1,720,996 research outputs found
Data from: Palaeoecological implications of the preservation potential of soft-bodied organisms in sediment-density flows: testing turbulent waters
No full textInterpreting how far organisms within fossil assemblages may have been transported and if they all originated from the same location is fundamental to understanding whether they represent true palaeocommunities. In a three-factorial experimental design, we used an annular flume to generate actualistic sandy sediment-density flows that were fast (2 ms−1) and fully turbulent in order to test the effects of flow duration, sediment concentration, and grain angularity on the states of bodily damage experienced by the freshly euthanized polychaete Alitta virens. Results identified statistically significant effects of flow duration and grain angularity. Increasing sediment concentration had a statistically significant effect with angular sediment but not with rounded sediment. Our experiments demonstrate that if soft-bodied organisms such as polychaetes were alive and then killed by a flow then they would have been capable of enduring prolonged transport in fast and turbulent flows with little damage. Dependent upon sediment concentration and grain angularity, specimens were capable of remaining intact over flow durations of between 5 and 180 min, equating to transport distances up to 21.6 km. This result has significant palaeoecological implications for fossil lagerstätten preserved in deposits of sediment-density flows because the organisms present may have been transported over substantial distances and therefore may not represent true palaeocommunities.,Table of experimental trials with recorded states of bodily damageExperimental combinations of flow duration, sediment concentration and grain angularity with corresponding recorded states of bodily damage.Table of raw data.docx</span
Palaeoecological implications of the preservation potential of soft-bodied organisms in sediment-density flows: testing turbulent waters
No full textInterpreting how far organisms within fossil assemblages may have been transported and if they all originated from the same location is fundamental to understanding whether they represent true palaeocommunities. In a three-factorial experimental design, we used an annular flume to generate actualistic sandy sediment-density flows that were fast (2 ms−1) and fully turbulent in order to test the effects of flow duration, sediment concentration, and grain angularity on the states of bodily damage experienced by the freshly euthanized polychaete Alitta virens. Results identified statistically significant effects of flow duration and grain angularity. Increasing sediment concentration had a statistically significant effect with angular sediment but not with rounded sediment. Our experiments demonstrate that if soft-bodied organisms such as polychaetes were alive and then killed by a flow then they would have been capable of enduring prolonged transport in fast and turbulent flows with little damage. Dependent upon sediment concentration and grain angularity, specimens were capable of remaining intact over flow durations of between 5 and 180 min, equating to transport distances up to 21.6 km. This result has significant palaeoecological implications for fossil lagerstätten preserved in deposits of sediment-density flows because the organisms present may have been transported over substantial distances and therefore may not represent true palaeocommunities
Deposits of flows transitional between turbidity current and debris flow
No full textThe relationship between submarine sediment gravity flows and the character of their deposits is poorly understood. Annular flume experiments were used to investigate the depositional dynamics and deposits of waning sediment-laden flows. Decelerating fast (>3 m/s) flows with fixed sand content (10 vol%) and variable mud content (0–17 vol%) resulted in only four deposit types. Clean sand with a mud cap that resembled a turbidity current deposit (turbidite) formed if the flow was turbulent when deposition began, or if the muddy fluid had insufficient strength to suspend the sand. The clean sand could contain structures if mud content was low (<6%) and the deceleration period was >300 s. Ungraded muddy sand with a mud cap that resembled a debris-flow deposit (debrite) formed if the flow became laminar before sand could deposit. Clean sand overlain by ungraded muddy sand and a mud cap formed either from a transitional flow or by late-stage settling of sand from a muddy suspension. These deposits resemble enigmatic submarine flow deposits called linked debrite-turbidites. The experiments provide a basis for inferring flow type from deposit character for submarine sediment-laden flows. <br/
Deposit structure and processes of sand deposition from a decelerating sediment suspension
No full textTurbidity currents are notoriously difficult to monitor directly, therefore interpretation of their deposits forms the basis for much of our understanding of these flows. The deceleration rate of a flow is a potentially important yet poorly understood control on depositional processes. A series of experiments were conducted in an annular flume, in which fast (up to 3.5 m/s) and highly turbulent flows of sand (up to 250 µm) and water were decelerated at different rates and processes of deposition and deposit character analyzed. Previously poorly documented depositional processes were observed in the experiments. This is because the flows were initially unusually fast and of prolonged duration, with sustained periods of sediment fallout as the flow slowed down. The conditions in these flows are thus likely to be closer to those at the base of a waning turbidity current than is achieved in other relatively slow experimental flows. The collapse of high-concentration, moving, thin (< 5 mm) near-bed layers (laminar sheared layers) were an important mechanism by which the bed aggraded beneath these unsteady flows. At bed aggradation rates in excess of 0.44 mm/s the sequential collapse of laminar sheared layers produced a structureless, poorly graded and poorly sorted deposit (Bouma Ta). When bed aggradation rates fell below 0.44 mm/s the collapsing laminar sheared layers were reworked by turbulence to form planar laminae (Bouma Tb). These laminae are formed in a very different manner than the planar laminae attributed to bedwaves in previous open-channel flow experiments. Collapse of laminar sheared layers is therefore an alternative process for generating the Bouma Tb division. Inverse grading developed at the base of the deposits of slowly decelerated flows. This inverse grading was probably a result of grain sorting in a high-concentration layer that persisted at the base of the flow for many minutes prior to the onset of deposition. <br/
Mud-clast armoring and its implications for turbidite systems
Get PDFSeafloor sediment density flows are the primary mechanism for transporting sediment to the deep sea. These flows are important because they pose a hazard to seafloor infrastructure and deposit the largest sediment accumulations on Earth. The cohesive sediment content of a flow (i.e., clay) is an important control on its rheological state (e.g., turbulent or laminar); however, how clay becomes incorporated into a flow is poorly understood. One mechanism is by the abrasion of (clay-rich) mud clasts. Such clasts are common in deep-water deposits, often thought to have traveled over large (more than tens of kilometers) distances. These long travel distances are at odds with previous experimental work that suggests that mud clasts should disintegrate rapidly through abrasion. To address this apparent contradiction, we conduct laboratory experiments using a counter rotating annular flume to simulate clast transport in sediment density flows. We find that as clay clasts roll along a sandy floor, surficial armoring develops and reduces clast abrasion and thus enhances travel distance. For the first time we show armoring to be a process of renewal and replenishment, rather than forming a permanent layer. As armoring reduces the rate of clast abrasion, it delays the release of clay into the parent flow, which can therefore delay flow transformation from turbidity current to debris flow. We conclude that armored mud clasts can form only within a sandy turbidity current; hence where armored clasts are found in debrite deposits, the parent flow must have undergone flow transformation farther up slope
Going Beyond Counting First Authors in Author Co-citation Analysis
Get PDFThe present study examines one of the fundamental aspects of author co-citation analysis (ACA) - the way co-citation
counts are defined. Co-citation counting provides the data on which all subsequent statistical analyses and mappings
are based, and we compare ACA results based on two different types of co-citation counting - the traditional type that
only counts the first one among a cited work's authors on the one hand and a non-traditional type that takes into
account the first 5 authors of a cited work on the other hand. Results indicate that the picture produced through this non-traditional author co-citation counting contains more coherent author groups and is therefore considerably clearer. However, this picture represents fewer specialties in the research field being studied than that produced through the traditional first-author co-citation counting when the same number of top-ranked authors is selected and analyzed. Reasons for these effects are discussed
Current-aligned dewatering sheets and ‘enhanced’ primary current lineation in turbidite sandstones of the Marnoso-arenacea Formation
Get PDFTurbidite sandstones of the Miocene Marnoso-arenacea Formation (northern Apennines, Italy) display centimetre to decimetre long, straight to gently curved, 0.5 to 2.0 cm regularly spaced lineations on depositional (stratification) planes. Sometimes these lineations are the planform expression of sheet structures seen as millimetre to centimetre long vertical ‘pillars’ in profile. Both occur in the middle and upper parts of medium-grained and fine-grained sandstone beds composed of crude to well-defined stratified facies (including corrugated, hummocky-like, convolute, dish-structured and dune stratification) and are aligned sub-parallel to palaeoflow direction as determined from sole marks often in the same beds. Outcrops lack a tectonic-related fabric and therefore these structures may be confidently interpreted to be sedimentary in origin. Lineations resemble primary current lineation formed by the action of turbulence during bedload transport under upper stage plane bed conditions. However, they typically display a larger spacing and micro-topography compared to classic primary current lineation and are not associated with planar-parallel, finely-laminated sandstones. This type of ‘enhanced lineation’ is interpreted to develop by the same process as primary current lineation, but under relatively high near-bed sediment concentrations and suspended load fallout rates, as supported by laboratory experiments and host facies characteristics. Sheets are interpreted to be dewatering structures and their alignment to palaeoflow (only noted in several other outcrops previously) inferred to be a function of vertical water-escape following the primary depositional grain fabric. For the Marnoso-arenacea beds, sheet orientation may be genetically linked to the enhanced primary current lineation structures. Current-aligned lineation and sheet structures can be used as palaeoflow indicators, although the directional significance of sheets needs to be independently confirmed. These indicators also aid the interpretation of dewatered sandstones, suggesting sedimentation under a traction-dominated depositional flow – with a discrete interface between the aggrading deposit and the flow – as opposed to under higher-concentration grain or hindered settling dominated regimes
Variations on the Author
Get PDF“Variations on the Author” discusses two of Eduardo Coutinho’s recent films (Um Dia na Vida, from 2010, and Últimas Conversas, posthumously released in 2015) and their contribution to the general question of documentary authorship. The director’s filmography is characterized by a consistent yet self-effacing form of authorial self-inscription: Coutinho often features as an interviewer that rather than express opinions propels discourses; an interviewer that is good at listening. This mode of self-inscription characterizes him as an author who is not expressive but who is nonetheless markedly present on the screen. In Um Dia na Vida, however, Coutinho is completely absent form the image, while Últimas Conversas, on the contrary, includes a confessional prologue that moves the director from the margins to the center of his films. This article examines the ways in which these works stand out in the filmography of a director who offers new insights into the notion of cinematic authorship
Appropriate Similarity Measures for Author Cocitation Analysis
Get PDFWe provide a number of new insights into the methodological discussion about author cocitation analysis. We first argue that the use of the Pearson correlation for measuring the similarity between authors’ cocitation profiles is not very satisfactory. We then discuss what kind of similarity measures may be used as an alternative to the Pearson correlation. We consider three similarity measures in particular. One is the well-known cosine. The other two similarity measures have not been used before in the bibliometric literature. Finally, we show by means of an example that our findings have a high practical relevance.information science;Pearson correlation;cosine;similarity measure;author cocitation analysis
- …
