author rankings resulting from different citation counting methods actually are, and to demonstrate the capability of emerging data and tools on the Web in supporting more realistic citation counting methods. Our results contest some common arguments for the continued
use of first-author citation counts in the evaluation of scholars, such as high correlations between author rankings by first-author citation counts and other citation
counting methods, and high costs of using more realistic citation counting methods that are not well-supported by the ISI databases. It is argued that increasingly available digital full text research papers make it possible for citation analysis studies to go beyond what the ISI databases have directly supported and to employ more
sophisticated methods
- …
