9,819 research outputs found
The first international consensus conference on continuous renal replacement therapy
No full textThe first international consensus conference on continuous renal replacement therapy.BackgroundManagement of acute renal failure (ARF) in the critically ill is extremely variable and there are no published standards for the provision of renal replacement therapy in this population. We sought to review the available evidence, make evidence-based practice recommendations, and delineate key questions for future study.MethodsWe undertook an evidence-based review of the literature on continuous renal replacement therapy (CRRT) using MEDLINE searches. We determined a list of key questions and convened a 2-day consensus conference to develop summary statements via a series of alternating breakout and plenary sessions. In these sessions, we identified supporting evidence and generated practice guidelines and/or directions for future research.ResultsOf the 46 questions considered, we found consensus for 20. We found inadequate evidence for 21 questions and for the remaining five we found data but no consensus. Full versions of workgroup findings are available on the Internet at http://www.ADQI.net.ConclusionsDespite limited data, broad areas of consensus exist for use of CRRT and guideline development appears feasible. Equally broad areas of disagreement also exist and additional basic and applied research in acute renal failure is needed
Common Mode Currents in DC Power Routers
No full textThe grid reinforcement and energy redirection needs have led to the emergence of Back-To-Back Voltage Source Converter (BTB-VSC) based dc power routers. This paper investigates the low frequency Common Mode Currents (CMCs) that arise in the system if the employed BTB-VSCs have an un-isolated ac path connected in parallel to their output ports. Simulation results are presented to show a sensitivity analysis of lower order harmonics in CMC with respect to the operating active and reactive power of the dc router, dc link voltage, link resistance, modulation method and pole capacitance. Experimental results are shared to show existance of lower order CMC in 3-wire ac link operating in parallel with the dc power router and these are mitigated using zero sequence controller
Modeling, Control, and Operation of an M-DAB DC-DC Converter for Interconnection of HVDC Grids
No full textFuture high-voltage direct-current (HVDC) networks based on voltage source converters (VSCs) will have different structures (asymmetric monopolar, bipolar, or symmetric monopolar), voltage levels, control, and protection schemes. Therefore, dc-dc converters are needed to interconnect those VSC-HVDC grids and several technical issues on their control and operational systems must be adequately addressed. A dc-dc converter based on a modular-dual active bridge (M-DAB) converter is suggested to reach a desirable interconnection of the HVDC grids and regulate power flow (PF) between them. A dynamic averaged model is proposed for the M-DAB converter and its stability is analyzed using the Lyapunov function. Moreover, a new local controller based on nonlinear control theory is proposed for the M-DAB. The new M-DAB local controller is integrated with the energy management system (EMS), by updating the PF equations, to create a complete control structure. Considering the CIGRE DCS3 HVDC test system and the studied M-DAB, static, dynamic simulation, and experimental studies are conducted and the dc-dc converter and the performance of the designed controllers and the EMS are examined and validated.Green Open Access added to TU Delft Institutional Repository 'You share, we take care!' - Taverne project https://www.openaccess.nl/en/you-share-we-take-care Otherwise as indicated in the copyright section: the publisher is the copyright holder of this work and the author uses the Dutch legislation to make this work public.Intelligent Electrical Power Grid
Understanding PPPs and PPP-based national accounts
No full textPPP-based national accounts have become an important part of the database for macroeconomists, development economists, and economic historians. Frequently used global data come from the Penn World Table (PWT) and the World Bank’s World Development Indicators; a substantial fraction of the world is also covered in the PPP accounts produced by the OECD and the European Union. This paper provides an overview of how these data are constructed, and discusses both the theory and the practical problems of implementing it. All of these data are underpinned by the International Comparison Program (ICP), which collects data on prices worldwide. The most recent round of the ICP was for 2005 with final results published in early 2008; version 7.0 of the Penn World Table will soon incorporate these results. The 2005 ICP, like earlier rounds, involved substantial revisions to previous data, most notably revising downwards the size of the Chinese (40 percent smaller) and Indian (36 percent) economies. We discuss the reasons for the revisions, and assess their plausibility. We focus on four important areas: how to handle international differences in quality, the treatment of urban and rural areas of large countries such as China, India, and Brazil, how to estimate prices for government services, health, and education, and the effects of the regional structure of the ICP. All of these affect the interpretation of previous data, as well as the current revisions. We discuss previous revisions of the PWT, and their effects on various kinds of econometric analysis. The paper concludes with health warnings that should be kept in mind when using these data, which are not always suitable for the purposes to which they are put. Some international comparisons are close to impossible, even in theory, and in others, the practical difficulties make comparison exceedingly hazardous.
Restructuring the existing medium voltage distribution grids using DC systems
No full textGreen Open Access added to TU Delft Institutional Repository ‘You share, we take care!’ – Taverne project https://www.openaccess.nl/en/you-share-we-take-care Otherwise as indicated in the copyright section: the publisher is the copyright holder of this work and the author uses the Dutch legislation to make this work public.DC systems, Energy conversion & Storag
Cold cracking in DC-cast high strength aluminum alloy ingots: An intrinsic problem intensified by casting process parameters
No full textFor almost half a century the catastrophic failure of direct chill (DC) cast high strength aluminum alloys has been challenging the production of sound ingots. To overcome this problem, a criterion is required that can assist the researchers in predicting the critical conditions which facilitate the catastrophic failure of the ingots. This could be achieved at first glance by application of computer simulations to assess the level and distribution of residual thermal stresses. However, the simulation results are only able to show the critical locations and conditions where and when high stresses may appear in the ingots. The prediction of critical void/crack size requires simultaneous application of fracture mechanics. In this paper, we present the thermo-mechanical simulation results that indicate the critical crack size distribution in several DC-cast billets cast at various casting conditions. The simulation results were validated upon experimental DC-casting trials and revealed that the existence of voids/cracks with a considerable size is required for cold cracking to occur.Materials Science & EngineeringMechanical, Maritime and Materials Engineerin
A Dynamically Reconfigurable Recursive Switched-Capacitor DC-DC Converter with Adaptive Load Ability Enhancement
No full textMultiple voltage conversion ratio (VCR) recursive switched-capacitor (SC) dc-dc converters, based on several basic 2:1 converters, are widely used for on-chip power supplies due to their flexible VCRs for higher energy efficiency. However, conventional multiple VCR SC converters usually have one or more 2:1 converters unused for some VCRs, which results in lower power density and chip area wastage. This article presents a new recursive dc-dc converter system, which can dynamically reconfigure the connection of all on-chip 2:1 converter cells so that the unused converters in the conventional designs can be reused in this new architecture for increasing the load-driving capacity, power density, and power efficiency. To validate the design, a 4-bit-input 15-ratio system was designed and fabricated in a 180-nm BCD process, which can support a maximum load current of \text{0.71}\,\text{mA} and achieves a peak power efficiency of 93.1% with 105.3\,\mu \text{A/mm} {2} chip power density from a 2-V input power supply. The measurement results show that the load-driving capacity can become 6.826×, 2.236×, and 2.175× larger than the conventional topology when the VCR is 1/2, 1/4, and 3/4, respectively. In addition, the power efficiency under these specific VCRs can also be improved considerably.Green Open Access added to TU Delft Institutional Repository ‘You share, we take care!’ – Taverne project https://www.openaccess.nl/en/you-share-we-take-care Otherwise as indicated in the copyright section: the publisher is the copyright holder of this work and the author uses the Dutch legislation to make this work public.Electronic Instrumentatio
A Microeconometric Approach to Development Policy
No full textTwo decades after its original publication, The Analysis of Household Surveys is reissued with a new preface by its author, Sir Angus Deaton, recipient of the 2015 Nobel Prize in Economic Sciences. This classic work remains relevant to anyone with a serious interest in using household survey data to shed light on policy issues.
This book reviews the analysis of household survey data, including the construction of household surveys, the econometric tools useful for such analysis, and a range of problems in development policy for which this survey analysis can be applied. The author's approach remains close to the data, using transparent econometric and graphical techniques to present data in a way that can clearly inform policy and academic debates.
Chapter 1 describes the features of survey design that need to be understood in order to undertake appropriate analysis. Chapter 2 discusses the general econometric and statistical issues that arise when using survey data for estimation and inference. Chapter 3 covers the use of survey data to measure welfare, poverty, and distribution. Chapter 4 focuses on the use of household budget data to explore patterns of household demand. Chapter 5 discusses price reform, its effects on equity and efficiency, and how to measure them. Chapter 6 addresses the role of household consumption and saving in economic development. The book includes an appendix providing code and programs using STATA, which can serve as a template for the users' own analysis
From DC nano- and microgrids towards the universal DC distribution system - a plea to think further into the future
No full textThe traditional ac power system is challenged by the increased amount of distributed energy resources. Enormous changes and investments are necessary in order to achieve an ac smart grid capable of coping with the challenges introduced. In dc, solutions seem to be more straightforward since most of the distributed energy sources and most of the loads connected to the low voltage grid operate with dc. For this reason, dc distribution systems should be considered as an alternative with significant potential. Nevertheless, nowadays research is mainly focused on local dc nano- and microgrids. This paper introduces relevant aspects related to dc distribution networks. A wide field of opportunities and challenges are briefly exposed.Accepted Author ManuscriptOld - EWI-ESE-DC&S DC systems & StorageElectrical Power Processin
Power Disequilibrium Suppression in Bipolar DC Distribution Grids By Using A Series-Parallel Power Flow Controller
No full textThe unbalanced power between positive and negative poles in a bipolar DC distribution network (DC-DN) generates an unbalanced current at the neutral line, which enlarges the power losses of the system and the voltage deviation of DC loads. An unbalanced power suppression strategy based on a series-parallel power flow controller (SP-PFC) is proposed in this paper. The SP-PFC is adopted as the interconnection between two different DC-DNs. The topology and operating modes of SP-PFC are analyzed. Subsequently, SP-PFC output voltage and line current expressions under constant power control are derived. The nonlinear relationship between the output voltage and line current is linearized at the operating point. On this basis, the influences of unbalanced load and receiving-end voltage on the SP-PFC are investigated. A small-signal model of bipolar DC-DN containing an SP-PFC is established, and the system stability is analyzed. A simulation model of the bipolar DC distribution network containing an SP-PFC is built up in MATLAB/Simulink, and the effectiveness of the SP-PFC in the suppression of unbalanced power is verified.Green Open Access added to TU Delft Institutional Repository 'You share, we take care!' - Taverne project https://www.openaccess.nl/en/you-share-we-take-care Otherwise as indicated in the copyright section: the publisher is the copyright holder of this work and the author uses the Dutch legislation to make this work public.DC systems, Energy conversion & Storag
- …
