INESC TEC Repository
Not a member yet
2130 research outputs found
Sort by
The Mutual Impact of Demand Response Programs and Renewable Energies: A Survey
No full textRenewable energies as a solution for environmental issues have always been a key research area due to Demand Response Programs (DRPs). However, the intermittent nature of such energies may cause economic and technological challenges for Independent System Operators (ISOs) besides DRPs, since the acceptable effective solution may exceed the requirement of further investigations. Although, previous studies emphasized employing Demand Response and Renewable Energies in power systems, each problem was investigated independently, and there have been few studies which have investigated these problems simultaneously. In these recent studies, authors neither analyzed these problems simultaneously nor discussed which scientific and practical aspects of demand response and renewable energy injection were employed. Motivated by this requirement, this research has focused on a comprehensive review of recent research of these cases to provide a comprehensive reference for future works
Experimental and analytical approach on the Trombe wall thermal performance parameters characterization
No full textAn analytical and experimental analysis on the Trombe wall thermal performance was carried out for different conditions of ventilation openings and occlusion device operation. Experimental results allowed to determine temperature fluctuation, heat flux, heat delay and air velocity at the ventilation openings. A calculation methodology was applied to estimate the heat gains and losses through the system using experimental data. Ventilation openings and occlusion device effect was immediately visible in the temperature fluctuation and, consequentelly, in the heat gains and losses. Experimental.results showed that, when there was no occlusion device, massive wall external surface temperature values exceeded 60 degrees C and, when it was placed, reduced to 30 degrees C or less. Heat took almost 3 times more to achieve the interior of the test cell when the ventilation openings were closed. Air velocity increased following a diagonally pattern from the bottom to the top of the ventilation opening and its values varied between 0.10 m/s and 0.40 m/s, leading to air flow values between 0.002 m(3)/s and 0.008 m(3)/s. The calculation methodology application allowed to determine the total gains through the system for a continuous period. The impact of the system operation on the different thermal performance parameters was observed
Biomass in the generation of electricity in Portugal: A review
No full textThe quality and composition of biomass as used in Portugal's thermal power plants is highly variable. The biomass consists mainly of residual forest biomass derived from forestry operations and wood waste from industrial processes, in particular paper and pulp industry. Its quality and composition is influenced by the presence of moisture and inert fragments, the latter being incorporated during collection or as a consequence of adherence to the biomass prior to collection. This variability presents difficulties for the thermal power plants; besides being an additional operational cost, the presence of large amounts of water and inerts in biomass used as a fuel, can result in problems related to the instability of the combustion and the accumulation of ash or rock that have to be removed and discarded. The objective of this paper is to review the main parameters that influence the quality of biomass, while analysing the current state-of-the-art power generation from the biomass sector in Portugal, as a new contribution to earlier studies
Context-aware HDR video distribution for mobile devices
No full textHDR video on mobile devices is in its infancy and there are no solutions yet that can achieve full HDR video reproduction due to computational power limitations. In this paper we present a novel and versatile solution that allows the delivery of HDR video on mobile devices by taking into account contextual information and retro-compatibility for devices that do not have the computational power to decode HDR video. The proposed solution also enables the remote transmission of HDR video to mobile devices in real-time. This context-aware HDR video distribution solution for mobile devices is evaluated and discussed by considering the impact of HDR videos over conventional low dynamic range videos on mobile devices as well as the challenge of playing HDR videos directly locally or remotely. © 2016 Springer Science+Business Media New Yor
Verification of User Interface Software: The Example of Use-Related Safety Requirements and Programmable Medical Devices
Get PDFOne part of demonstrating that a device is acceptably safe, often required by regulatory standards, is to show that it satisfies a set of requirements known to mitigate hazards. This paper is concerned with how to demonstrate that a user interface software design is compliant with use-related safety requirements. A methodology is presented based on the use of formal methods technologies to provide guidance to developers about addressing three key verification challenges: 1) how to validate a model, and show that it is a faithful representation of the device; 2) how to formalize requirements given in natural language, and demonstrate the benefits of the formalization process; and 3) how to prove requirements of a model using readily available formal verification tools. A model of a commercial device is used throughout the paper to demonstrate the methodology. A representative set of requirements are considered. They are based on US Food and Drug Administration (FDA) draft documentation for programmable medical devices, and on best practice in user interface design illustrated in relevant international standards. The methodology aims to demonstrate how to achieve the FDA's agenda of using formal methods to support the approval process for medical devices
Inactivation of pathogenic microorganisms in freshwater using HSO5-/UV-A LED and HSO5-/Mn+/UV-A LED oxidation processes
Get PDFFreshwater disinfection using photolytic and catalytic activation of peroxymonosulphate (PMS) through PMS/UV-A LED and PMS/Mn+/UV-A LED [Mn+ = Fe2+ or Co2+] processes was evaluated through the inactivation of three different bacteria: Escherichia coli (Gram-negative), Bacillus mycoides (sporulated Gram-positive), Staphylococcus aureus (non-sporulated Gram-positive), and the fungus Candida albicans. Photolytic and catalytic activation of PMS were effective in the total inactivation of the bacteria using 0.1 mM of PMS and Mn+ at neutral pH (6.5), with E. coli reaching the highest and the fastest inactivation yield, followed by S. aureus and B. mycoides. With B. mycoides, the oxidative stress generated through the complexity of PMS/Mn+/UV-A LED combined treatments triggered the formation of endospores. The treatment processes were also effective in the total inactivation of . albicans, although, due to the ultrastructure, biochemistry and physiology of this yeast, higher dosages of reagents (5 mM of PMS and 2.5 mM of Mn+) were required. The rate of microbial inactivation markedly increased through catalytic activation of PMS particularly during the first 60 s of treatment. Co2+ was more effective than Fe2+ to catalyse PMS decomposition to sulphate radicals for the inactivation of S. aureus and C. albicans. The inactivation of the four microorganisms was well represented by the Horn model. The Biphasic and the Double Weibull models, which are based on the existence of two microbial sub-populations exhibiting different resistance to the treatments, also fitted the experimental results of photolytic activation of PMS
Predicting direct marketing response in banking: comparison of class imbalance methods
No full textCustomers' response is an important topic in direct marketing. This study proposes a data mining response model supported by random forests to support the definition of target customers for banking campaigns. Class imbalance is a typical problem in telemarketing that can affect the performance of the data mining techniques. This study also contributes to the literature by exploring the use of class imbalance methods in the banking context. The performance of an undersampling method (the EasyEnsemble algorithm) is compared with that of an oversampling method (the Synthetic Minority Oversampling Technique) in order to determine the most appropriate specification. The importance of the attribute features included in the response model is also explored. In particular, discriminative performance was enhanced by the inclusion of demographic information, contact details and socio-economic features. Random forests, supported by an undersampling algorithm, presented very high prediction performance, outperforming the other techniques explored
Nash equilibria in the two-player kidney exchange game
No full textKidney exchange programs have been set in several countries within national, regional or hospital frameworks, to increase the possibility of kidney patients being transplanted. For the case of hospital programs, it has been claimed that hospitals would benefit if they collaborated with each other, sharing their internal pools and allowing transplants involving patients of different hospitals. This claim led to the study of multi-hospital exchange markets. We propose a novel direction in this setting by modeling the exchange market as an integer programming game. The analysis of the strategic behavior of the entities participating in the kidney exchange game allowed us to prove that the most rational game outcome maximizes the social welfare and that it can be computed in polynomial time
Arteriovenous access banding revisited
Get PDFPurpose: The aim of this study is to validate the current applicability of arteriovenous access banding in high flow access (HFA) and/or haemodialysis access-induced distal ischaemia (HAIDI). Methods: This retrospective study was conducted at the GEV (Grupo de Estudos Vasculares) vascular access centre. The clinical records of consecutive patients undergoing banding for HAIDI and HFA symptoms, between June 2011 and January 2015, were reviewed until April 2015. All vascular access patients' consultation records and surgical notes were reviewed. We analysed and compared patients' age, gender, comorbidities, symptoms and intraoperative ultrasound control. We defined technical failure as recurrence of symptoms, requiring new banding. Excessive banding, access thrombosis, rupture and false aneurysm development were registered as complications. Primary clinical success was defined as improvement of symptoms or effective flow reduction after banding, with no need for reintervention. If one reintervention was necessary, we have defined it as secondary clinical success. Results: Overall, 119 patients underwent banding: 64 (54%) with HAIDI and 55 (46%) with HFA. The HAIDI group was significantly older (65 +/- 13 years compared with 56 +/- 22 years, p = 0.001) and had significantly greater number of patients with diabetes (56% vs 24%, p = 0.004). Primary success was achieved in 85 patients (71.4%) and the secondary success rate was 84.9%. Older age (p = 0.016) and intraoperative ultrasound control (p = 0.012) were significantly associated with primary success. Conclusions: Our results do not corroborate the high incidence of thrombosis previously reported as associated with AV access banding and suggest that ultrasound control is crucial for preventing technical failure. The procedure was effective on both compared groups