Hochschulschriftenserver der Hochschule der Medien Stuttgart
Not a member yet
128342 research outputs found
Sort by
CONSTRAINING MOUNTAIN FRONT ACTIVITY IN ACTIVE EXTENSIONAL SETTING BY TECTONIC GEOMORPHOLOGY: CASE STUDIES FROM THE SOUTHERN APENNINES (ITALY)
The southern Apennines is a fold-and-thrust belt, which was formed during the late Cenozoic convergence between the African and Eurasian plates. Late Quaternary and active tectonics are dominated by extensional faulting mainly acting in both the inner and the axial belts of the mountain belt. Since the Early-Middle Pleistocene, activity of high-angle normal faults caused the formation of large coastal grabens and intramountain basins that are often limited by mountain fronts, up to 2000 high, formed in carbonate rocks. Late Quaternary activity of some of these high-angle normal faults, that mainly trend NW-SE and E-W, has been proved through field geomorphological and/ or stratigraphical and structural data and could be inferred by quantitative investigation of landforms. To test the suitability of the quantitative analysis approach to assess the state of activity of faults placed at the boundaries between mountain fronts and alluvial basins, and to verify the limits of applicability of this method, we have carried out a comprehensive analysis of some mountain fronts in the Southern Apennines. We have compared the following indexes: mountain front sinuosity, swath profile, river long profile, slope/area data, alluvial fan and drainage basin metrics. Overall data point to variable geomorphic features of different mountain fronts and along-strike variability of some parameters at the mountain front scale in response to either rock-type resistance or fault behaviour. This study highlights the importance of the tectonic geomorphology approach in active orogens and suggest that this method is suitable to application worldwide to compare mountain front maturity
Time domain predictions of inertial loads on a drifting ship in irregular beam waves
A proper estimation of the ship accelerations, particularly in the transversal direction, is fundamental for predicting the risk of cargo shifts and inherent structural damages in severe irregular seas. A specific situation worth to be considered in this context is the so-called dead ship condition, in which the ship, because of a loss of steering capabilities, is drifting in beam waves at zero speed. Particularly in this situation, a proper modelling of ship dynamics in wave is deemed necessary for a reliable assessment of inertial loads.
In this paper three time domain procedures with different accuracy are applied and compared. The aim is to investigate the dependency of inertial loads on the non-linear effects of ship geometry and on the couplings among the 6DOF of the ship.
Simulations are carried out with, in input, the same irregular sea realizations in the time domain, obtained from a digitalisation of JONSWAP spectra. A technique allowing for a fine matching of the digitalised spectra to the analytical ones is developed and applied.
The investigation indicates that couplings among ship motions trigger larger inertial loads and, accordingly, a larger probability of occurrence for cargo shifting and structural damages
New insights into the hydration of cementitious materials based on magnesium carbonates
The hydration of reactive periclase (MgO) in the presence of hydromagnesite (Mg5(CO3)4(OH)2·4H2O) was investigated by a
variety of physical and chemical techniques. This system is of potential interest as low CO2 binder, if the magnesium
carbonate is produced by carbonation from naturally occurring magnesium silicates such as olivine or serpentine.
In contrary to thermodynamic prediction not artinite (Mg2(CO3)(OH)2·3H2O), but a very poorly-crystalline form of brucite
(Mg(OH)2), and an unknown amorphous hydrate which partially loses its crystal water at about 100°C were the main hydration
products
"Quindici uomini sulla cassa del morto": questione di fiducia e funzioni costituzionali del Parlamento
Il lavoro affronta in tema del conflitto di attribuzione sollevato dai singoli parlamentari nell'ipotesi di lesione delle proprie funzione a seguito dell'apposizione della questione di fiducia da parte del Governo, alla luce della più recente giurisprudenza costituzional
Le ragioni della Natura, della Storia e della Comunità tra rischi ambientali e antropici. Il caso di Ischia.
I dati ISTAT relativi alla Regione Campania al 2018 registrano una popolazione residente pari a 5.826.860 abitanti e una superficie territoriale di 13.590 kmq da cui scaturisce una densità territoriale di 429 ab/kmq. Si conserva, dunque, il primato per densità tra le regioni italiane e anche europee con l’Olanda. Per quanto riguarda il nuovo ente della Città Metropolitana di Napoli che coincide con il precedente ente territoriale della Provincia i dati ISTAT del 2018 registrano una popolazione residente di 3.101.002 abitanti e una superficie territoriale di 1.178,93 kmq da cui scaturisce una densità territoriale di 2.630,35 ab/kmq. Per quanto riguarda l’Isola d’Ischia tra il 2009 e il 2019 si è registrato un incremento di popolazione che dai 60mila è cresciuta a oltre 64mila contro una sostenibilità ambientale all’impatto antropico di appena 23mila abitanti circa un terzo della popolazione residente attuale. I rischi ambientali presenti sull’isola d’Ischia sono legati alla natura vulcanica e idrogeologica, il versante meridionale e settentrionale sono entrambi a rischio frana e alluvione per la presenza del Monte Epomeo e dei boschi della Falanga. Il maggiore rischio sismico si concentra prevalentemente sul versante settentrionale in corrispondenza del Comune di Casamicciola Terme dove nel corso dei secoli si sono sempre verificati terremoti molto superficiali con area epicentrale molto circoscritta. Nonostante la prevalente coincidenza di eventi sismici l’incessante edificazione dell’isola non ha risparmiato nessuna area pianeggiante né delle pendici collinari. Alla sovrapposizione dei rischi ambientali per i fenomeni naturali si amplificano notevolmente per l’esposizione ai rischi stessi di ampie fasce di popolazione residente nonché di ingenti flussi turistici. Dalla sovrapposizione degli effetti sia dei rischi naturali che antropici ne scaturisce un quadro di vulnerabilità del patrimonio edilizio sia storico che di più recente costruzione
Casein composition and differential translational efficiency of casein transcripts in donkey’s milk
The amount of the four caseins (as1, as2, and k-CN) in donkey milk was evaluated by Urea-PAGE analysis at pH 8.6, followed by immuno-detection with polyclonal antibodies, coupled to densitometric analysis. The achieved results showed the percentage of each casein in decreasing order: b54.28) > as1 (35.59) > as2 (7.19) > k-CN (2.79). The mRNA quantification of donkey casein transcripts, carried out by RT-qPCR, showed that the average percentage of corresponding genes’transcripts (CSN2, CSN1S1, CSN1S2 I and CSN3) was 70.85, 6.28, 14.23 and 8.65, respectively. The observed translation efficiency, assessed as percentage of single milk casein fraction out of single percentage of transcript, was 0.76, 5.66, 0.50 and 0.32, respectively. The analysis of the sequences flanking the start codon, the codon usage frequencies and the coding sequence length might explain, at least in part, the differential transcriptional and translational rate observed among the casein transcripts
Proposal of design rules for ductile X-CBFS in the framework of EUROCODE 8
Cross concentrically braced frames (X‐CBFs) are commonly used as primary
seismic resisting system, owing to their large lateral stiffness, simplicity of
design, and relatively low constructional cost. Current EN 1998‐1 provides
design rules theoretically aiming at developing ductile global plastic mechanism,
namely enforcing plastic deformations in the diagonal members, while
the remaining structural members and connections should elastically behave.
However, as widely demonstrated by many existing studies, the design and
the corresponding seismic performance of EC8‐compliant X‐CBFs are generally
affected by several criticisms, eg, difficulties in sizing of diagonal members,
massive and non‐economical structures, and poor seismic behavior. In light of
these considerations, the research activity presented in this paper is addressed
to revise the design rules and requirements given EN 1998‐1 for X‐CBFs to simplify
the design process and to improve the ductility and the dissipative capacity
of this structural system. Hence, design rules are proposed for the next
version of EN 1998‐1 and numerically validated by means of nonlinear dynamic
analyse
Sfide e metodi della traduzione del plurilinguismo: il caso Pontano.
Nel corso del seminario si punterà l’attenzione sulla produzione dialogica latina di Giovanni Gioviano Pontano, esponente di spicco dell’Umanesimo napoletano e successore di Antonio Panormita alla guida della celebre Accademia napoletana, che in seguito sarebbe stata detta, in suo onore, Pontaniana. Ci si soffermerà, in particolar modo, sui dialoghi Charon e Antonius, di cui la relatrice sta curando una nuova edizione critica, accompagnata dalla traduzione francese.
«La scelta di produrre una nuova edizione dei due dialoghi pontaniani – dichiara Bistagne – scaturisce dalla volontà di restituire la giusta importanza ai manoscritti, anche se mutili e talora non autografi. Presentare il testo più vicino possibile al manoscritto significa, infatti, illustrare uno stato della lingua latina e delle lingue volgari altrimenti perduto».
Nell’intervento, inoltre, si discuterà dei criteri cui sembra opportuno improntare il lavoro di traduzione. «Il problema del traduttore – continua Bistagne – di fronte a un linguaggio in movimento, che non è fisso e che vuole essere mimetico di oralità, è complesso. Prima di tutto, dobbiamo lavorare sul testo stesso e, in questo caso, su testi in diverse lingue con diversi riferimenti. Dal punto di vista del traduttore bisogna ammettere che il maggior numero di elementi della realtà contemporanea del Pontano ci sfugge. La sfida del traduttore è quindi quella di non lasciare nulla al regno dell’intraducibile e intendo presentare in questa sede i metodi scelti per raggiungere questo scopo»