1,720,988 research outputs found
Going Beyond Counting First Authors in Author Co-citation Analysis
Full text linkThe present study examines one of the fundamental aspects of author co-citation analysis (ACA) - the way co-citation
counts are defined. Co-citation counting provides the data on which all subsequent statistical analyses and mappings
are based, and we compare ACA results based on two different types of co-citation counting - the traditional type that
only counts the first one among a cited work's authors on the one hand and a non-traditional type that takes into
account the first 5 authors of a cited work on the other hand. Results indicate that the picture produced through this non-traditional author co-citation counting contains more coherent author groups and is therefore considerably clearer. However, this picture represents fewer specialties in the research field being studied than that produced through the traditional first-author co-citation counting when the same number of top-ranked authors is selected and analyzed. Reasons for these effects are discussed
Variations on the Author
Full text link“Variations on the Author” discusses two of Eduardo Coutinho’s recent films (Um Dia na Vida, from 2010, and Últimas Conversas, posthumously released in 2015) and their contribution to the general question of documentary authorship. The director’s filmography is characterized by a consistent yet self-effacing form of authorial self-inscription: Coutinho often features as an interviewer that rather than express opinions propels discourses; an interviewer that is good at listening. This mode of self-inscription characterizes him as an author who is not expressive but who is nonetheless markedly present on the screen. In Um Dia na Vida, however, Coutinho is completely absent form the image, while Últimas Conversas, on the contrary, includes a confessional prologue that moves the director from the margins to the center of his films. This article examines the ways in which these works stand out in the filmography of a director who offers new insights into the notion of cinematic authorship
Appropriate Similarity Measures for Author Cocitation Analysis
Full text linkWe provide a number of new insights into the methodological discussion about author cocitation analysis. We first argue that the use of the Pearson correlation for measuring the similarity between authors’ cocitation profiles is not very satisfactory. We then discuss what kind of similarity measures may be used as an alternative to the Pearson correlation. We consider three similarity measures in particular. One is the well-known cosine. The other two similarity measures have not been used before in the bibliometric literature. Finally, we show by means of an example that our findings have a high practical relevance.information science;Pearson correlation;cosine;similarity measure;author cocitation analysis
Dispelling the Myths Behind First-author Citation Counts
Full text linkWe conducted a full-scale evaluative citation analysis study of scholars in the XML research field to explore just how different from each other author rankings resulting from different citation counting methods actually are, and to demonstrate the capability of emerging data and tools on the Web in supporting more realistic citation counting methods. Our results contest some common arguments for the continued
use of first-author citation counts in the evaluation of scholars, such as high correlations between author rankings by first-author citation counts and other citation
counting methods, and high costs of using more realistic citation counting methods that are not well-supported by the ISI databases. It is argued that increasingly available digital full text research papers make it possible for citation analysis studies to go beyond what the ISI databases have directly supported and to employ more
sophisticated methods
Structure, mechanical and tribological properties of Mo-S-N solid lubricant coatings
No full text Solid lubricant coatings deposited by plasma-assisted deposition techniques represent modern way to reduce the coefficient of friction in lubricant-free sliding contacts. Molybdenum disulphide (MoS2 ) is perhaps the most known and applied solid lubricant coating; however, its use is strictly limited by low hardness and environmental sensitivity. To improve mechanical and tribological properties, we doped MoS2 coating with nitrogen. Mo-S-N self-lubricant films were deposited by pulsed d. c. High Target Utilisation Sputtering (HiTUS) in reactive atmosphere. The effect of deposition conditions on chemical composition, structure and mechanical properties of MoSx and Mo-S-N coatings was studied; films with the most promising properties have been selected for tribological testing. MoSx film with the elemental composition sulphur to molybdenum (S/Mo ratio) 1.6 exhibited the coefficients of friction (COFs) in humid air 0.17 and 0.07 for loads 2 and 15 N, respectively. Mo-S-N films were prepared with nitrogen content in a range of 11 to 50 at., whereas S/Mo ratio varied from 1.35 to 0.4. Mo-S-N films were amorphous or nanostructured with nanograins of molybdenum disulphide. Hardness increased with N content up to 14 GPa for film with the highest content of nitrogen. Friction behaviour in humid air was evaluated using a ball-on-disk tribometer. Globally, the doping with N resulted in hardness in Mo–S–N films one order of magnitude higher and wear rate two orders of magnitude lower than in an undoped one, keeping the friction coefficient at the same level or even lower. These coatings showed remarkable friction coefficients in humid air from 0.28 to 0.05 with loads from 2 to 15 N, respectively. The excellent friction properties were attributed to the formation of a thin molybdenum disulphide tribofilm at the sliding interface. HiTUS represents a very promising way of producing thin films on the thermally sensitive substrates (e.g. bearing steel) with desired properties. </p
koamabayili/VECTRON-author-checklist: VECTRON author checklist
No full textWe have done our best to complete the author checklist relating to the use of animals in the hut study. Note that the objective for the hut study was to evaluate the IRS treatment applications for residual efficacy against Anopheles mosquitoes, including the local An. coluzzii mosquito population. Cows were only used to attract mosquitoes into the huts and no tests were carried out directly on the cows. The author checklist is intended for use with studies where experiments are carried out on animals, which is why we have had such difficulty in completing this for the hut study, as many of the questions do not relate to how the cows were used
Phase transformations in Mo-doped FINEMETs
Full text linkIn this paper, the phase transformations occurring during the crystallization process of FINEMETs in which Nb has been gradually replaced by Mo have been studied by a variety of techniques including DSC, DTA, TGA, XRD and TEM. The thermal stability of the alloy was deteriorated as a consequence of Mo’s smaller atomic size. The gradual replacement of Nb by Mo reduced the onset temperature of Fe–Si and of the borides. The Curie temperature of the amorphous phase slightly decreased from 594 K for x=0 to 587 K for x=3. The borides compounds Fe2B and Fe23B6 as well as the (Nb,Mo)5Si3 phase were found to precipitate in the second and third crystallization.Fil: Silveyra, Josefina María. Consejo Nacional de Investigaciones Científicas y Técnicas. Oficina de Coordinación Administrativa Houssay. Instituto de Tecnologías y Ciencias de la Ingeniería; Argentina; Argentina. Universidad de Buenos Aires. Facultad de Ingenieria. Departamento de Fisica. Laboratorio de Sólidos Amorfos; ArgentinaFil: Illeková, Emília. Slovak Academy of Sciences; EslovaquiaFil: Švec, Peter. Slovak Academy of Sciences; EslovaquiaFil: Janičkovič, Dušan. Slovak Academy of Sciences; EslovaquiaFil: Rosales Rivera, Andrés. Universidad Nacional de Colombia; ColombiaFil: Cremaschi, Victoria Juliana. Consejo Nacional de Investigaciones Científicas y Técnicas. Oficina de Coordinación Administrativa Houssay. Instituto de Tecnologías y Ciencias de la Ingeniería; Argentina; Argentina. Universidad de Buenos Aires. Facultad de Ingenieria. Departamento de Fisica. Laboratorio de Sólidos Amorfos; Argentin
Author-wise bibliometric analysis based on entropy.
No full textAuthor-wise bibliometric analysis based on entropy.</p
- …
