1,720,959 research outputs found
Development of an actuator line model for simulation of floating offshore wind turbines
No full textThis study focuses on developing and applying an actuator line model (ALM) to predict the wake behind floating offshore wind turbines (FOWTs). A computational method is presented which implements an ALM, able to handle 6 Degree-of-Freedom (DOF) motion dynamics, coupled with a CFD solver. Computational grides used are cubic and do not require a boundary layer mesh. Results show that just about 300k grids are necessary for performance assessment of the NREL Phase VI case. Therefore, the proposed method leads to significantly lower computational cost and easier preprocessing compared to highorder methods used for solving RANS. On the other hand, coupled aerodynamic and motion analyses showed that pitch and surge motions have the most considerable influence on turbine performance due to their inherent effect on 3D local wind inclination in the relative frame. The peak power happened when the platform is in its initial position, where the platform motion velocity is maximum. Finally, it is shown that the wind turbine movement has a considerable effect on its wake characteristics. The gap distances between wake rings can also change wake interactions, and, for the case with platform pitch motion, the condition of the wake is even more complicated as such distance is not the same in all azimuthal sectors. The results show that the applied ALM method is beneficial for simulating the wake behind offshore wind turbines and the complex phenomena in the wake due to platform oscillation
A Numerical Investigation on the Effects of Vaned Diffusers on the Aerodynamic Performance of a Low Pressure-Ratio Methane Centrifugal Compressor
Get PDFVaned diffusers are widely used in centrifugal compressors due to their higher pressure-recovery coefficients compared to vaneless diffusers. In this study, the effects of the diffuser vanes’ wrap angle and number of vanes on the aerodynamic performance of an industrial Methane centrifugal compressor with a pressure-ratio of 1.288 are studied using high fidelity steady-RANS numerical simulations. Three wrap angles (WA = 19.3o, 22.3o and 25.3o) and three number of vanes (NDiff. = 16, 20 and 24) are examined, while all the other geometrical and operational parameters are kept constant. Results showed that decreasing the wrap angle can enhance the choke flow rate of the compressor, with slight reduction in pressure ratio at low flow rates. However, increasing the diffuser wrap angle, intensifies the flow separation over the diffuser vanes. On average, the best aerodynamic performance of the compressor occurred at WA=22.3o. Results also showed that reducing the number of diffuser vanes enlarges the operating range of the compressor, however, the pressure ratio will be lower at the flow rates less than the design point. Conversely, higher pressure ratios will be achieved at the flow rates greater than the design flow rate. The optimal aerodynamic efficiency of the diffuser, considering both the pressure ratio and the total-to-total efficiency, was achieved when the NDiff value was set to 20
An actuator line method for performance prediction of HAWTs at urban flow conditions: A case study of rooftop wind turbines
No full textBlade-resolved numerical modeling of wind turbines at complex flow conditions are resource expensive due to large computational domains and extra-fine grid requirements. The Actuator Line Method (ALM) can significantly boost the simulation speed, providing acceptable accuracy and flow details. This study investigates the performance of NREL Phase VI wind turbine mounted over a high-rise building at nine different locations, providing practical illustrations of complicated flow situations. To demonstrate the superior capabilities of this method compared to the actuator disk model, two hub-heights are considered for mounting the wind turbine. Results showed that the power coefficient of the turbines with higher hub-height are close to the corresponding bare wind turbine. However, up to 52 % reduction was observed for the low hub-heights. Furthermore, variations of the bending moment experienced by the turbine's blade in a complete revolution are presented, which is a crucial factor affecting the fatigue life and structural stability of the wind turbine. Eventually, more in-depth discussions on the time-evolution of rotor performance at various locations are presented by illustrating the spanwise distributions of Angle-of-Attack histogram and its PSD diagram for the blade-1 of the wind turbine
Effects of the ring clearance on the aerodynamic performance of a CO2 centrifugal compressors annular seal: A numerical study
No full textComputational fluid dynamics simulations are performed on a floating-ring annular seal of a Carbon Dioxide (CO2) centrifugal compressor. The numerical methodology has been validated by comparing the numerical results for the labyrinth function of a stepped-type labyrinth seal with those from experiments. An annular seal of a CO2 compressor is considered and the effects of the rings’ clearances on the seal function are investigated. Results showed that although the leakage rate grows considerably with increasing ring clearance, the leakage function rises marginally with clearance. Furthermore, the leakage function remains almost constant with increasing the inlet total pressure and temperature. Results also showed that the minimum required flow rate of the barrier gas grows substantially with increasing the ring clearance
Effects of number of inlet guide vanes on the aerodynamic performance of a centrifugal compressor
Get PDFVariable inlet guide vanes (VIGVs) are widely used for flow throttling and also extending the operating range of centrifugal compressors. Although there are several studies on the effects of adding IGVs on the performance curve of the compressors, none of them have focused on the number of vanes. In the current study, high-fidelity three-dimensional numerical simulations are carried out to analyze the effects of adding VIGVs with different number of vanes on the aerodynamic performance of a single-stage centrifugal compressor. The selected compressor prototype is a high flowrate single-stage compressor equipped with a vaned diffuser, designed and fabricated by Siemens. Computational fluid dynamic simulations are performed for three different number of guide vanes at three IGV inclination angles of 0, −30 and +45 degrees. The numerical results are validated by comparing the pressure-rise curves with the available experimental data of the compressor data sheet, where a good agreement was achieved. Results show that at the fully-open condition, the number of vanes does not have considerable effect on the performance curve of the compressor. However, as the IGV inclination angle increases, the number of inlet vanes plays a considerable role in the compressor efficiency. For example, at IGV inclination angle of +45 degree, increasing the number of vanes from 7 to 11 can increase the compressor maximum efficiency up to 5 points. Numerical results showed that increasing the number of inlet guide vanes imposes a higher pressure drop in the inlet passage of the compressor while generating a more uniform velocity distribution at the suction surface of the impeller. Due to the existence of several counteracting effects, an optimum number of inlet guide vanes can be found
Going Beyond Counting First Authors in Author Co-citation Analysis
Get PDFThe present study examines one of the fundamental aspects of author co-citation analysis (ACA) - the way co-citation
counts are defined. Co-citation counting provides the data on which all subsequent statistical analyses and mappings
are based, and we compare ACA results based on two different types of co-citation counting - the traditional type that
only counts the first one among a cited work's authors on the one hand and a non-traditional type that takes into
account the first 5 authors of a cited work on the other hand. Results indicate that the picture produced through this non-traditional author co-citation counting contains more coherent author groups and is therefore considerably clearer. However, this picture represents fewer specialties in the research field being studied than that produced through the traditional first-author co-citation counting when the same number of top-ranked authors is selected and analyzed. Reasons for these effects are discussed
Variations on the Author
Get PDF“Variations on the Author” discusses two of Eduardo Coutinho’s recent films (Um Dia na Vida, from 2010, and Últimas Conversas, posthumously released in 2015) and their contribution to the general question of documentary authorship. The director’s filmography is characterized by a consistent yet self-effacing form of authorial self-inscription: Coutinho often features as an interviewer that rather than express opinions propels discourses; an interviewer that is good at listening. This mode of self-inscription characterizes him as an author who is not expressive but who is nonetheless markedly present on the screen. In Um Dia na Vida, however, Coutinho is completely absent form the image, while Últimas Conversas, on the contrary, includes a confessional prologue that moves the director from the margins to the center of his films. This article examines the ways in which these works stand out in the filmography of a director who offers new insights into the notion of cinematic authorship
Appropriate Similarity Measures for Author Cocitation Analysis
Get PDFWe provide a number of new insights into the methodological discussion about author cocitation analysis. We first argue that the use of the Pearson correlation for measuring the similarity between authors’ cocitation profiles is not very satisfactory. We then discuss what kind of similarity measures may be used as an alternative to the Pearson correlation. We consider three similarity measures in particular. One is the well-known cosine. The other two similarity measures have not been used before in the bibliometric literature. Finally, we show by means of an example that our findings have a high practical relevance.information science;Pearson correlation;cosine;similarity measure;author cocitation analysis
Dispelling the Myths Behind First-author Citation Counts
Get PDFWe conducted a full-scale evaluative citation analysis study of scholars in the XML research field to explore just how different from each other author rankings resulting from different citation counting methods actually are, and to demonstrate the capability of emerging data and tools on the Web in supporting more realistic citation counting methods. Our results contest some common arguments for the continued
use of first-author citation counts in the evaluation of scholars, such as high correlations between author rankings by first-author citation counts and other citation
counting methods, and high costs of using more realistic citation counting methods that are not well-supported by the ISI databases. It is argued that increasingly available digital full text research papers make it possible for citation analysis studies to go beyond what the ISI databases have directly supported and to employ more
sophisticated methods
- …
