300 research outputs found
Embedding spanning subgraphs into large dense graphs
No full textIn this thesis we are going to present some results on embedding spanning subgraphs into large dense graphs. Spanning Trees Bollob'as conjectured that if is a graph on vertices, for some , and is a bounded degree tree on vertices, then is a subgraph of . The problem was solved in the affirmative by Koml'os, S'ark"ozy and Szemer'edi for large graphs. They then strengthened their result, and showed that the maximum degree of need not be bounded: there exists a constant such that is a subgraph of if , and is large. Both proofs are based on the Regularity Lemma-Blow-up Lemma Method. Recently, using other methods, it was shown that bounded degree trees embed into graphs with minimum degree , where is a constant depending on the maximum degree of . Here we show that in general is sufficient for every . We also show that this bound is tight for the two extreme values of i.e. when and when . Powers of Hamiltonian Cycles In 1962 P'osa conjectured that if then contains the square of a Hamiltonian cycle. Later, in 1974, Seymour generalized this conjecture: if then contains the th power of a Hamiltonian cycle. In 1998 the conjecture was proved by Koml'os, S'ark"ozy and Szemer'edi for large graphs using the Regularity Lemma. We present a ``deregularised" proof of the P'osa-Seymour conjecture which results in a much lower threshold value for , the size of the graph for which the conjecture is true. We hope that the tools used in this proof will push down the threshold value for to around 100 at which point we will be able to verify the conjecture for every .Ph.D.Includes bibliographical referencesIncludes vitaby Asif Jamshe
Prevalence of Postpartum Depression and its Risk Factors among Pakistani Females
No full textAbstract
Objective: To determine the prevalence of postpartum depression and its risk factors among Pakistani mothers. Methodology: This Cross-sectional study was conducted after ethical approval on a sample of 200 females of reproductive age (20-45years). Participants were selected through convenient random sampling on the basis of predefined eligibility criteria. Data were collected from primary and secondary healthcare facilities of district Sialkot using the Edinburg postnatal depression screening tool. Results: The mean age ±Std Dev of the participants was 28.09±5.346 years ranging from 20 to 45. The mean ±SD of the total score EPDS was found to be 3.53±5.72 with 87.50% of participants with scores below 13. Out of 200, 25(12.50%) females were candidates for postpartum depression. Conclusion: Postpartum depression screening helps recognition of the disorder. Postpartum depression among females of the target population is not negligibl
Prediction of particle concentration profiles in binary-solid liquid fluidized bed
No full textA simple mixing rule is presented here to predict the concentration profile of individual particle species in a binary-solid liquid fluidized bed from the information about the total solid concentration in the bed. Using the experimental data available in the literature, the applicability of this approach is demonstrated for the presence of different size particles in the bed. For the case of binary-solid fluidized bed showing layer inversion behavior, this simple mixing rule is capable of predicting the concentration of two species from the total solid concentration data of the bed.Corresponding Author:
Dr. Mohammad Asif, Professor
Department of Chemical Engineering, College of Engineering, King Saud University,
P.O. Box 800, Riyadh-11421, Saudi Arabia.
Email: [email protected]
Semantic Question Classification Datasets
No full textThis is the datasets used in the following paper:Can Taxonomy Help? Improving Semantic Question Matching using Question TaxonomyPaper: http://aclweb.org/anthology/C18-1042If you use the dataset please cite the following paper:@InProceedings{C18-1042,
author = "Gupta, Deepak
and Pujari, Rajkumar
and Ekbal, Asif
and Bhattacharyya, Pushpak
and Maitra, Anutosh
and Jain, Tom
and Sengupta, Shubhashis",
title = "Can Taxonomy Help? Improving Semantic Question Matching using Question Taxonomy",
booktitle = "Proceedings of the 27th International Conference on Computational Linguistics",
year = "2018",
publisher = "Association for Computational Linguistics",
pages = "499--513",
location = "Santa Fe, New Mexico, USA",
url = "http://aclweb.org/anthology/C18-1042"
}
</div
Recommended from our members
Human Rights Law in Egypt and Malaysia: Freedom of Religion and Expression, Volume 1 /
No full textThe discourse surrounding freedom of religion and expression in Muslim-majority countries is complex and multifaceted, shaped by a myriad of factors including cultural, political, and legal dynamics. This volume examines the complex interplay of these factors within the contexts of Egypt and Malaysia, offering valuable insights into the challenges and advancements in safeguarding these fundamental freedoms. From the diverse interpretations of Islamic principles to the varying legal frameworks and the influence of global events, such as geopolitical conflicts and terrorism, on human rights dynamics, this volume provides a comprehensive exploration of the complexities involved. Moreover, it delves into the historical, social, and political contexts that shape the protection and limitation of these freedoms, offering a nuanced understanding of the evolving discourse surrounding human rights in Muslim-majority countries. Through comparative analyses and discussions on the role of civil society and advocacy groups, this volume serves as an invaluable resource for scholars, policymakers, and activists seeking to deepen their understanding of the multifaceted realm of freedom of religion and expression in Egypt and Malaysia. Asif Mohiuddin is a Lecturer in the Department of Moral Studies, Civics and Character Building at the Faculty of Human Sciences, Sultan Idris Education University, Malaysia. Previously, he worked as a Postdoctoral Academic Officer at the same institution. He is the author of the book "Navigating Religious Authority in Muslim Societies: Islamist Movements and the Challenge of Globalisation" (Palgrave Macmillan, 2023). From 2021 to 2022, he served as a Post-Doctoral Fellow in the Faculty of Theology at Sakarya University, Turkey. Before joining Sakarya University, he was a Lecturer in the Department of Higher Education, Government of Jammu and Kashmir, India. He earned his PhD from the University of Kashmir in 2018. His research interests include globalisation and Islam, the intersection between politics and religion in the Middle East, human rights law, Islam and the West, and Muslim minorities in multicultural societies (Europe and South Asia)
Prediction of tool temperature during machining of Ti-6Al-4V alloy with atomization-based cutting fluid spray system
No full textAtomization-based cutting fluid (ACF) spray system is being sought as an alternative to cooling processes currently used for machining difficult-to-cut materials such as Ti-6Al-4V alloy. The ACF spray system generates a stream of monodispersed droplets of cutting fluid which then gets mixed in a high-velocity gas flow to form a focused axisymmetric jet of droplets. During machining, this jet is able to penetrate the small region of the tool-chip interface helping in lubrication and cooling of the interface. The advantage of the ACF spray system is that it requires very small amount of cutting fluid, which makes the system more energy efficient and environmentally friendly. It has been recently reported that ACF spray system improves machining performances including tool life and reduced temperature near the tool-chip interface in turning Ti-alloy. It is clear from these studies that the reduction in temperature and improvement in machining are mainly dependent on the interaction of the cutting fluid from the ACF spray system with the chip-tool interface. Therefore, it is imperative to have a physics-based understanding of the phenomena taking place at the interface that is responsible for the tool temperature reduction.
In this study, a thermal model for the atomization-based cutting fluid (ACF) spray system is developed to predict the temperature of the cutting edge of the tool during machining of titanium alloys. In the model, film boiling is taken into account because of the high temperatures involved in turning of Ti-6Al-4V alloy. Due to film boiling a thin vapor film is formed between the heated tool surface and the droplet. Heat is being conducted away from the tool through this film. It is shown that the thermal model is able to predict the temperature reduction due to ACF spray cooling and the predicted temperature profile is comparable to the experimental results.Submission published under a 24 month embargo labeled 'Closed Access', the embargo will last until 2017-08-01The student, Asif Tanveer, accepted the attached license on 2015-07-24 at 11:26.The student, Asif Tanveer, submitted this Thesis for approval on 2015-07-24 at 11:34.This Thesis was approved for publication on 2015-07-24 at 12:56.DSpace SAF Submission Ingestion Package generated from Vireo submission #8643 on 2015-09-29 at 15:06:54Made available in DSpace on 2015-09-29T21:08:27Z (GMT). No. of bitstreams: 2
TANVEER-THESIS-2015.pdf: 5086790 bytes, checksum: 282d1e7303cadf265c50b5554666401f (MD5)
LICENSE.txt: 4209 bytes, checksum: bd7acda06591d0aee5bc8c7fd43c53f5 (MD5)
Previous issue date: 2015-07-24Embargo set by: Seth Robbins for item 89602
Lift date: 2017-09-29T21:08:35Z
Reason: Author requested closed access (OA after 2yrs) in Vireo ETD systemLimited Restriction Lifted for Item 89602 on 2017-09-30T09:15:32Z
Hydraulic simulations to evaluate and predict design and operation of the Chashma Right Bank Canal
No full textIrrigation systems / Irrigation canals / Flow control / Velocity / Canal regulation techniques / Hydraulics / Simulation models / Design / Operations / Crop-based irrigation / Distributary canals / Water delivery / Policy / Protective irrigation / Water allocation / Water requirements / Sedimentation / Water distribution / Equity / Water conveyance / Pakistan / Chashma Right Bank Canal
Tax systems in the reforming socialist economies of Europe
No full textAs socialist countries move toward market systems, fiscal policy is an important part of their reform agenda. First, they need to reorient public spending to focus more on the provision of"public"goods. Second, they need to adopt more selective, predictable, and nondiscretionary means to finance such spending. The goal of this paper is to lay out some of the broad trends and issues now emerging as socialist economies attempt to reform their systems of taxation. The primary focus is on Eastern Europe, although many of the same trends and issues arise in the reforming socialized countries of Asia and Africa. Particular attention is paid to Hungary and Poland, which are most advanced in the tax reform process. The experiences they have had and the problems they are facing provide valuable lessons for those countries just starting on the reform process.Public Sector Economics&Finance,Environmental Economics&Policies,Economic Theory&Research,Banks&Banking Reform,Municipal Financial Management
A study of open innovation and its applications to product design
No full textThesis: S.M. in Engineering and Management, Massachusetts Institute of Technology, Engineering Systems Division, System Design and Management Program, 2013.This electronic version was submitted by the student author. The certified thesis is available in the Institute Archives and Special Collections.Cataloged from student-submitted PDF version of thesis.Includes bibliographical references (pages 101-105).The rapid development of the internet and social media have democratized the innovation opportunities for small startups and individual innovators. This is creating more ways for companies to exploit external ideas for their internal innovation. The dominant use of open innovation today is in idea generation. However, some companies have gainfully applied open innovation across other phases of product development, including concept development, detailed design, manufacturing and sales. The academic literature in this area is rapidly evolving and is covering many different concepts associated with open innovation. At the same time, product development processes are also evolving and are being integrated with more digital tools and electronic workflows. Although many companies are saving R&D costs by utilizing open innovation methods, there clearly is a need to understand the right open innovation tools and processes to maximize the returns from this strategy; one approach does not fit all. This thesis builds a taxonomy of open innovation and discusses its applicability to modern product design processes. This thesis studies the applications and benefits of open innovation in all phases of product design, and suggests strategies for an optimal mix of open and closed innovation processes and tools applicable to modern product design. Challenges in incorporating open innovation and managerial strategies to overcome them are also discussed.by Asif Iqbal.S.M. in Engineering and Managemen
Novel CO2 Separation Membranes
No full textUsing membranes for CO2 capture has gained recent prominence in the global scientific community due to its lower capital cost and a quicker separation performance than the conventional separation methods. The membrane process features desirable properties, like compactness, energy efficiency, and environmental friendliness. Various polymeric and inorganic materials have been tested both as unique ingredients and blends to form CO2 separation membranes with a focus on increasing the performance but have had varying rates of success. For commercial viability, the membrane sector requires new techniques and testing materials to lower the cost of CO2 capture. Recently, thermally rearranged polymers, intrinsic microporous polymers, ionic liquid inclusion as fillers, and binary fillers have all emerged as novel trends, focusing on enhancing the working efficiency and sustainability of the membranes. This chapter explores the most recent advances in membrane technology and its future prospects as a sustainable solu ion towards carbon dioxide capture. This Page is compulsory Book Title – Sustainable Carbon Capture: Technologies and Applications Chapter Author(s) – Asif Jamil, Department of Chemical Polymer and Composite Material Engineering, University of Engineering and Technology (New Campus), Lahore, Pakistan, [email protected] Muhammad Latif, Institute of Energy and Environmental Engineering, University of the Punjab, 54590, Lahore, Pakistan, [email protected] Alamin Idris Abdulgadir, Department of Engineering and Chemical Sciences, Karlstad University, SE-651 88 Karlstad, Sweden, [email protected] Danial Qadir, Centre for Sustainable Engineering, Teesside University, Middlesbrough, United Kingdom, [email protected] Hafiz Abdul Mannan, Institute of Polymer and Textile Engineering, University of the Punjab, 54590, Lahore, Pakistan, [email protected]</p
- …
