57 research outputs found

    Statistical analysis of conflict involvements in port water navigation

    No full text
    With increasing rate of shipping traffic, the risk of collisions in busy and congested port waters is likely to rise. However, due to low collision frequencies in port waters, it is difficult to analyze such risk in a sound statistical manner. A convenient approach of investigating navigational collision risk is the application of the traffic conflict techniques, which have potential to overcome the difficulty of obtaining statistical soundness. This study aims at examining port water conflicts in order to understand the characteristics of collision risk with regard to vessels involved, conflict locations, traffic and kinematic conditions. A hierarchical binomial logit model, which considers the potential correlations between observation-units, i.e., vessels, involved in the same conflicts, is employed to evaluate the association of explanatory variables with conflict severity levels. Results show higher likelihood of serious conflicts for vessels of small gross tonnage or small overall length. The probability of serious conflict also increases at locations where vessels have more varied headings, such as traffic intersections and anchorages; becoming more critical at night time. Findings from this research should assist both navigators operating in port waters as well as port authorities overseeing navigational management

    “A legacy of troubles. Bengal Partition as long-lasting narration”

    No full text
    This essays analyses Indian Partition Literature, focusing on the Eastern border and the novel East/West by the Bengali author Gangopadhyay

    Learning from insurance data: Injuries to other road users in motorcyclist at-fault crashes

    No full text
    In multi-vehicle motorcycle crashes, the motorcycle rider is less likely to be at-fault but more commonly severely injured than the other road user. Therefore, not surprisingly, crashes in which motorcycle riders are at-fault and particularly the injuries to the other road users in these crashes have received little research attention. This paper aims to address this gap in the literature by investigating the factors influencing the severity of injury to other road users in motorcyclist-at-fault crashes. Five years of data from Queensland, Australia, were obtained from a database of claims against the compulsory third party (CTP) injury insurance of the at-fault motorcyclists. Analysis of the data using an ordered probit model shows higher injury severity for crashes involving young (under 25) and older (60+) at-fault motorcyclists. Among the not at-fault road users, the young, old, and males were found to be more severely injured than others. Injuries to vehicle occupants were less severe than those to pillions. Crashes that occurred between vehicles traveling in opposite directions resulted in more severe injuries than those involving vehicles traveling in the same direction. While most existing studies have analyzed police reported crash data, this study used CTP insurance data. Comparison of results indicates the potential of using CTP insurance data as an alternative to police reported crash data for gaining a better understanding of risk factors for motorcycle crashes and injury severity

    How similar are two-unit bicycle and motorcycle crashes?

    No full text
    This paper explores the similarities and differences between bicycle and motorcycle crashes with other motor vehicles. If similar treatments can be effective for both bicycle and motorcycle crashes, then greater benefits in terms crash costs saved may be possible for the same investment in treatments. To reduce the biases associated with under-reporting of these crashes to police, property damage and minor injury crashes were excluded. The most common crash type for both bicycles (31.1%) and motorcycles (24.5%) was intersection from adjacent approaches. Drivers of other vehicles were coded most at fault in the majority of two-unit bicycle (57.0%) and motorcycle crashes (62.7%). The crash types, patterns of fault and factors affecting fault were generally similar for bicycle and motorcycle crashes. This confirms the need to combat the factors contributing to failure of other drivers to yield right of way to two-wheelers, and suggest that some of these actions should prove beneficial to the safety of both motorized and non-motorized two-wheelers. In contrast, child bicyclists were more often at fault, particularly in crashes involving a vehicle leaving the driveway or footpath. The greater reporting of violations by riders and drivers in motorcycle crashes also deserves further investigation

    Modelling Collision Potentials in Port Anchorages: Application of the Navigational Traffic Conflict Technique (NTCT)

    No full text
    Despite the extent of works done on modelling port water collisions, not much research effort has been devoted to modelling collisions at port anchorages. This paper aims to fill this important gap in literature by applying the Navigation Traffic Conflict Technique (NTCT) for measuring the collision potentials in anchorages and for examining the factors contributing to collisions. Grounding on the principles of the NTCT, a collision potential measurement model and a collision potential prediction model were developed. These models were illustrated by using vessel movement data of the anchorages in Singapore port waters. Results showed that the measured collision potentials are in close agreement with those perceived by harbour pilots. Higher collision potentials were found in anchorages attached to shoreline and international fairways, but not at those attached to confined water. Higher operating speeds, larger numbers of isolated danger marks and day conditions were associated with reduction in the collision potentials

    A comparison of self-nominated and actual speeds in work zones

    No full text
    Despite significant research on drivers’ speeding behavior in work zones, little is known about how well drivers’ judgments of appropriate speeds match their actual speeds and what factors influence their judgments. This study aims to fill these two important gaps in the literature by comparing observed speeds in two work zones with drivers’ self-nominated speeds for the same work zones. In an online survey, drivers nominated speeds for the two work zones based on photographs in which the actual posted speed limits were not revealed. A simultaneous equation modelling approach was employed to examine the effects of driver characteristics on their self-nominated speeds. The results showed that survey participants nominated lower speeds (corresponding to higher compliance rates) than those which were observed. Higher speeds were nominated by males than females, young and middle aged drivers than older drivers, and drivers with truck driving experience than those who drive only cars. Larger differences between nominated and observed speeds were found among car drivers than truck drivers. These differences suggest that self-nominated speeds might not be valid indicators of the observed work zone speeds and therefore should not be used as an alternative to observed speed data

    Navigational safety in port waters: Techniques for modeling collision risk

    No full text
    Navigational collisions are one of the major safety concerns for many seaports. Continuing growth of shipping traffic in number and sizes is likely to result in increased number of traffic movements, which consequently could result higher risk of collisions in these restricted waters. This continually increasing safety concern warrants a comprehensive technique for modeling collision risk in port waters, particularly for modeling the probability of collision events and the associated consequences (i.e., injuries and fatalities). A number of techniques have been utilized for modeling the risk qualitatively, semi-quantitatively and quantitatively. These traditional techniques mostly rely on historical collision data, often in conjunction with expert judgments. However, these techniques are hampered by several shortcomings, such as randomness and rarity of collision occurrence leading to obtaining insufficient number of collision counts for a sound statistical analysis, insufficiency in explaining collision causation, and reactive approach to safety. A promising alternative approach that overcomes these shortcomings is the navigational traffic conflict technique (NTCT), which uses traffic conflicts as an alternative to the collisions for modeling the probability of collision events quantitatively. This article explores the existing techniques for modeling collision risk in port waters. In particular, it identifies the advantages and limitations of the traditional techniques and highlights the potentials of the NTCT in overcoming the limitations. In view of the principles of the NTCT, a structured method for managing collision risk is proposed. This risk management method allows safety analysts to diagnose safety deficiencies in a proactive manner, which consequently has great potential for managing collision risk in a fast, reliable and efficient manner

    Worker views on safety at roadworks

    No full text
    Roadworks in live traffic environments are hazardous to workers and road users alike. In an increasing body of international research literature, roadwork risks and hazards have been comprehensively examined. As in the broader field of road safety research, much of the work rightly takes a quantitative approach to assessing risk and related issues and to addressing the identified risks appropriately. In Australia, however, limited official data constrains the ability of researchers to achieve an in-depth understanding of the situation at state/territory and national levels based on traditional quantitative analyses. One way to enhance and supplement the limited available data is to consult those who are directly involved in roadworks for qualitative information, although such an approach is rarely reported in the roadwork safety arena. As part of the major study focusing on safety at roadworks in Queensland, 66 workers were interviewed about their perceptions and experiences regarding roadwork safety. This paper thus outlines a qualitative examination of workers' perceptions of the causes of roadwork incidents and the effectiveness of hazard mitigation measures. Consistent with findings reported in the literature is the view among workers that speeding is a major hazard and that police enforcement is the most effective countermeasure. Other hazards commonly observed by workers but less frequently reported elsewhere include driver distraction and aggression toward workers, working in poor weather and working at night. Workers mostly suggested educational measures to address distraction and aggression issues, though such measures are only tentatively supported in the literature
    corecore