Iranian Journal of Health, Safety and Environment (IJHSE)
Not a member yet
218 research outputs found
Sort by
The survey of electrocoagulation Process for removal dye Reactive Orange 16 from aqueous solutions using sacrificial iron electrodes
Get PDFABSTRACT
Discharge of textile industries colored wastewaters without enough treatment into natural water supplies cause serious damages to the environment. This study was performed to investigate the effect of electrocoagulation for dye removal from synthetic wastewater using iron electrodes. Removal of dye reactive orange 16 (RO16) by electrocoagulation using iron electrode was conducted in a batch reactor with volume 1 liter. The effect of operating parameters such as current density, initial concentration of dye, pH and contact time was studied and the electrical energy consumption was calculated. The maximum efficiency of hardness removal which was obtained in current density of 20mA/cm2, optimum concentration 50mg L-1, optimum pH 5.5, reaction time of 30 min and NaCL concentration 1.5g/l are equal to 99.27%. Also COD removal efficiency is increased to 66%. Results show, electrocoagulation process by iron electrode is an effective method for reactive dye removal from colored wastewater
Thermal, physiological strain index and perceptual responses in Iranian Muslim women under Thermal Condition in order to Guide in Prevention of Heat Stress
No full textHeat stress risk assessment, as a harmful agent at workplace, is essential for controlling heat strain. The purpose of this study was relation between physiological and perceptual heat strain responses in Iranian veiled women under laboratory thermal conditions.
This experimental study was carried out on 36 healthy females (age 22.3 ± 2.0 yr, height 162.76±5. 57cm, weight 55.82 ± 9.27kg) in sitting state under thermal conditions (27 - 38° C) in the hot-dry climatic condition for 120 min. In order to calculate the physiological strain index (PSI), oral temperature and heart rate were measured every 5 min. Physiological factors, and Heat Strain Score Index (HSSI) questionnaires are simultaneous measurements taken at any 5 min during the exposure and physiological factors, and Heat Strain Score Index (HSSI) questionnaires are the initial measurements.
The data were analyzed using correlation and line regression by test spss16.
The results showed that the average heart rate and oral temperature at resting and sitting were between 83.06 ±9.41bpm, 87.91 ±7.87 bpm and 36.7° C, 37. 1° C respectively. Also, the results have revealed a direct and significant and direct correlation among HSSI with WBGT (R2 = 0.97, P< 0.001), PSI (R2 = 0.96, P< 0.001), oral temperature (R2 = 0.96, P< 0.001) and heart rate (R2 = 0.62, P< 0.01) indices.
The results have shown that simultaneously with the increase in valid indices of heat stress evaluation such as WBGT and PSI indices, the amount of HSSI index has also increased with high power. Therefore, it can be conclude that when there is no access to a reliable heat stress method such as WBGT or PSI indices, HSSI index, an objective and subjective heat strain method, can be used as a simple, fast and inexpensive method for evaluating the heat strain in women
Determination of Safety Integrity Level (SIL) using LOPA method in the Emergency Shutdown system (ESD) of Hydrogen unit.
Get PDFPetrochemical plants are high risk, high parameter, and high-energy units, with the potential risks of fire, explosion and poisoning. The severe accidents at Bhopal, Mexico City, Samton, Brazil, Panipat, Mumbai and many others have increased the public awareness of the health, property and environmental risks posed by chemical installations. The recent years have seen a convergence of scenario-based Hazard and Operability (HAZOP) studies, Layer of Protection Analyses (LOPAs), and Safety Integrity Level (SIL) determinations. The aim of the research was to study the hazardous scenario identified in the hydrogen unit of petrochemical plant and to determine the SIL for ESD system. 20 hazardous scenarios identified by HAZOP study and determined by SIL by applying the LOPA method for ESD system, were used to control the hazardous scenarios. KS-1, KS-2 and KS-3are three ESD systems applied in the hydrogen unit. The maximum SIL determined for ESD system was SIL3. Since the rise in SIL can be quite costly for the industry, adding other layers of protection can reduce the level of SIL for ESD (SIS)
Evaluation of sustainable development using business excellence model in used motor oil industries
Get PDFBusiness and commerce are a chance to create wealth and economic development in companies and industries. Leader of companies must be containing a sense of relief and hope as one of the factors of production and wealth to enhance trust, cooperation between the organization and the community. In order to achieve at the Business Excellence (BE) is emphasized to the need for the simultaneous measurement of organizational performance on the Critical Success Factors (CSFs), environmental, social issues and challenges. Objective of current study was to evaluate of sustainable development in used motor oil industry using BE models. Therefore, a framework was discussed as distinct from other common practices to measure performance of an industry. The models allow multi -dimensional focuses on different indicators of the organization's internal, external and CSFs. The check list method was used to collect data in site of industry in the present study. Then, obtained results were surveyed by models such as the Malcolm Baldrige National Quality Award (MBNQA), European Federation for Quality Management (EFQM) and Kanji’s Business Excellence Model (KBEM). Results of current analyze indicated that despite the fact that these models and approaches are different, but they are same in term of shared concepts. Finally, we can be able to say that the simultaneous implementation of these models and approaches can be a suitable process in the study of sustainable development of organizations. According to the obtained results of models, the case study industry was in sustainable development conditions
Optimization of pyrene removal from contaminated soil by electrokinetic remediation process
Get PDFABSTRACT
The electrokinetic remediation process has been intensively investigated by many researchers as a novel technique to remove different pollutants from soil. The process utilizes a direct-current electric field to soils to insert some process such as electroosmosis and electrolytic migration. In the present study, the removal of pyrene as a model of polycyclic aromatic hydrocarbons (PAHs) were optimized using response surface methodology (RSM) based on central composite design (CCD). The electrokinetic experiment was performed using an electrokinetic setup that includes an electric power supply, a plexiglass soil box and two square stainless steel electrodes electrodes. In the optimum condition, electrode type, moisture and voltage were determined as stainless steel, 30% and 12 volt, respectively. Pyrene removal efficiency in optimum condition estimated 80.05 %. Analysis of variance (ANOVA) exhibited a reasonable correlation coefficient between the predicted and experimental values (R2=0.95).These results showed that electrokinetic remediation process could be applied as an efficient technique for pyrene removal
Removal of reactive dyes from aqueous solutions by a non-conventional and low cost agricultural waste: adsorption on ash of Aloe Vera plant
Get PDFDyes are an important class of pollutants and disposal of them in precious water resources must be avoided. Among various methods adsorption occupies a prominent place in dye removal. The aim of this study is to evaluate adsorption of dye Reactive Red 198 and Blue 19 (RR-198 & RB-19 (on to Aloe Vera plant ash from aqueous solutions.
In this research Aloe Vera ash was prepared at laboratory conditions and then after shredding, screened by ASTM standard sieve with 60 -200 mesh sizes and the effects of pH (3-12), adsorbent dose (0.1-1 g/L), contact time (10-60 min), initial dye concentration (10-160 mg/L) and temperature were investigated in the experiment. In different samples Dye concentration was measured by spectrophotometer at 592 nm and 520 nm wavelength for RR198 and RB19 respectively. Also the Langmuir and Freundlich adsorption isotherms were determined in order to describe the relations between the colored solutions and the adsorbent.
The results of this study showed that acidic conditions were more conducive to enhance the hydrolysis rate than basic ones as the decomposition was optimum at pH 3. The adsorption rate of RR-198 and RB-19 dyes was increased by increasing of initial dye concentration, increasing of adsorbent dose in 0.1 to 0.4 mg/L. Dye solution was decolorized in a relatively short time (20 min). The efficiencies for RR-198 and RB- 19 reactive dyes were 82.68% and 90.42% respectively. The maximum adsorption capacity (qmax) has been found to be 80.152 mg/g for RR-198 reactive dye and 88.452 mg/g for Blue 19 reactive dye. Adsorption isotherms were examined by Freundlich and Langmuir isotherm that finally showed the Freundlich multilayer isotherm has better accordance with dates.
The results indicate that Aloe Vera ash plant as a natural and inexpensive adsorbent is a suitable adsorbent for the adsorption of textile dyes
The Prevalence of Needle sticks injuries among health care workers at a hospital in Tehran
Get PDFABSTRACT
Needle stick injuries (NSIs) are one of the most significant and preventable hazards in relation to Healthcare workers (HCWs). Such injuries have been shown to be of high prevalence within developing countries. To determine the prevalence and circumstances pertaining to the occurrence of NSIs among HCWs employed at a special hospital. The study conducted was a cross-sectional study on HCWs and was carried out in one of Tehran's special hospitals in the year 2012. In this study, in order to identify and determine hazardous potential due to needle stick, HFMEA method was chosen. This resulted in the collection of 240 valid and reliable questionnaires. The validity and reliable nature of the questionnaires was confirmed by experts and by means of the test re-test method. The gathered data was analyzed with SPSS software, version 16.From the analysis of the data it was shown that, a total of 97 (40.42%) HCWs had suffered NSIs in the last year. The patient ward showed the highest prevalence of NSIs (47.42%) in the hospital. Nurses had the highest risk of suffering NSIs (56.7%) in comparison with the other occupational groups. All in all 175 NSIs occurred for the 240 HCWs trialed during the selected period of clinical practice. Of those that received injuries, only roughly 1 in 3 (38.14%) reported it to their infection control officer. Just over a quarter (26.80%) of the injured HCWs used post exposure prophylaxis (PEP) against HIV. Almost all (88.75%) of the HCWs had received a safe injection course. In general, NSIs and their subsequent underreporting are commonplace among hospital healthcare professionals. Significantly, more than two-thirds of the injured HCWs did not use post-exposure prophylaxis (PEP) against HIV. Improved prevention and reporting strategies are needed if the occupational health and safety of healthcare workers is to improve
The study of Influencing Maintenance Factors on Failures of Two gypsum Kilns by Failure Modes and Effects Analysis (FMEA)
Get PDFDeveloping technology and using equipment in Iranian industries caused that maintenance system would be more important to use. Using proper management techniques not only increase the performance of production system but also reduce the failures and costs. The aim of this study was to determine the quality of maintenance system and the effects of its components on failures of kilns in two gypsum production companies using Failure Modes and Effects Analysis (FMEA). Furthermore the costs of failures were studied.
After the study of gypsum production steps in the factories, FMEA was conducted by the determination of analysis insight, information gathering, making list of kilns’ component and filling up the FMEA’s tables. The effects of failures on production, how to fail, failure rate, failure severity, and control measures were studied. The evaluation of maintenance system was studied by a check list including questions related to system components. The costs of failures were determined by refer in accounting notebooks and interview with the head of accounting department.
It was found the total qualities of maintenance system in NO.1 was more than NO.2 but because of lower quality of NO.1’s kiln design, number of failures and their costs were more. In addition it was determined that repair costs in NO.2’s kiln were about one third of NO.1’s. The low severity failures caused the most costs in comparison to the moderate and low ones.
The technical characteristics of kilns were appeared to be the most important factors in reducing of failures and costs
Autohydrogenotrophic denitrification by a bioelectrochemical process: A viability study
No full textABSTRACT
In this study, viability of the autotrophic bacteria was investigated in a denitrification process. Bench-scale bioelectrochemical denitrification with separated chambers reactor were applied for nitrate reduction from synthetic wastewater. The influences of current density, retention time, mixing on viability of autotrophic denitrifying bacteria were investigated in the bioelectrochemical reactor (BER). It was found that by increasing the current density up to 8 mA/cm2, nitrate reduction rate was increased. At higher current density (24 - 32 mA/cm2), denitrification rate due to excess of hydrogen gas on cathode surface and accumulation of nitrite, was decreased. Low current density
Occupational Noise Pollution and Hearing protection in selected industries
Get PDFABSTRACT
The use of technology in industries is ever increasing. With the introduction of this technology come new safety and human performance concerns. Hearing loss caused by industrial noise has been recognized for many years, and protection of employee hearing has been made mandatory by governmental agencies. This paper presents an investigation of occupational noise exposure and Personal hearing protective devices (PHPD) in selected industries in the south-eastern Iran. A questionnaire has been used to collect data for workers with high noise exposure and Personal hearing protective devices (PHPD). The subjects were 354 industrial workers expose to noise pressure levels greater than the action level defined in Iranian legislation (85dB (A) 8h/d. The results of this study indicated that only younger workers with minor professional experience and with high educational background are used PHPD to protect and preserve their hearing. The finding of this study shows that approximately 75% of the workers with age 18-36 reported the use of personal protective Devices at all the time, and 73% of workers with age more than 46 years old reported that they had never used them PHPD, even though it was mandatory in their workplaces. Statistical data show that, the percentage of male workers (82) with age more than 37 years old having headaches at workplace are higher than female (3.4) with the same age groups. A noise training and education program must be developed for industrial employees in order to protect them from hazardous noise pollution. Employers must play an important role in promoting the regular use of Personal hearing protective devices. Noise level in work areas must be considered in the early design of Hearing Conservation Program