1,720,964 research outputs found
1.3 µm dissipative soliton resonance generation in Bismuth doped fiber laser
No full textIn this work, a Figure-9 (F9) bismuth-doped fiber laser (BiDFL) operating in the dissipative soliton resonance (DSR) regime is presented. The 1338 nm laser used a BiDF as the active gain medium, while a nonlinear amplifying loop mirror (NALM) in an F9 configuration was employed to obtain high energy mode-locked pulses. The wave breaking-free rectangular pulse widened significantly in the time domain with the increase of the pump power while maintaining an almost constant peak power of 0.6 W. At the maximum pump power, the mode-locked laser delivered a rectangular-shaped pulse with a duration of 48 ns, repetition rate of 362 kHz and a radio-frequency signal-to-noise ratio of more than 60 dB. The maximum output power was recorded at around 11 mW with a corresponding pulse energy of 30 nJ. This is, to the best of the author’s knowledge, the highest mode-locked pulse energy obtained at 1.3 μm as well as the demonstration of an NALM BiDFL in a F9 configuration.</p
Multi-wavelength Bismuth-doped fiber laser in 1.3 µm based on a compact two-mode fiber filter
No full textIn this work, a multi-wavelength Bismuth-doped fiber laser (MWLBDFL) operating in the 1.3 µm wavelength region is presented and experimentally demonstrated. The MWLBDFL leveraged on a 60 m Bismuth-doped fiber as an active gain medium, a compact two-mode fiber filter (TMFF) as a comb filter and a 2 km single-mode fiber section to induce four-wave mixing in the system. By optimising the polarization controller, the MWLBDFL generated 18 stable lasing output channels within 10 dB from the highest lasing line and a reasonably flat spectrum over a range of 11 nm. The stability of the MWLBDFL tested for a 150-minute duration showed a peak power fluctuation of less than 1 dB with a negligible wavelength drift. The extinction ratio of the TMFF was approximately 8.6 dB while the highest and lowest optical-signal-to-noise ratios (OSNRs) of the MWLBDFL were ~ 55 dB and ~ 50 dB, respectively. To the best of the author's knowledge, the proposed MWLBDFL demonstrates the highest number of output channels compared to other MWLs operating in the same wavelength region.</p
1.3 μm passively Q-Switched bismuth doped fiber laser using Nb<sub>2</sub>C saturable absorber
No full textA tunable passively Q-switched fiber laser operating at 1.3 μm was demonstrated using bismuth-doped fiber (BDF) as the gain medium and using niobium carbide (Nb2C) as the saturable absorber (SA). The Nb2C was prepared using the solution casting method, and then fabricated into a film form for ease of integration into the laser cavity. Stable Q-switched pulses were observed as the pump power was increased from 820 to 1037 mW, generating pulses with increasing repetition rates from 10.1 kHz to 13.8 kHz and decreasing pulse widths from 17.54 to 7.58 μs. The all-fiber laser had a center wavelength at 1314 nm with a broad 3-dB bandwidth of 8.35 nm. The maximum output power and pulse energy of the Q-switched laser were 0.74 mW and 53.7 nJ, respectively. The laser was stable when tested for its long-term stability, where the peak frequency remained consistent at 13.8 kHz and the SNRs were maintained to be more than 60 dB throughout the entire test period. To the best of our knowledge, this is the first demonstration for a passively Q-switched fiber laser operating at 1.3 μm wavelength region using BDF as the gain medium
Going Beyond Counting First Authors in Author Co-citation Analysis
Full text linkThe present study examines one of the fundamental aspects of author co-citation analysis (ACA) - the way co-citation
counts are defined. Co-citation counting provides the data on which all subsequent statistical analyses and mappings
are based, and we compare ACA results based on two different types of co-citation counting - the traditional type that
only counts the first one among a cited work's authors on the one hand and a non-traditional type that takes into
account the first 5 authors of a cited work on the other hand. Results indicate that the picture produced through this non-traditional author co-citation counting contains more coherent author groups and is therefore considerably clearer. However, this picture represents fewer specialties in the research field being studied than that produced through the traditional first-author co-citation counting when the same number of top-ranked authors is selected and analyzed. Reasons for these effects are discussed
Variations on the Author
Full text link“Variations on the Author” discusses two of Eduardo Coutinho’s recent films (Um Dia na Vida, from 2010, and Últimas Conversas, posthumously released in 2015) and their contribution to the general question of documentary authorship. The director’s filmography is characterized by a consistent yet self-effacing form of authorial self-inscription: Coutinho often features as an interviewer that rather than express opinions propels discourses; an interviewer that is good at listening. This mode of self-inscription characterizes him as an author who is not expressive but who is nonetheless markedly present on the screen. In Um Dia na Vida, however, Coutinho is completely absent form the image, while Últimas Conversas, on the contrary, includes a confessional prologue that moves the director from the margins to the center of his films. This article examines the ways in which these works stand out in the filmography of a director who offers new insights into the notion of cinematic authorship
Appropriate Similarity Measures for Author Cocitation Analysis
Full text linkWe provide a number of new insights into the methodological discussion about author cocitation analysis. We first argue that the use of the Pearson correlation for measuring the similarity between authors’ cocitation profiles is not very satisfactory. We then discuss what kind of similarity measures may be used as an alternative to the Pearson correlation. We consider three similarity measures in particular. One is the well-known cosine. The other two similarity measures have not been used before in the bibliometric literature. Finally, we show by means of an example that our findings have a high practical relevance.information science;Pearson correlation;cosine;similarity measure;author cocitation analysis
Dispelling the Myths Behind First-author Citation Counts
Full text linkWe conducted a full-scale evaluative citation analysis study of scholars in the XML research field to explore just how different from each other author rankings resulting from different citation counting methods actually are, and to demonstrate the capability of emerging data and tools on the Web in supporting more realistic citation counting methods. Our results contest some common arguments for the continued
use of first-author citation counts in the evaluation of scholars, such as high correlations between author rankings by first-author citation counts and other citation
counting methods, and high costs of using more realistic citation counting methods that are not well-supported by the ISI databases. It is argued that increasingly available digital full text research papers make it possible for citation analysis studies to go beyond what the ISI databases have directly supported and to employ more
sophisticated methods
koamabayili/VECTRON-author-checklist: VECTRON author checklist
No full textWe have done our best to complete the author checklist relating to the use of animals in the hut study. Note that the objective for the hut study was to evaluate the IRS treatment applications for residual efficacy against Anopheles mosquitoes, including the local An. coluzzii mosquito population. Cows were only used to attract mosquitoes into the huts and no tests were carried out directly on the cows. The author checklist is intended for use with studies where experiments are carried out on animals, which is why we have had such difficulty in completing this for the hut study, as many of the questions do not relate to how the cows were used
- …
