196,047 research outputs found
Characterization of the PTB ultra-high pulse dose rate reference electron beam
Get PDF: Purpose. This investigation aims to present the characterisation and optimisation of an ultra-high pulse dose rate (UHPDR) electron beam at the PTB facility in Germany. A Monte Carlo beam model has been developed for dosimetry study for future investigation in FLASH radiotherapy and will be presented.Material and methods. The 20 MeV electron beams generated by the research linear accelerator has been characterised both in-beamline with profile monitors and magnet spectrometer, and in-water with a diamond detector prototype. The Monte Carlo model has been used to investigate six different setups to enable different dose per pulse (DPP) ranges and beam sizes in water. The properties of the electron radiation field in water have also been characterised in terms of beam size, quality specifierR50and flatness. The beam stability has also been studied.Results. The difference between the Monte-Carlo simulated and measuredR50was smaller than 0.5 mm. The simulated beam sizes agreed with the measured ones within 2 mm. Two suitable setups have been identified for delivering reference UHPDR electron beams. The first one is characterised by a SSD of 70 cm, while in the second one an SSD of 90 cm is used in combination with a 2 mm aluminium scattering plates. The two set-ups are quick and simple to install and enable an expected overall DPP range from 0.13 Gy up to 6.7 Gy per pulse.Conclusion. The electron beams generated by the PTB research accelerator have shown to be stable throughout the four-months length of this investigation. The Monte Carlo models have shown to be in good agreement for beam size and depth dose and within 1% for the beam flatness. The diamond detector prototype has shown to be a promising tool to be used for relative measurements in UHPDR electron beams
Absorbed-dose-to-water measurement using alanine in ultra-high-pulse-dose-rate electron beams
Get PDF: Objective. The aim of the presented study is to evaluate the dose response of the PTB's secondary standard system, which is based on alanine and electron spin resonance (ESR) spectroscopy measurement, in ultra-high-pulse-dose-rate (UHPDR) electron beams.Approach. The alanine dosimeter system was evaluated in the PTB's UHPDR electron beams (20 MeV) in a range of 0.15-6.2 Gy per pulse. The relationship between the obtained absorbed dose to water per pulse and the in-beamline charge measurement of the electron pulses acquired using an integrating current transformer (ICT) was evaluated. Monte Carlo simulations were used to determine the beam quality conversion and correction factors required to perform alanine dosimetry.Main results. The beam quality conversion factor from the reference quality60Co to 20 MeV obtained by Monte Carlo simulation, 1.010(1), was found to be within the standard uncertainty of the consensus value, 1.014(5). The dose-to-water relative standard uncertainty was determined to be 0.68% in PTB's UHPDR electron beams.Significance. In this investigation, the dose-response of the PTB's alanine dosimeter system was evaluated in a range of dose per pulse between 0.15 Gy and 6.2 Gy and no evidence of dose-response dependency of the PTB's secondary standard system based on alanine was observed. The alanine/ESR system was shown to be a precise dosimetry system for evaluating absorbed dose to water in UHPDR electron beams
Dr. Duane M. Jackson, Morehouse College, July 2011
No full textThis video is a conversation with Dr. Duane M. Jackson. Dr. Jackson talks about his paper, "Recall and the Serial Position Effect: The Role of Primacy and Recency on Accounting Students' Performance." Jackie Daniel, AUC Woodruff Library, is the interviewer
"Reflections on the subject of Emigration from Europe with a view to Settlement in the United States" By M. Carey.
No full text"Reflections on the subject of Emigration from Europe with a view to Settlement in the United States: containing bried sketches of the moral and political character of those states.
By M. Carey, member of the American philosophical, and of the American Antiquarian Society, and author of The Olive Branch, Cindiciae Hibernicae, essays on banking, on political economy, and on internal improvement.
To which are now added the English editor's comments on the subject; together with Important Advice to Emigrants, and Cautions Against Impositions Practiced in the Outports
Dispelling the Myths Behind First-author Citation Counts
Get PDFWe conducted a full-scale evaluative citation analysis study of scholars in the XML research field to explore just how different from each other author rankings resulting from different citation counting methods actually are, and to demonstrate the capability of emerging data and tools on the Web in supporting more realistic citation counting methods. Our results contest some common arguments for the continued
use of first-author citation counts in the evaluation of scholars, such as high correlations between author rankings by first-author citation counts and other citation
counting methods, and high costs of using more realistic citation counting methods that are not well-supported by the ISI databases. It is argued that increasingly available digital full text research papers make it possible for citation analysis studies to go beyond what the ISI databases have directly supported and to employ more
sophisticated methods
Dr. Glendon Swarthout
No full textHosted by Roger M. Busfield, MSU Assistant Professor of Speech and Theater, Meet the Author is designed to introduce a general audience to a contemporary author and their work through in-depth interviews. This episode features a conversation between Dr. Glendon Swarthout, prolific author and English professor at MSU, and assistant professors Sam S. Baskett and Theodore B. Strandness
Simulation of thermal plant optimization and hydraulic aspects of thermal distribution loops for large campuses
Get PDFFollowing an introduction, the author describes Texas A&M University and its utilities system. After that, the author presents how to construct simulation models for chilled water and heating hot water distribution systems. The simulation model was used in a $2.3 million Ross Street chilled water pipe replacement project at Texas A&M University. A second project conducted at the University of Texas at San Antonio was used as an example to demonstrate how to identify and design an optimal distribution system by using a simulation model. The author found that the minor losses of these closed loop thermal distribution systems are significantly higher than potable water distribution systems. In the second part of the report, the author presents the latest development of software called the Plant Optimization Program, which can simulate cogeneration plant operation, estimate its operation cost and provide optimized operation suggestions. The author also developed detailed simulation models for a gas turbine and heat recovery steam generator and identified significant potential savings. Finally, the author also used a steam turbine as an example to present a multi-regression method on constructing simulation models by using basic statistics and optimization algorithms. This report presents a survey of the author??s working experience at the Energy Systems Laboratory (ESL) at Texas A&M University during the period of January 2002 through March 2004. The purpose of the above work was to allow the author to become familiar with the practice of engineering. The result is that the author knows how to complete a project from start to finish and understands how both technical and nontechnical aspects of a project need to be considered in order to ensure a quality deliverable and bring a project to successful completion. This report concludes that the objectives of the internship were successfully accomplished and that the requirements for the degree of Degree of Engineering have been satisfied
Intern experience at CH���M Hill, Inc.: an internship report
Get PDFIncludes author's vita"Submitted to the College of Engineering of Texas A&M University in partial
fulfillment of the requirement for the degree of Doctor of Engineering."Includes bibliographical referencesA review of the author's internship experience with CH���M HILL, Inc.
during the period September 1975 through May 1976 is presented. During this nine month
internship the author worked as an Engineer II in the Industrial Processes discipline of this
large consulting engineering firm... The author's prime responsibility was as one of three
lead design engineers on the design of a large wastewater treatment facility for a pulp mill
in Hoquiam, Washington owned by ITT Rayonier Inc. The work generally consisted of the design
of individual treatment units and associated piping and pumping. The purpose of the project
was to provide wastewater treatment capabilities that would satisfy the effluent limitations
(standards) imposed upon the mill by the State of Washington Department of Ecology and the
U.S. Environmental Protection Agency. The author's assignment also entailed necessary
interaction with the project manager and other CH���M HILL design engineers and support staff
members, the client's representatives, and representatives of two other consulting engineering
firms working on the project. Thus, the internship position at CH���M HILL provided considerable
experience coordinating the author's work with the work of other engineers, guiding the design
and administrative efforts of a support staff, and interacting regularly with the client and
other consulting firms. This broad exposure to a variety of engineering and organizational
problems provided a valuable educational experience
Transition to turbulence in a qblique shock-wave/boundary-layer interaction at M=15
No full textDirect numerical simulations are carried out for different forcing techniques to trigger transition during the interaction between an oblique shock-wave and a laminar boundary-layer at M = 1.5. Three forcing methods are used: a) forcing of oblique unstable modes, whose shape and behaviour are determined by the local linear stability theory, b) broadband free-stream acoustic disturbances, and c) a cold plasma flow control device. While the oblique-mode breakdown is dominant for low-amplitude forcing, long streaky structures drive the transition process in a high-amplitude disturbance environment. LES are also performed on the experimental setup by the Institute of Theoretical and Applied Mechanics (ITAM) from Novosibirsk State University with cold plasma actuation. As well as the disturbance type, the effect of Reynolds number and forcing amplitude will be investigated
Letter from Cedrick M. Shimo to the Office of Redress Administration, June 4, 1991
No full textA letter from Cedrick M. Shimo to the Office of Redress Administration arguing that John Y. Udaka is entitled to a redress payment.These materials are from box 73 and 74 of the Frank Chin Papers. The Frank Chin Papers contain personal and professional correspondence between Frank Chin and Michi Weglyn relating to particular projects on which either author was working as well as files related to the Day of Remembrance Tribute to Michi Weglyn
- …
