1,914 research outputs found
The effects of shower head orientation and substrate position on the uniformity of GaN growth in a HVPE reactor
No full textInvestigation into laser re-melting of inconel 625 HVOF coating blended with WC
Full text linkHigh velocity oxy-fuel (HVOF) spraying of Diamalloy 1005 powders mixed with WC particles onto steel (304) is considered and laser re-melting of the resulting coatings is examined. Laser re-melting process is modeled to determine the melt layer thickness while temperature increase is formulated using the Fourier heating law. The morphological and metallurgical analyses prior and post laser re-melting process are carried out using scanning electron microscopy (SEM) and energy dispersive spectroscopy (EDS). X-ray diffraction (XRD) technique is used to determine the residual stress developed in the coating while the analytical formulation is adopted to predict the residual stress levels at the coating base material interface. The indentation tests are carried out to determine the Young’s modulus and fracture toughness of the coating prior to laser re-melting. Corrosion resistance of coating is measured using potentiodynamic polarization technique prior and post laser treatment process. The predictions of the melt layer thickness are in good agreement with experimental results. The presence of WC particles modifies temperature rise and its gradient in the coating while affecting the Young’s modulus, residual stress levels, and fracture toughness of the coating. The differences in the thermal properties of Inconel 625 powders and WC particles result in formation of small size cellular structure through polyphase solidification. WC dissolution in the central region of the large polycrystalline cells is observed due to the loss of carbon through carbonic gas formation. The results of corrosion tests prevail that significant improvement of corrosion resistance can be achieved after laser treatment process
Seroepidemiology of Toxocara canis infection among mountain aboriginal adults in Taiwan.
No full text
Obtaining Crack-free WC-Co Alloys by Selective Laser Melting
No full textAbstractStandard hardmetals of WC-Co system are brittle and often crack at selective laser melting (SLM). The objective of this study is to estimate the range of WC/Co ratio where cracking can be avoided. Micron-sized Co powder was mixed with WC nanopowder in a ball mill to obtain uniform distribution of WC over the surface of Co particles. Continuous layers of remelted material on the surface of a hardmetal plate were obtained from this composite powder by SLM at 1.07μm wavelength. The layers have satisfactory porosity and are well bound to the substrate. The chemical composition of the layers matches the composition of the initial powder mixtures. The powder mixture with 25wt.%WC can be used for SLM to obtain materials without cracks. The powder mixture with 50wt.%WC cracks because of formation of brittle W3Co3C phase. Cracking can considerably reduce the mechanical strength, so that the use of this composition is not advised
Abrasive wear behaviour of detonation sprayed WC-Co coatings on mild steel
No full textThe main objective of the present investigation is to evaluate the abrasive wear behaviour of detonation sprayed WC-Co coatings and to compare them with plasma sprayed WC-Co coatings and carburised and nitrided surfaces. Mild steel was coated with WC-12Co and WC-17Co using detonation and plasma guns. The abrasive wear rates of these coatings were determined at three different loads and compared with wear rates of as received, carburised, and nitrided mild steel. The abraded surfaces and the surfaces beneath the abraded surfaces were characterised by SEM. The results indicate that the detonation sprayed WC-12Co coating has the best abrasive wear resistance at all loads. Maximum improvement in wear resistance is obtained at an intermediate load (i.e. at 5 kg). The wear of detonation sprayed coatings is by abrasion of the soft Co matrix followed by the pullout of hard WC particles
- …
