Journal of Applied Geology
Not a member yet
197 research outputs found
Sort by
NUMERICAL MODELLING AND SIMULATION OF CO2 –ENHANCED COAL-BED METHANE RECOVERY (CO2-ECBMR): THE EFFECT OF COAL SWELLING ON GAS PRODUCTION PERFORMANCE
Get PDFThis presents study investigate the effect of swelling on gas production performances at coal reservoirs during CO2-ECBMR processes. The stressdependent permeability-models to express effect of coal matrix shrinkage/swelling using Palmer and Mansoori (P&M) and Shi and Durucan (S&D) models were constructed based on present experimental results for typical coal reservoirs with the distance of 400 to 800 m between injection and production wells. By applying the P&M and S&D models, the numerical simulation results showed that CH4 production rate was decreasing and peak production time was delayed due to effect of stress and permeability changes caused by coal matrix swelling. The total CH4 production ratio of swelling effect/no-swelling was simulated as 0.18 to 0.95 for permeability 1 to 100 mD, respectively. It has been cleared that swelling affects gas production at permeability 1 to 15 mD, however, it can be negligible at permeability over 15 mD
Lateritization process of peridotites in Siruka, Choiseul, Solomon Islands
Get PDFThe lateritic weathering crusts exposed in Siruka, Choiseul Islands, Solomon Islands, were developed on the expense of serpentinized peridotite underlain by Siruka schists and Voza lavas with a subhorizontal contact. The lateritic profiles consist of three generalized zones: bedrock, saprolitic zone (weathered and decomposed zone) and the limonitic zones. The profiles demonstrate variations in depths and continuity but illustrate mineralogy and geochemical affinity down profile and are analogous to saprolitic nickel laterite deposits. Silica and magnesia in the bed rock and the saprolitic zones have been removed and only the residual elements (iron, chromium, aluminium, manganese, cobalt and nickel) remain in the limonitic zone. These elements are relatively concentrated as a result of the removal of the soluble elements. Nickel is associated with silica and magnesia, as lizardite ormixed gels (garnierite nickel ore) at the weathering fronts. On the other hand, nickel, with generally low concentrations
COMPARISON OF KRIGING AND INVERSE DISTANCE WEIGHTED (IDW) INTERPOLATION METHODS IN LINEAMENT EXTRACTION AND ANALYSIS
Get PDFAnalysis that is based on geostatistics eliminates many corresponding defects and limitations compared to classical statistics which have been developed by random distribution theory of processes and variables. Interpolation is important for local analysis by GIS, because many maps used for GIS operation are made by interpolation. In this research, two different methods which is Kriging method and Inverse Distance Weighted (IDW) method was examined for developing Digital Elevation Model image. Each method’s advantages and disadvantages were considered. The study are, Kepil, is within Kulon Progo physiographic and stratigraphic area, located in the western part of Yogyakarta city. This area is located close to the Java Island Subduction Zone, hence influence of tectonic plate movement is relatively dominant. Geological structures become a main factor that shapes the recent morphology. This study area also has many settlements and has high weathering and erosion rate. Lineaments are extracted based on Digital Elevation Model to provide assistance in delineating geological structures. The structural geology analysis and an understanding of tectonic phase of the area provide useful information for geological map- ping. Accuracy of lineament depends on extraction and imagery parameters used. In this study, the extraction was conducted by two different raster methods, namely Kriging and Inverse Distance Weighted (IDW) with the same resolution of 30 meters. Lineament extracted automatically (digitally) with certain parameter settings. Keywords: Kriging, inverse distance weighted, interpolation, lineament, random distribution, digital elevation model
CHARACTERISTICS AND LIQUEFACTION OF COAL FROM WARUKIN FORMATION, TABALONG AREA, SOUTH KALIMANTAN–INDONESIA
Get PDFSince the coal characteristic is the main controlling factors in coal liquefaction, thus five coal seams with different coal rank from Warukin Formation in Tabalong Area, South Kalimantan have been used in this study. Three seams were low rank coal (Wara 110, Wara 120, Wara 200) while two seams were medium rank (Tutupan 210 and Paringin 712). The objectives of this study was to investigate the effect of coal rank on the rate of coal conversion factor. Coal liquefaction was conducted in an autoclave on low pressure (14.7 psi) and temperature 120°C. Experiments were designed with time intervals 30, 60 and 90 minutes, respectively. The average coal properties of seam Wara 110, Wara 120 and Wara 200 were 26.65%, 5.08%, 46.26% and 30.60% for inherent moisture, ash content, volatile matter and. fixed carbon, respectively. In contrast, coal properties for seam Tutupan 210 and Paringin 712 were 18.42%, 1.81%, 23.02% and 35.76% for inherent moisture, ash content, volatile matter and fixed carbon, respectively. The maximum yields for Wara 110, Wara 120 and Wara 200 were 48.60% (30 minutes), 51.27% (60 minutes) and 46.72% (90 minutes). In comparison, Tutupan 210 and Paringin 712 resulted maximum yields of 8.22% (30 minutes), 18.35% (60 minutes), 6.23% (90 minutes). In conclusion, low rank coal has higher yield conversion compared to medium rank coal since it has higher H/C ratio. Keywords: Coal liquefaction, low rank coal, Kalimantan
Evaluation of strong ground motion for Yogyakarta depression area, Indonesia
Get PDFThe probabilistic seismic hazard maps are developed for Yogyakarta depression area. The earthquake catalog of ANSS (1970-2007) is taken into account with the complement of NEIC (USGS, 1973-2007) and the records of BMG (2000-2004). On the basis of seismicity of the area, tectonics and geological information, the seismic source zones are characterized for this area. The seismicity parameters of each seismic source are determined by applying the classical Gutenberg-Richter recurrence model, regarding the historical records. The attenuation relation for Yogyakarta depression area cannot be evaluated since the sufficient strong ground motion records are not available for this region. Therefore the attenuation relations which were developed for other territories as Europe and Japan are used for the present hazard calculation by validating, using the aftershocks records, modeling the peak ground acceleration maps for the recent event, 27 May, 2006, Yogyakarta earthquake inserting the damage area distribution pattern. The probabilistic seismic hazard maps are finally developed by using the McGuire (1976) EQRISK computer program by modifying for the present purpose. The seismic hazard maps expressed in term of peak ground acceleration are developed for the recurrence intervals of 10, 50, 100, 200 and 500 year
Engineering geology evaluation for predicting the collapse susceptibility of Sidoarjo hot mud earth levees: A hazard assessment
No full textSince May 29, 2006, a sea of hot mud has been gushing from the ground in Sidoarjo, East Java, 35 kilometres south of Indonesia’s second largest city, Surabaya. Due to this disaster, approximately thousand of peoples have been forced from their homes because 600 ha of land and villages were submerged, farmland was ruined, businesses and schools closed as the mud inundated the surrounding area. The authorities response was to build containment ‘basins’ or ‘ponds’ by enclosing areas of land within earth dams, or levees. During the heavy rain on the rainy season, the earth dams and ringdykes have overflown and broken regularly, causing the flooding of more land and damaging infrastructures. However, not only in the rainy season, the levees had also collapses during the dry season. Therefore, an engineering geology study was conducted in order to evaluate the geological factors which causes this phenomena. The parameters used for the evaluation are the heterogeniety of lithology under the dams, geological discontinuity which indicated by the occuring of surface cracks and bubbles, and subsidence phenomena which indicated by the vertical displacement. Overlying method was used to build homogeniety zone of engineering geology based on those parameters, and the resulted map was once again overlay with the location of dams collapses. Result of this evaluation shows that the earth dams collapses were highly correlated with the existing geological discontinuities and subsidences, respectively. Based on this study, the susceptible location of earth dams collapses can be predicted and allow engineers to prepare and plan better engineering solution for the high probable collapses points in order to protect land and infrastructures from the damaging hot mud overflown.
Keywords: Hot mud disaster, geological factors, homogeniety zone, earth levee failure points, Sidoarjo-Indonesi
DEPOSITIONAL MODEL OF NGRAYONG FORMATION IN MADURA AREA, NORTH EAST JAVA BASIN, INDONESIA
Get PDFThe early Middle Miocene Ngrayong Formation, an important reservoir of North East Java Basin, is well exposed in the central anticlinal part of Madura Island. The purpose of current study is to classify the depositional environments of the study area based on the characteristics and geometry of sedimentary facies. In the Madura island, the thicker clastics and deeper carbonates of Ngimbang Formation and Kujung Formation of Late Oligocene-Early Miocene deposited in the northeast-southwest asymmetrical half grabens. After the deposition of Kujung Formation, the basin morphology developed nearly eastwest trending shelf edge and the deposition of Tuban Formation began. The fine grained complex of Tuban Formation was followed by the Ngrayong Sandstones deposition. The depositional model of Ngrayong Formation is being producing of wide variety of depositional environments. Large scale cross-bedded sandstones and bioturbated massive sandstones with thin to medium bedded argillaceous limestone that outcrop in the northern part of the study area are deposited in costal environment. The heterolithic sandstone with planar and trough cross-lamination, fine grained sandstone with interlaminated structure and bioclastic carbonate exposed in the central part of the study area are deposited in upper shallow marine area. Dark grey siltstones and mudstones deposited in lower shallow marine area are well exposed in southern part of the study area. In conclusion, Ngrayong Formation in Madura area is developed in three depositional units which are coastal, upper shallow marine and lower shallow marine
MINERAL POTENTIAL MAPPING USING GEOGRAPHIC INFORMATION SYSTEMS (GIS) FOR GOLD MINERALIZATION IN WEST JAVA, INDONESIA
Get PDFWestern Java is a part of the Sunda Banda magmatic belt. This belt is well known to be host for several gold deposits in Indonesia, the distribution of 107 Au occurrences in this area was examined in terms of spatial association with various geological phenomena. The goal of this project is to use GIS to conduct weights of evidence (WofE) model for gold mineralization in West Java, Indonesia. A Geographic Information System (GIS) is a computer system for capturing, storing, querying, analyzing, and displaying geospatial data and weight of evidence method is one of the most important datadriven methods for mapping in GIS. The method is a probability based on technique for mapping mineral potential using the spatial distribution of known mineral occurrences. Therefore this method is very useful for gold potential mapping. There are six evidences maps such as NE–SW lineaments NW–SE Lineament, host rocks, heat sources, clay alteration and limonitic alteration, have been combined using a weights of evidence model to predict gold potential in West Java. The best predictive map generated by this method defines 21.62% (9902 km) of study area as favourable zones for gold mineralization further exploration work. It predicts correctly 74 (92.5%) of the 80 model deposits and predicts correctly 26 (96.35%) of the 27 validation deposits, has 6 main 2 prospective target for future exploration are located in Bayah Dome, southern mountain, Honjie Igneous Complex and Bogor zone, Purwakarta. Bayah Dome is highest potential area for gold deposit like Gunung Pongor, Cikidang, Cirotan, Ciawitali, Cikotok destricts and other deposits. The potential area of Au occurrences in research area is associated with NE–SW and NW–SE structure/ lineaments, dominated surrounding the Tertiary intrusive rock unit and hosted in Miocene to Pleistocene lithology rock unit
Study on mineralogy and chemistry of the saprolitic nickel ores from Soroako, Sulawesi, Indonesia: Implication for the lateritic ore processing
Get PDFAn investigation of mineralogy and chemistry of saprolitic nickel ores developed on ultramafic rock with different serpentinization degree from Soroako, Sulawesi has been conducted using X ray diffraction, thermal analysis, FTIR, and ICP-AES. The implication for the processing of these ores under acidic media was also studied. Weathering of unserpentinized peridotite in the Soroako west block produces saprolitic ore containing minerals such as relict olivine, goethite, quartz, talc with minor serpentine and smectite; whereas the weathered materials overlaying serpentinized peridotite in the Petea area are mainly composed of residual serpentine with lesser chlorite, maghemite, and remnant pyroxene and amphibole. Chemical analysis determined by ICP-AES demonstrates that west ore is higher in Si, Mg, and Ni, as compared to that Petea ore. Conversely, Fe and Al concentrations are higher in Petea ore than in west block ore. SEM-EDX examination reveals that olivine, talc, serpentine and goethite are the Ni-bearing phases occurring in west block ore; while serpentine is the principal host for Ni in the Petea ore. Chemical leaching under sulfuric acid reveals that olivine has highest dissolution rate in the west ore followed by serpentine; while talc, pyroxene, and iron oxides have slow dissolution rates. In contrast, serpentine in Petea ore is easily dissolved and is followed by chlorite; whereas amphibole, pyroxene, and maghemite are difficult to leach. Quartz is present in both ores and it seems to be undissolved during the chemical leaching. It is shown that Ni recovery from Petea saprolitic ore is higher than that of West Block ore
Characteristics and genesis of montmorilonitic claystone from Bandung area, Wonosegoro, Boyolali, Central Java, Indonesia
Get PDFThe Bandung bentonite deposit is located in Wonosegoro District, Boyolali Regence, Central Java. Characteristics of bentonite in this area are very important due to increase demand on bentonite in the industry. Several methods are used to characterize the bentonite in this area, such as PLM (polarizing light microscope), X-Ray Diffraction and Scanning Electron Microscope combined with EDX measurements. The montmorilonitic claystone belongs to Kerek Formation from Banyuurip Member. This deposit consists of mainly montmorilonitic claystone interbedded with tuffaceous sandstone. Petrographical analysis shows that montmorilonitic claystone consists of mostly clay minerals with small amount of calcite, volcanic glass, feldspar, quartz, and opaque minerals. The clay minerals are likely as alteration product of volcanic glass. The oriented XRD analyses show that the clay samples consist of Ca-montmorilonite, illite, and kaolinite. Physico-chemical analyses of montmorilonitic claystone display that the initial CEC (cation exchange capacity) is 20 mgrek.Na2O/200gr (54 mg.Na2O/100gr) and low swelling ability for about 2 times of its initial volume. Based on its mineralogical association, textures, and stratigraphic position, the montmorilonite is formed from devitivication of volcanic glass in a diagenetic environment with over 2 km thicks of overburden. Keywords: Bentonite, montmorillonitic claystone, devitrivication, diagenesis, montmorillonit