Publishing Network for Geoscientific and Environmental Data
Not a member yet
441201 research outputs found
Sort by
Color Reflectance (Spectrophotometer) of IODP Hole 386-M0092D
No full textColor reflectance spectrophotometry and colorimetry data from the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). The data where obtained during the onshore phase of expedition 386 which took place between 2022-02-14 – 2022-03-15 onboard D/V Chikyu. After longitudinal splitting of the core sections, each archive half was scanned by the Tri-Sensor Core Logger (TSCL; NS Design) including a noncontact imaging spectrophotometer (MetaVue VS3200; X-Rite), recording data at 2-cm sampling interval. The obtained data is represented in the L*a*b* color coordinate system, where L* is a total reflectance index ranging 0%–100%, a* is green (0) chromaticity, and b* is blue (0) chromaticity. L*a*b* values were transferred into RGB values using the MATLAB routine lab2rgb.
For further methodological information see methods chapter in Strasser, M. et al., 2023 https://doi.org/10.14379/iodp.proc.386.102.202
Color Reflectance (Spectrophotometer) of IODP Hole 386-M0094A
No full textColor reflectance spectrophotometry and colorimetry data from the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). The data where obtained during the onshore phase of expedition 386 which took place between 2022-02-14 – 2022-03-15 onboard D/V Chikyu. After longitudinal splitting of the core sections, each archive half was scanned by the Tri-Sensor Core Logger (TSCL; NS Design) including a noncontact imaging spectrophotometer (MetaVue VS3200; X-Rite), recording data at 2-cm sampling interval. The obtained data is represented in the L*a*b* color coordinate system, where L* is a total reflectance index ranging 0%–100%, a* is green (0) chromaticity, and b* is blue (0) chromaticity. L*a*b* values were transferred into RGB values using the MATLAB routine lab2rgb.
For further methodological information see methods chapter in Strasser, M. et al., 2023 https://doi.org/10.14379/iodp.proc.386.102.202
Master tracks in different resolutions of POLARSTERN cruise PS145/1, Bremerhaven - Las Palmas, 2024-11-24 - 2024-12-05
No full textRaw data acquired by position sensors on board RV Polarstern during expedition PS145/1 was processed to receive a validated master track which can be used as reference of further expedition data. During PS145/1 two Trimble Marine R750 GPS receivers and the iXBlue HYDRINS hydrographic survey inertial navigation system were used as navigation sensors. Data were downloaded from DAVIS SHIP data base (https://dship.awi.de) with a resolution of 1 sec. Processed data are provided as a master track with 1 sec resolution derived from the position sensors' data selected by priority and a generalized track with a reduced set of the most significant positions of the master track
Magnetic susceptibility of composite sediment core ROD11 from the crater basin of Rodderberg, Germany
No full textMagnetic susceptibility – a proxy parameter for core correlation and reconstruction of glacial/interglacial cycles for the Middle Pleistocene sediment record from the crater basin of Rodderberg, Germany. A 72.8 m long sediment record was recovered by means of wire-line drilling with 3 m long liners from the silted-up crater basin of Rodderberg (East Eifel Volcanic Field) in the vicinity of the city of Bonn, Germany. The two drill holes (ROD11-2 and ROD11-3) were merged to establish a composite record (ROD11) based on macroscopic sediment description and were fine-tuned by magnetic susceptibility data. Magnetic susceptibility was continuously logged with 1 cm spatial resolution with a Bartington loop-sensor (MS2C) on a GEOTEK multi-sensor core-logger. Furthermore, this parameter facilitates the differentiation between glacial and interglacial sediments, thereby supporting the palaeoclimatic interpretation based on geochemical data spanning the past 430 ka. The combined evidence suggests a depositional evolution from a deep crater lake via a shallow lake or desiccating wetland followed by deposition of loess and pedogenesis. This terrestrial record, evaluated through multiple dating techniques, offers a comprehensive environmental reconstruction since the Middle Pleistocene
Master track of POLARSTERN cruise PS145/2 in 1 sec resolution (zipped, 59 MB)
No full textRaw data acquired by position sensors on board RV Polarstern during expedition PS145/2 was processed to receive a validated master track which can be used as reference of further expedition data. During PS145/2 two Trimble Marine R750 GPS receivers and the iXBlue HYDRINS hydrographic survey inertial navigation system were used as navigation sensors. Data were downloaded from DAVIS SHIP data base (https://dship.awi.de) with a resolution of 1 sec. Processed data are provided as a master track with 1 sec resolution derived from the position sensors' data selected by priority and a generalized track with a reduced set of the most significant positions of the master track
P-wave velocity of discrete samples (DPW) from IODP Hole 386-M0083A
No full textP-wave velocity data from discrete samples from the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). During the onshore phase of expedition 386, which took place between 2022-02-14 – 2022-03-15 onboard D/V Chikyu, discrete samples for P-wave velocity measurements were taken from the work halves approx. every 2 meter down core using syringes with an inner diameter of 2 cm. Samples measured 2.5–3 cm long for a sample volume of ~10 cubic centimetres. Samples were then shipped to the European Petrophysics Consortium (EPC) laboratory at the University of Leicester (UK) for processing. Measurements were performed with a Geotek P-wave logger for discrete samples (PWL-D). Measurements were attempted for each sample, however, the unconsolidated lithology of some samples proved unsuitable for the instrument (e.g. too soupy or too friable to be placed between the transducers).
Operator notes: Data from section numbers > 30 can be associated to a decrease in velocity values, this is likely due to cracks opening in the samples when applying pressure on it at the time of measurement (as observed by operators). For holes M0081E & F Sections 1-29 velocity values are overestimated due to an issue with the calibration.
For further methodological information see methods chapter in Strasser, M. et al., 2023 https://doi.org/10.14379/iodp.proc.386.102.202
P-wave velocity of discrete samples (DPW) from IODP Hole 386-M0084D
No full textP-wave velocity data from discrete samples from the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). During the onshore phase of expedition 386, which took place between 2022-02-14 – 2022-03-15 onboard D/V Chikyu, discrete samples for P-wave velocity measurements were taken from the work halves approx. every 2 meter down core using syringes with an inner diameter of 2 cm. Samples measured 2.5–3 cm long for a sample volume of ~10 cubic centimetres. Samples were then shipped to the European Petrophysics Consortium (EPC) laboratory at the University of Leicester (UK) for processing. Measurements were performed with a Geotek P-wave logger for discrete samples (PWL-D). Measurements were attempted for each sample, however, the unconsolidated lithology of some samples proved unsuitable for the instrument (e.g. too soupy or too friable to be placed between the transducers).
Operator notes: Data from section numbers > 30 can be associated to a decrease in velocity values, this is likely due to cracks opening in the samples when applying pressure on it at the time of measurement (as observed by operators). For holes M0081E & F Sections 1-29 velocity values are overestimated due to an issue with the calibration.
For further methodological information see methods chapter in Strasser, M. et al., 2023 https://doi.org/10.14379/iodp.proc.386.102.202
P-wave velocity of discrete samples (DPW) from IODP Hole 386-M0084F
No full textP-wave velocity data from discrete samples from the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). During the onshore phase of expedition 386, which took place between 2022-02-14 – 2022-03-15 onboard D/V Chikyu, discrete samples for P-wave velocity measurements were taken from the work halves approx. every 2 meter down core using syringes with an inner diameter of 2 cm. Samples measured 2.5–3 cm long for a sample volume of ~10 cubic centimetres. Samples were then shipped to the European Petrophysics Consortium (EPC) laboratory at the University of Leicester (UK) for processing. Measurements were performed with a Geotek P-wave logger for discrete samples (PWL-D). Measurements were attempted for each sample, however, the unconsolidated lithology of some samples proved unsuitable for the instrument (e.g. too soupy or too friable to be placed between the transducers).
Operator notes: Data from section numbers > 30 can be associated to a decrease in velocity values, this is likely due to cracks opening in the samples when applying pressure on it at the time of measurement (as observed by operators). For holes M0081E & F Sections 1-29 velocity values are overestimated due to an issue with the calibration.
For further methodological information see methods chapter in Strasser, M. et al., 2023 https://doi.org/10.14379/iodp.proc.386.102.202
P-wave velocity of discrete samples (DPW) from IODP Hole 386-M0087B
No full textP-wave velocity data from discrete samples from the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). During the onshore phase of expedition 386, which took place between 2022-02-14 – 2022-03-15 onboard D/V Chikyu, discrete samples for P-wave velocity measurements were taken from the work halves approx. every 2 meter down core using syringes with an inner diameter of 2 cm. Samples measured 2.5–3 cm long for a sample volume of ~10 cubic centimetres. Samples were then shipped to the European Petrophysics Consortium (EPC) laboratory at the University of Leicester (UK) for processing. Measurements were performed with a Geotek P-wave logger for discrete samples (PWL-D). Measurements were attempted for each sample, however, the unconsolidated lithology of some samples proved unsuitable for the instrument (e.g. too soupy or too friable to be placed between the transducers).
Operator notes: Data from section numbers > 30 can be associated to a decrease in velocity values, this is likely due to cracks opening in the samples when applying pressure on it at the time of measurement (as observed by operators). For holes M0081E & F Sections 1-29 velocity values are overestimated due to an issue with the calibration.
For further methodological information see methods chapter in Strasser, M. et al., 2023 https://doi.org/10.14379/iodp.proc.386.102.202
P-wave velocity of discrete samples (DPW) from IODP Hole 386-M0087C
No full textP-wave velocity data from discrete samples from the above given hole of International Ocean Discovery Program (IODP) Expedition 386 (Japan Trench Paleoseismology). During the onshore phase of expedition 386, which took place between 2022-02-14 – 2022-03-15 onboard D/V Chikyu, discrete samples for P-wave velocity measurements were taken from the work halves approx. every 2 meter down core using syringes with an inner diameter of 2 cm. Samples measured 2.5–3 cm long for a sample volume of ~10 cubic centimetres. Samples were then shipped to the European Petrophysics Consortium (EPC) laboratory at the University of Leicester (UK) for processing. Measurements were performed with a Geotek P-wave logger for discrete samples (PWL-D). Measurements were attempted for each sample, however, the unconsolidated lithology of some samples proved unsuitable for the instrument (e.g. too soupy or too friable to be placed between the transducers).
Operator notes: Data from section numbers > 30 can be associated to a decrease in velocity values, this is likely due to cracks opening in the samples when applying pressure on it at the time of measurement (as observed by operators). For holes M0081E & F Sections 1-29 velocity values are overestimated due to an issue with the calibration.
For further methodological information see methods chapter in Strasser, M. et al., 2023 https://doi.org/10.14379/iodp.proc.386.102.202