Baghdad Science Journal
Not a member yet
3064 research outputs found
Sort by
Complete Blood Count and Cinnamic acid activity against Cytoxan in albino mice.
Get PDFThe aim of study to evaluated cinnamic acid and its activity on complete blood count(RBC,WBC,HG,HCV,MCH,MCHC and Plat.)and removed the cytoxan damage which caused bone marrow failure and leukemia and other that due to linked the cytoxan in 7- nitrogen of guanine based of DNA that lead to dead cells. Two concentration from pure cinnamic acid (5.6, 2.8 mg ? mice weight) in first step to choice the perfect concentration in comparison with each negative control ,positive control of cytoxan and the comparison group represent vitamin C. The second step to understand cinnamic acid mechanism activity towards cytoxan by used pre- cytoxan and post – cytoxan in interaction with perfect concentration of cinnamic acid dose (2.8 mg ? mice weight).The analysis showed that cinnamic acid removed each kinds of anemia ,leukemia, bone marrow failure, hypoxia, cancer chemotherapy, hemolytic anemia and hormone erythropoietin from kidney failure in post-cytoxan than pre-cytoxan perfectly ,therefore, cinnamic acid has cure ability and removed cytoxan damage and can give to patient whom used cytoxan in transplanting body part surgeries to a void refused the part for 6 days after transplanting surgeries
Ingots Defects under the influence of Solidification and Freezing Conditions.
No full textThe results of research to reach the conditions that prevents the emergence of primary or secondary voids and achieve worker benefit from molded by almost 100%, which was the situation that cast poured in a mold heated and insulated from all sides to achieve freezing directional full starting from the region remote from the casting and ending then. Has also been compared to the microscopic structure of the resulting castings of various molding conditions, as these conditions have achieved the best sound microscopic structures
'I-V Characteristic and Crystal Structural Of a-As/c-Si Heterojunctions
Get PDFIn this research the a-As flims have been prepared by thermal evaporation with thickness 250 nm and rata of deposition r_d(1.04nm/sec) as function to annealing temperature (373 and 473K), from XRD analysis we can see that the degree of crystalline increase with T_a, and I-V characteristic for dark and illumination shows that forward bias current varieties approximately exponentially with voltage bias. Also we found that the quality factor and saturation current dependence on annealing temperatures
Producing Ceramic Water Purifiers Made Of Iraqi Bentonite Type (Bpl1)
Get PDFIn this study, ceramic purifier (CP) was produced from a mixture of Iraqi raw materials. This ceramic mixture was prepared using Bentonite as a Clay, Porcelanite as a Silica, and Limestone as a flux. The produced ceramic filter was formed by semi-dry compressing method and was fired at 1200 C?.
Physical properties of the produced CP were measured. A hydraulic test rig was constructed to study the hydraulic conductivity of the produced CP. The average hydraulic conductivity of the produced CP was 55 times that of commercial types of ceramic filters.
The mineral composition of the produced ceramics was found by X-Ray tests. Tests results showed that all of the produced ceramics filters composed mainly of low Cristobalte and Tridoymite in addition to some of other minerals.
Both of the raw and the water purified by produced ceramic were tested for a number of water quality parameters. that the ceramic disc purifier could remove, as an average percentages of removal, 99.98% of turbidity, 78.86% of the electrical conductivity , 81.61% of the total dissolved solids, 73.45% of Ca++, 49.69% of Na+, 55.63% of NO3-, 37.54% of HCO3- .
The results showed that CP has excellent adsorption ability for solutes of seven heavy metals, Mn, Fe, Pb, Cd, Co, Cu and Zn, at concentrations of 1 mg/leach and 10 mg/l each. The adsorption capacities of each filter to adsorb seven heavy metals were computed according to Langmuir model and Freundlich models. The results showed variety in adsorption capacities for each heavy metal
Study of Some Physical and Chemical Properties of Staphylolysin Enzyme purified from Pseudomonas aeruginosa
No full textSome of the characters of the Staphylolysin A and D enzymes purified from Pseudomonas aeruginosa P16 and P5 respectively were studied, the molecular weights of Staphylolysin A and D were 20.417 kilo dalton and 23.988 kilo Dalton respectively by SDS- polyacryl amide gel electrophoresis. The optimum pH for staphylolysin A activity was found to be 8 which gives higher activity reaches 150 unit/ml, and for enzyme stability was 7.5-8.5 in which the enzyme nearly retained its full activity, while it was 9.5 for staphylolysin D that gives higher activity of 16 unit/ml,and 8.5-9.5 for enzyme stability in which the enzyme nearly retained its full activity, Maximum activity of two enzymes was obtained at 40C in which the specific activity for staphylolysin A and D were 140 and 16.4 unit/ml, and the two enzymes remained approximately without change at 25-40C for one hour.
When the effects of some materials on Staphylolysin A&D activity were studied, the results showed that both sodium chloride & potassium chloride at 1 & 5 mM had the activator effect on enzymatic activity compared with its control where the staphylolysin A and D retained 105% ,108% and 102%, 104% of their activity respectively when treated with sodium chloride, while they retained 110%, 114% and 133%, 118% of their activity respectively when treated with potassium chloride.
The enzymatic activity for both enzymes were inhibited when treated with ferric , mercury and zinc chloride at variable ratios, Staphylolysin A kept 73% and 7% of its initial activity respectively when treated with 5mM of ferric chloride and mercury chloride respectively and it kept only 9% of its initial activity when treated with 0.1mM Zinc chloride .
Staphylolysin D kept 45% and 13% of it is initial activity respectively when treated with 5mM of ferric chloride and mercury chloride respectively and it kept only 23% of its initial activity when treated with 0.1mM Zinc chloride while enzymatic activity for both enzymes were not affected when treated with EDTA at l0mM and phenyl methyl sulphonyl fluoride (PMSF) at 0.4mM.These results referred to that Staphylolysin A and D are Zn -metallo endopeptidase
Using the molecular methods in detection of antibiotics resistance genes in bacteria of Typhoi (Salmonella typhi)
No full textThis study was carried out for direct detection of typhi and some of its multidrug resistance genes(tem,capt,gyrA&sul2)which encode for resistance to (Ampicillin, Chloramphenicol,Ciprofioxacin,Co-trimoxazole)by using Polymerase Chain Reaction technique .(71)blood samples for people suffering from typhoid fever symptoms depending on the clinical examination and (25)for control were collected.
The results investigation for flic gene which encode for flagellin protein indicated that only (19)with percentage of (26,76%)gave appositive results while all control had a negative ones.
Investigation for antibiotic resistance drug in samples which show positive results for flic gene showed that there is a multidrug for all antibiotics with (94.73%) in patient
Effect of Magnetized Water Treatment on some Biological Aspects for Fresh Water Snail Lymnaea lagotis (Schrank,1803)
No full textExposure assays to magnetized water have so far revealed striking results. The present study was conducted to determine the effects of magnetized water treatment with in different intensities 500 , 1000 and 1500 Gauss on some biological aspects for species of freshwater Gastropod Lymnaea lagotis (Schrank, 1803) which important species in faun of aquatic habitats of Iraq. This species are considered a component of the food chain. The obtained results compared with these species which lived in the river(control). Result of these experiments showed increased significance the shell size (shell high, shell aperture length, shell aperture width and shell width) for L. lagotis with increased intensity magnetized water such as treated water with 1000 Gauss intensity compared with untreated water. Although increase significant was observed to fecundity for snails such as (egg mass dimensions, number and diameter of eggs and survival juveniles) with increased intensity of magnetized water comparative with untreated water
Biosorption of Lead, Cadmium and Nickle from Industrial Wast water by Using Dried Macroalgae
No full textBiosorpion of lead (Pb), Cadmium (Cd) and Nickl(Ni) by dried biomass of Chara sp. for sample of BMP was used as alternative approach of conventional method. The range of removal percentages was between 92-97%, 70-98.7% and 46.6-96.6% for Pb, Cd and Ni respectively at 3h.Treatment time, with 300-500 mg dried weight from Chara sp. powder at pH 4, with 60 rpm at shaker. FTIR analysis showed the active groups which are responsible for sequestration of heavy metals represented by carboxyl, hydroxyl alkyl, amine and amide. The Biosorption equilibrium experiment for elements showed that the highest sorption percentage for three elements was, Pb 96.6% after 30 minute, for Cd was 100% after 15 minute and 40% to Ni after 75 minute, while the biosorption equilibrium by using Chara sp. was at 90 minute for Pb and Ni
The Use of Tea leaves Wastes to reduce Hexavalent Chromium Concentration in industrial Waste Water by Adsorption
Get PDFAbstract : A research was conducted to study the process parameters affecting hexavalent chromium Cr (VI) (carcinogenic compound) the removal percentage from the electrical industries company waste water that contain 88 mg/l of Cr (VI) concentration by adsorption onto tea wastes. Synthetic water with 88 mg/l Cr (VI) concentration was used. Several operation parameters affecting Cr (VI) removal efficiency were investigated, such as pH, initial Cr (VI) concentration, stirring time and tea wastes dose. The experimental results reveal that maximum Cr (VI) removal reached up to 94.26% at pH of 2, stirring time of 180 minute, tea wastes dose of 8gm/100 ml and the equilibrium was attained at 180 minute. Langmuir and Freundlich adsorption isotherm models were analyzed and the experimental results fit very well with Freundlich model
Improvement of thermostable productivity ?-amylase from local isolate Bacillus licheniformis H14.
No full text(28)Bacterial local isolates of Bacillus sp. were obtained from soil samples. Isolates were tested for thermostable alpha- amylase production on solid media; fifteen isolates were able to develop clear zone around the bacterial growth after floating the plates with iodine reagent (Lugol's solution). There were further tested in submerged culture which led to selection of Bacillus sp. H14since it was the most efficient .Microbial and biochemical tests showed that the local isolate Bacillus sp.H14was refered to the species B.licheniformis that signed as H14 was refered to the species B.licheniformis H14 .,To get ahigher yield of alpha – amylase(48.70unit/mg protein) production from the local isolate B.licheniformis H14 . This study used different mutation ways such as physical way by using the physical mutagen (ultraviolet light) and chemical way by using the chemical mutagen (nitrosoguanidine). Physical mutation results showed that the local isolate B.licheniformis HM14 get higher yield of alpha – amylase production(102.10 unit/mg protein) according to killing percentage (90%) while the chemical mutation results showed that the local isolate B.licheniformis HM4 get higher yield of alpha –amylase production(100.94 unit/mg protein) from the two mutant local isolates (HM14 and HM4)were the best carbon source starch (1.5%), peptone (1.5%) as nitrogen source, calcium chloride (0.02%), sodium chloride (0.05%), magnicium phosphate (0.05%), sodium di –hydrogen phosphate (0.16%), at initial pH (5) and inoculum size 1*108 cfu/ml at (50?C) For (72) hours, using shaking incubator at (150) rpm