International Journal of Applied Power Engineering (IJAPE)
Not a member yet
508 research outputs found
Sort by
Analysis of a gas station hybridization with a solar thermal plant by using ETAP
Get PDFIraq is facing deficiency of electric power for last decades. The main reason for deficiency of electric power is due to less respect of analytical load flow studies of electric supply substation. To stop and overcome such situation in future, researchers should be analyzing different power substation focusing on load flow studies, short circuit studies and protection schemes. Due to lack of research and studies on load flow and fault analysis, Iraq is facing a lot of issues, such as power failures and high copper losses, solving of these problems on substation level, demand a high familiarity about the power system. In this paper we analyses combined typical gas station with solar thermal power station and survey load flow, short circuit, transient stability, and voltage drop before and after combined station by using electrical transient analyzer program (ETAP). Now a day’s power supply reliability and goodness are big interest. analyses of power system are a main part in power system designing and planning, in order to accommodate future loads and the expansion of cities
Smart power grid vulnerability analysis in composite system through power grid modelling
Get PDFA though the number of traditional literature reviews most of the researchers in this area have concluded that modern intelligent electric network a referred standard new model which is considering for proposed power flow model analysis of smart power grid vulnerability through composite network. By the theorem of max-flow and complex power network theorems that are represented the advance vulnerability indices for pick out endangered lines of the smart grid network. In other hand, the power flow model and existing models simulation are examined on the IEEE 39-bus test model. The results of the simulation introduced that the proposed concept of grid model, estimation and the index application are more adequate in smart grid weakness power and efficiency analysis. In this paper briefly summarize the methods and probabilities of a vulnerability index which was explained in specific in references. Therefore, it is imperative to further implement new models and new tools so as to reach the novel state and moderate the huge or massive potential shutof
Hybrid PSO-GSA algorithm-based optimal control strategy for performance enhancement of a grid-connected wind generator
Get PDFDue to the great level of wind energy penetration in the existing network, huge efforts have been directed to enhance the grid-connected wind generator performance. This paper shows an application of a hybrid algorithm of the particle swarm optimization and the gravitational search algorithm (PSO-GSA) to enhance the transient stability of the grid-tied wind energy conversion system. The variable-speed wind turbine (VSWT) direct-drive permanent-magnet synchronous generator is connected to the network through a full-scale converter. The generator- and grid-side converters are controlled by utilizing an optimum proportional-integral (PI) controller. The criterion of the integral squared error is utilized as an objective function. The PSO-GSA based-PI controller efficacy is validated by comparing its results with that are obtained by utilizing the genetic algorithm (GA)-based-PI controller. The performance of the suggested control scheme is checked during various fault conditions. The control scheme quality is legalized by the simulation results that are obtained using MATLAB/Simulink progra
Ranking of hydropower projects based on sustainability criteria in India using multicriteria decision making methods
Get PDFAssessment of hydropower projects with respect to sustainability criteria is a multidimensional and a complex issue that decision makers usually face during planning process. In hydropower projects, it is important to consider technical, environmental and social parameters instead of purely economic ones for sustainability assessment and decision making. Multi-criteria decision making (MCDM) methods offer a practical approach to a problem having conflicting criteria. The flexibility to consider several criteria and objectives simultaneously made MCDM methods well accepted in the field of energy planning. This paper aims for applicability of MCDM methods which will facilitate the decision makers to select the most sustainable hydropower projects by making real and logical choices based on various sustainability criteria. For comprehensively rank hydropower projects of Indian region based on sustainability criteria four MCDM methods are applied i.e., analytic hierarchy process (AHP), technique for order of preference by similarity to ideal solution (TOPSIS), preference ranking organization method for enrichment evaluations (PROMETHEE II) and elimination and choice translating reality (ELECTRE III). To ensure better decision making the eight criteria selected are compatible to the sustainable development of hydropower projects
A grid interconnected nested neutral-point clamped inverter with voltage synchronization using synchronous reference frame controller
Get PDFNested neutral-point clamped multi level inverter with inter connection to grid through the synchronous reference frame (SRF) controller for synchronization of voltage to the grid is demonstrated. The system's main feature is that voltage stress in each inverter switching device is kept to a minimum, and redundant inverter switching states are utilised for neutral point and flying capacitor voltage balancing with sinusoidal pulse-width modulation (PWM) technique, synchronisation to grid voltages, and power injection with low harmonic generation. The inverter receives its input from a photovoltaic (PV) source that is coupled to DC-DC booster converters that are regulated by the maximum power point (MPP) tracking incremental conductance algorithm to maintain a constant dc voltage. The system is examined under various load conditions with MATLAB/Simulink model
State of charge estimation by using extended Kalman filter based on improved open circuit voltage model
Get PDFThis paper focuses on the state of charge estimation (SOC) for battery Li-ion. By modeling a battery based on the equivalent circuit model, the extended Kalman filter approach can be applied to estimate the battery SOC. An electrical battery model is developed in Matlab, Where the structure of the model is detailed by equations and blocks. The battery model has been validated from the experiment results. The comparison shows a good agreement in predicting the voltage, SOC estimation and the model performs better in SOC estimation
Factual power loss reduction by enriched black hole algorithm
Get PDFThis paper presents enriched black hole algorithm (EBHA) for solving optimal reactive power problem. In this work black hole algorithm based on membrane computing is projected. In black hole algorithm evolution of the population is through pushing the candidates in the course of the most excellent candidate in iterations and black hole which swap with those in the search space. Membrane computing is also branded as P system and it has multisets of objects with evolution rules in the membrane structure. Membrane structure is alike ingrained tree of section that demarcate the areas, and root is labelled as skin. Chemical substances (multisets of objects) are there inside the section (membranes) of a cell and the chemical reactions (evolution rules) that take place within the cell. Proposed enriched black hole algorithm (EBHA) has been evaluated in IEEE 14,300 bus test system. Loss reduction achieved
Solving optimal reactive power problem by hurricane search optimization algorithm
Get PDFIn this paper proposed hurricane search optimization (HSO) algorithm is proposed to solve optimal reactive power problem. An upward motion of air is caused due to release of heat which creates a low-pressure zone and by the rotation of the earth that is set into spin. In this spiraling airflow when energy is high then hurricane is created. Projected HSO algorithm design is based on the examination of the horizontal wind structure in a hurricane and how the wind parcels the progression in the neighboring atmosphere. A mixture of wind models has been developed for past few years to Backtesting and to compute hurricane exterior wind fields. Proposed HSO algorithm has been tested in standard IEEE 30, 57bus test systems and simulation results show the projected algorithm reduced the real power loss considerably
Grid integration of PMSG based wind energy conversion with battery storage system
Get PDFIn this paper, the design and implementation of a permanent magnet synchronous generator (PMSG) based wind energy conversion system and battery bank storages are connected to utility grid. It has phase locked loop (PLL) control strategy as it provides for control single-phase grid connected inverter with constant dc-link voltage. The dc-link is interfaced to a permanent magnet synchronous generator through diode bridge rectifier (DBR) with dc-dc boost converter, battery bank and single phase voltage source inverter (VSI). The dc-link voltage is maintained constant value of 48 V by controlling dc-dc converter with help of perturb and observe (P&O) algorithm based maximum power point tracker (MPPT). The VSI output voltage and frequency values are controlled based on grid parameters using PI controller and sinusoidal pulse width modulation (SPWM) technique. In this grid connected system is simulated and performances are analyzed through MATLAB software. The prototype experimental results are verified through 1 kW PMSG, 48 V battery bank with single phase grid connected system
Calculation and measurement of ampacity for class 5 flexible aluminum cable at 110 °C
Get PDFClass 5 flexible aluminum conductors are not common in cable manufacturing industry due to insufficient study on cable joints and connectors. The table of ampacities for aluminum conductors at 110 °C in AS/NZS3008.1.1 standards are also not available as a reference guide for electrical system designers that restricts the installation of aluminum low voltage (LV) cabling system to operate at 90 °C of conductor maximum operating temperature where 110 °C cables are permitted in Australia. In this paper, the cable ampacities of various LV Class 5 flexible aluminum cables at maximum operating temperature of 110 °C are calculated using IEC60287 and AS/NZ3008.1.1 standards. The calculated ampacities from the formula presented in clause 4.4. of AS/NZS3008.1.1 are verified by using the 6kA inductive current generator to determine the suitability for use. The joint temperature between cable and shear bolt mechanical connectors are simultaneoulsy simulated using the calculated ampacities to determine the suitability of mechanical shear bolt connectors when the coefficient of thermal expansion of material is considered. The observed differences between the calculated and measured values demonstrate the relevance of formula used in determining the current ampacity at 110 °C conductor temperature in free air