SICOT-J - Société Internationale de Chirurgie Orthopédique et de Traumatologie
Not a member yet
578 research outputs found
Sort by
Surgical treatments for acute unstable acromioclavicular joint dislocations
No full textIntroduction: Surgical treatment is usually recommended for acute, high-grade acromioclavicular joint (ACJ) injuries. A wide variety of surgical techniques exist, and the literature does not strongly support one over the other. In this literature review, we describe and compare the results of different surgical treatments for the management of acute unstable ACJ dislocation and aim to guide surgeons on optimal treatment. Materials and methods: A literature review was performed by searching PubMed, Medline, Cochrane, and Embase databases. Seventeen studies met the inclusion criteria and were analyzed. Only studies with comparative data were included. The clinical and radiological outcomes of these studies were reviewed. Results: Seventeen studies were included in this literature review. We found no difference in outcomes between open and arthroscopic procedures. Coracoclavicular ligament (CCL) reconstruction techniques provide better results than the more rigid hook plate fixation. There is no evidence that biologic repair with tendon graft is superior to synthetic grafts. Furthermore, an autograft is not shown to be better than an allograft. Rigid fixation between the clavicle and coracoid and the non-anatomic Weaver-Dunn technique appears less popular in recent literature. The hook plate is associated with subacromial osteolysis, acromial erosion, and the morbidity of a secondary procedure. Discussion: There is a recent increase in publications on the reconstruction of the ACJ after injury, with new techniques focusing on the anatomic reconstruction of the CCLs aiming to restore both vertical and horizontal plane stability of the ACJ using synthetic/biological grafts. Despite the plethora of new techniques introduced, meaningful comparisons are difficult to draw due to the heterogeneity of the treatments used and the outcome measure used to assess the results
Pars interarticularis repair using pedicle screws and laminar hooks fixation technique in patients with symptomatic lumbar spondylolysis
No full textStudy Design: Prospective case series. Purpose: To assess the outcomes of pars repair surgery using pedicle screws and laminar hooks. Methods: This study was conducted on 22 patients with symptomatic lumbar spondylolysis. Curettage of the fibrocartilage in the defect and drilling of the sclerotic bone ends were done, followed by impaction of cancellous bone graft. Pedicle screws were inserted bilaterally in the corresponding pedicles and connected to a laminar hook via rods (screw-rod-hook fixation). The intensity of back pain and the functional outcome were assessed using the visual analog scale (VAS) and the Oswestry disability index (ODI). Plain radiographs were performed immediately postoperatively and after 3 and 6 months. CT scan was done at the final follow-up to assess pars healing. The mean follow-up period was 27 months. Results: The mean preoperative VAS and ODI were 7.4 ± 0.8 and 64.8 ± 6.7, which improved to 2.4 ± 0.8 and 20 ± 6 respectively at the final follow-up (P < 0.001). Healing of the defect was found in 19 patients at the final follow-up. Non-fusion with graft resorption was noticed in the remaining 3 cases (13.6%). However, postoperative VAS and ODI values improved even in the radiologically non-fused patients. Level of evidence: Therapeutic study, Level IV. Conclusion: Pars repair using pedicle screws and laminar hooks is a relatively simple yet effective procedure
Wrist arthroscopy for diagnosis and treatment of acute and chronic conditions
No full textWrist arthroscopy is a constantly evolving procedure. Allowing direct visualization and dynamic testing of intra-articular structures led to a novel approach toward traumatic and degenerative lesions based on most of the classifications routinely used in wrist surgery. The development of specific instrumentation, combined with a novel understanding of the local anatomy, progressively allowed wrist surgeons to describe more ambitious and complex surgeries. Wrist arthroscopy has become an increasingly useful tool in hand and wrist surgeons’ panoply and seems promised to have further development in the future. This paper discusses the surgical technique and the various pathologies that can be treated by arthroscopy of the wrist
Functional Alignment Philosophy in Total Knee Arthroplasty – Rationale and technique for the varus morphotype using a CT based robotic platform and individualized planning
No full textIntroduction: Alignment techniques in total knee arthroplasty (TKA) continue to evolve. Functional alignment (FA) is a novel technique that utilizes robotic tools to deliver TKA with the aim of respecting individual anatomical variations. The purpose of this paper is to describe the rationale and technique of FA in the varus morphotype with the use of a robotic platform. Rationale: FA reproduces constitutional knee anatomy within quantifiable target ranges. The principles are founded on a comprehensive assessment and understanding of individual anatomical variations with the aim of delivering personalized TKA. The principles are functional pre-operative planning, reconstitution of native coronal alignment, restoration of dynamic sagittal alignment within 5° of neutral, maintenance of joint-line-obliquity and height, implant sizing to match anatomy and a joint that is balanced in flexion and extension through manipulation of implant positioning rather than soft tissue releases. Technique: An individualized plan is created from pre-operative imaging. Next, a reproducible and quantifiable method of soft tissue laxity assessment is performed in extension and flexion that accounts for individual variation in soft tissue laxity. A dynamic virtual 3D model of the joint and implant position that can be manipulated in all three planes is modified to achieve target gap measurements while maintaining the joint line phenotype and a final limb position within a defined coronal and sagittal range. Conclusion: Functional alignment is a novel knee arthroplasty technique that aims to restore constitutional bony alignment and balance the laxity of the soft tissues by placing and sizing implants in a manner that it respects the variations in individual anatomy. This paper presents the approach for the varus morphotype
Outcomes of double level osteotomy for osteoarthritic knees with severe varus deformity. A systematic review
No full textBackground: When correcting severe genu varus deformity, knee surgeons must choose between performing a single or double-level osteotomy. This systematic review aims to provide this equipoise with some clarity. Patients and methods: We conducted this study following the Preferred Reporting Items for Systematic Reviews and Meta-analyses Statement (PRISMA) and the Cochrane Handbook for systematic reviews and meta-analysis. Studies evaluating the effect of the double level osteotomy (DLO) or those comparing it to high tibial osteotomy (HTO) from all regions and written in any language were included. Results: Six studies were included in this systematic review. They were prepared and analysed using Review Manager V5.0 [Computer Program] (RevMan5). Performing DLO resulted in restoring patellar height, joint-line convergence angle (JLCA), and mMPTA to normal values. DLO was also more successful at avoiding joint line obliquity (JLO) in severe varus deformity when compared to HTO (P < 0.001). No significant difference was reported between the two cohorts regarding the mLPTA. DLO resulted in satisfactory short term KOOS and IKDC scores. The complication rate after DLO was 2.28%. Conclusions: DLO showed a low complication rate and satisfactory short term KOOS and IKDAC scores. Randomised control trials with long term follow-up comparing the DLO and HTO are recommended
Full-length standing radiographs can be used for determination of the Femoral neck-shaft angle but not acetabular coverage
No full textIntroduction: The exact evaluation of hip morphology is essential for surgical planning. A wide range of morphometric measures of the acetabulum is deduced from conventional anterior-posterior (ap) pelvic radiographs. Full-length weight-bearing radiographs (FLWBR) also depict the acetabulum and are commonly used for osteotomy planning of the lower limb. This study aimed to determine whether FLWBR can be used to evaluate acetabular morphology. Methods: Radiographs of patients receiving a hip workup that included a conventional ap pelvic X-ray and FLWBR were utilized for radiographic measurements. The following parameters were measured: extrusion index of the femoral head, anterior wall index, posterior wall index, lateral center edge angle (LCE), acetabular index, pubic arc angle (subpubic angle), and centrum-collum-diaphyseal angle (CCD). Results: FLWBR depicted a significantly reduced anterior coverage (p = 0.049) and increased posterior coverage (p < 0.001), higher acetabular index (p = 0.015), and higher pubic-arc angle (p = 0.02) compared to conventional ap pelvic radiographs. There were no significant differences regarding the CCD angle (p = 0.28), extrusion index (p = 0.31), and LCE (p = 0.16). Discussion: The CCD angle of the femur can be measured on conventional ap radiographs and full-length weight-bearing X-rays for lower limb deformity analysis. However, FLWBR will depict an anteverted acetabular morphology, rendering conventional ap radiographs necessary for planning pelvic osteotomies
The correlation between clinical and radiological severity of osteoarthritis of the knee
No full textIntroduction: Primary osteoarthritis (OA) is a common cause of knee pain. Appropriate management of knee OA is based on clinical and radiological findings. Pain, deformity, and functional impairments are major clinical factors considered along with radiological findings when making management decisions. Differences in management strategies might exist due to clinical and radiological factors. This study aims at finding possible associations between clinical and radiological observations. Methods: A prospective cross-sectional study of 52 patients with primary osteoarthritis of the knee managed conservatively at a tertiary hospital arthroplasty clinic was conducted for three months. English speaking patients with primary OA were identified and included in this study. Pain and functional impairment were assessed using Wong-Baker Faces pain scale, The Knee Society Score (KSS), and Western Ontario and McMaster Osteoarthritis Index (WOMAC). The Body Mass Index (BMI) of all participants was measured. Standard two views plain radiographs were used for radiographic grading of the OA. Anonymized radiographs were presented to two senior consultant orthopaedic surgeons who graded the OA using Kellgren and Lawrence (KL) and Ahlbäck classification systems. The severity of the functional impairment and pain score was then compared to the radiological grading. Results: The average age of our participants was 63 ± 9 years. Their average BMI was 34.9 ± 8.4 kg/m2, median self-reported pain, total WOMAC, and pain WOMAC scores were 8, 60, and 13, respectively. We observed no significant correlation between BMI and pain scores. Inter-rater reliability for KL and Ahlbäck grading was strong. There was no significant correlation between WOMAC scores and the radiological grades. Conclusion: There was no correlation between pain and functional scores, patient factors and radiological severity of OA of the knee
Image-based robot assisted bicompartmental knee arthroplasty versus total knee arthroplasty
No full textObjective: To evaluate the short-term clinical outcomes of image-based robot-assisted bicruciate retaining bicompartmental knee arthroplasty and compare it to robot-assisted total knee arthroplasty in the Indian population. Methods: Between December 2018 and November 2019, five patients (six knees) underwent robot-assisted bicompartmental knee arthroplasty (BCKA). These patients were demographically matched with five patients (six knees) who underwent robot-assisted total knee arthroplasty (TKA) during the same period. Clinical outcomes of these twelve knees were assessed in the form of knee society score (KSS) score, Oxford knee score (OKS), and forgotten joint score (FJS) after a minimum follow-up period of 25 months. The data between the two cohorts were compared and analyzed. Results: Scores obtained from both cohorts were subjected to statistical analysis. SPSS software was utilized and the Mann Whitney U-test was utilized to compare the two groups. There was no statistically significant difference found between the two groups in terms of functional outcome. Conclusion: Image-based robot-assisted BCKA is a bone stock preserving and more physiological procedure which can be a promising alternative to patients presenting with isolated arthritis of only two compartments of the knee. Although long-term, larger trials are warranted to establish it as an alternative, our pilot study shows an equally favorable outcome as TKA, making it an exciting new avenue in the field of arthroplasty
Personalized alignment in total knee arthroplasty: current concepts
No full textTraditionally in total knee arthroplasty (TKA), a post-operative neutral alignment was the gold standard. This principle has been contested as functional outcomes were found to be inconsistent. Analysis of limb alignment in the non-osteoarthritic population reveals variations from neutral alignment and consideration of a personalized or patient-specific alignment in TKA is challenging previous concepts. The aim of this review was to clarify the variations of current personalized alignments and to report their results. Current personalized approaches of alignment reported are: kinematic, inverse kinematic, restricted kinematic, and functional. The principle of “kinematic alignment” is knee resurfacing with restitution of pre-arthritic anatomy. The aim is to resurface the femur maintaining the native femoral joint line obliquity. The flexion and extension gaps are balanced with the tibial resection. The principle of the “inverse kinematic alignment” is to resurface the tibia with similar medial and lateral bone resections in order to keep the native tibial joint line obliquity. Gap balancing is performed by adjusting the femoral resections. To avoid reproducing extreme anatomical alignments there is “restricted kinematic alignment” which is a compromise between mechanical alignment and true kinematic alignment with a defined safe zone of alignment. Finally, there is the concept of “functional alignment” which is an evolution of kinematic alignment as enabling technology has progressed. This is obtained by manipulating alignment, bone resections, soft tissue releases, and/or implant positioning with a robotic-assisted system to optimize TKA function for a patient’s specific alignment, bone morphology, and soft tissue envelope. The aim of personalizing alignment is to restore native knee kinematics and improve functional outcomes after TKA. A long-term follow-up remains crucial to assess both outcomes and implant survivorship of these current concepts
Femoral head mosaicplasty by direct anterior approach for an osteochondral impaction without performing surgical hip dislocation
No full textSeveral surgical methods exist for the treatment of osteochondral lesions of the femoral head. They include osteochondral allograft transfer, femoral osteotomy, microfracture, autologous chondrocyte implantation, and hip arthroplasty. Mosaicplasty is a surgical method in which cylindrical plugs of bone and cartilage are transferred from a donor site to tunnels drilled into the bone and cartilage defects. This paper discusses the use of mosaicplasty by a direct anterior approach without dislocation in the treatment of an acute femoral head osteochondral impaction in a young patient